2001 Peugeot 206 1.6 - Answered Questions & Fixed issues


I would say it's a bad ABS sensor. That's where I'd start looking.

2001 Peugeot 206... | Answered on Feb 04, 2018 | 61 views


try this:

2001 Peugeot 206... | Answered on Sep 19, 2015 | 1,134 views


You use:
- "1" key to enter first digit of code (i.e. if first code digit is 5 you have to push "1" until it shows 5 on your display)
- "2" key to enter second digit of code
- "3" key to enter third digit of code
- "4" key to enter fourth digit of code
- "6" key to confirm code

2001 Peugeot 206... | Answered on Aug 20, 2015 | 171 views


Limp Mode is usually a transmission failure
that will have to be diagnosed-check for codes
& google what they are

There are overheating & possibly other limp
modes on some vehicles

Can't use it at all like that & not cause a problem

Need a repair shop or dealer

2001 Peugeot 206... | Answered on Nov 03, 2014 | 546 views


It's for brake fault pads, sensors low fluid

2001 Peugeot 206... | Answered on Sep 16, 2014 | 445 views


Low compression?

2001 Peugeot 206... | Answered on Aug 05, 2014 | 169 views


The ABS light normally illuminates to indicate that the ABS module is out of parameter, which may indicate a POTENTIALLY DANGEROUS CONDITION. Usually, replacing the ABS module will cure the condition, and the ABS warning light will turn off.

2001 Peugeot 206... | Answered on Jul 19, 2014 | 598 views


check the engine mounts and reaction rod bushes. check suspension rubbers

2001 Peugeot 206... | Answered on Jul 10, 2014 | 95 views


disconnect all (2) power wires.and connect again see it out.

2001 Peugeot 206... | Answered on Jun 20, 2014 | 171 views


Reach from under the car after exhaust pipe is removed from manifold.

2001 Peugeot 206... | Answered on Jun 13, 2014 | 96 views


I can say we would not have any code info here at fixya. Sorry.

2001 Peugeot 206... | Answered on Jun 10, 2014 | 25 views


There could be the starts of a timing issue. or The exhaust valves aren't closing all the way, and over night, all the carbon seizes the valves just a little. When it's finally up and running, the heat loosens the carbon deposits and functions normally.

2001 Peugeot 206... | Answered on May 11, 2014 | 63 views


Your CV joint(s) are about to shear off. They are relatively easy to replace while still intact.

2001 Peugeot 206... | Answered on Apr 26, 2014 | 70 views


there must be a fault with youre brake light switch in passenger side footwell

2001 Peugeot 206... | Answered on Nov 22, 2013 | 218 views


above the panel under the dash on a support bracket above the brake pedal ,twist and turn to remove

2001 Peugeot 206... | Answered on Dec 01, 2013 | 1,080 views


if i remember correctly it is behind the glovebox . if you open the glove box there should be 2 stoppers one either side squeeze them inwards and the glove box should swing all the way out and allow access

2001 Peugeot 206... | Answered on Jun 28, 2013 | 107 views


a lot of door check straps only use a rolled spring pin. If this is broken and you can remove the door trim it will be fixable mostly.

2001 Peugeot 206... | Answered on Jan 13, 2013 | 3,209 views


replacing the cooler is much less expensive then head gaskets

2001 Peugeot 206... | Answered on Jun 06, 2012 | 559 views

Not finding what you are looking for?
2001 Peugeot 206 1.6 Logo

107 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Marvin
Marvin

Level 3 Expert

85161 Answers

scj103

Level 2 Expert

89 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...