1999 Peugeot 206 - Page 3 - Answered Questions & Fixed issues


inside power distribution box under the hood!

Peugeot 206 Cars... | Answered on Mar 18, 2019 | 42 views


You can try out some guide from here reliable-store
they also provide live chat feature for instant help and it's very useful

Peugeot 206 Cars... | Answered on Mar 12, 2019 | 31 views


There's a website that has all this information about all this and manuals everything totally free there are many actually but I personally like few reliable-store .. let me know if u need help
thanks

Peugeot 206 Cars... | Answered on Feb 27, 2019 | 33 views


If you are positive that the bulb and connector are OK...then there could be several root causes:
Bad wiring:
There could be a short somewhere between the connector and fuse/relay or ground.
But you need to figure out first ... is it BOTH the high and low beams that are out on that side of the car?
I think your bulb has 3 spades for a combination high/low beam bulb. Knowing which line is dead helps on figuring out which wire(s) is the issue. If both high and low do not work ... then it is the ground wire.
If you have a voltmeter you can test out the wiring.
Bad Light Control Module (if your car has this; I could not confirm)
I am not sure if the Peugeot has a light control module but on some Saabs there is one and it caused your same symptom. Read link to learn more
http://saabworld.net/showthread.php?t=29583

Peugeot 206 Cars... | Answered on Jan 23, 2019 | 60 views


Not familiar with that particular model, but on most you must first remove the seat back and seat cover to access the airbag.

Peugeot 206 Cars... | Answered on Jun 07, 2018 | 42 views


Did you get the car plugged into a diagnostic reader after the battery change?
Some newer car ECU's need to be reset to 'new battery' settings. Over time the system alters the battery charge rate as the battery gets older and weaker so a new battery will overcharge if not reset..
The error code, (P0563), reads as "system voltage high".
Get the car plugged into a good diagnostic system and that will allow you to correct the error code and battery settings.
The other symptoms may settle down once the error code is sorted out.

Peugeot 206 Cars... | Answered on Apr 14, 2018 | 81 views


At this website www.reliable-store.com I found all complete guide, much better language, complete detail in
800+ pages, and they also have live assistance feature

Peugeot 206 Cars... | Answered on Mar 09, 2018 | 59 views


Chrysler/Dodge/Jeep:
External Fuel Quantity Access
Citroen/Peugeot:
Fuel Pump Control Out Of Range
Ford:
Fuel Pump Control Out Of Range
Jaguar:
Fuel Pump Control out Of Range (Fuel Pump Driver Module/VLCM)
Kia:
VSV 1/2/3 Circuit Range / Performance
Lincoln:
Fuel Pump Control Out of Range
Mazda:
Fuel Pump Control Circuit
Mercedes:
Fuel pump control out range
Mercury:
Fuel Pump Control Out of Range
Oldsmobile:
Fuel Pump Control Out of Range
Toyota:
High Pressure Fuel Pump Circuit Malfunction or Fuel Pump Control Out Of Range

Peugeot 206 Cars... | Answered on Feb 09, 2018 | 61 views


If oil is not circulating around engine then there could be a blockage resulting in increase of oil pressure. But if your car is under warranty then why dont you take it back and mention your concern in case if something goes wrong.

Peugeot 206 Cars... | Answered on Jan 08, 2018 | 62 views


I think its F5 on fuse box of 30 Amp.

Peugeot 206 Cars... | Answered on Jan 08, 2018 | 57 views


Low battery....you can damage your ecu if you continue to use it. Open the bonnet and charge the battery with a external charger and after charging battery check the alternator whether its charging the battery.

Peugeot 206 Cars... | Answered on Jan 08, 2018 | 96 views


Hook the vehicle to pp2000 to find out the exact obd code and to diagnose.

Peugeot 206 Cars... | Answered on Jan 08, 2018 | 468 views


Your best bet is to google it. I found plenty of diagrams

preview-peugeot-206-wiring-diagram-4.jpg

Peugeot 206 Cars... | Answered on Jan 08, 2018 | 76 views


Check the fuse box for F9 blown fuse.peugeot-106-1.1-2003-5.jpg

Peugeot 206 Cars... | Answered on Jan 08, 2018 | 132 views


Have you tried to disconnect battery terminal and wait for 5 minutes before connecting again to check the remote locking?

Peugeot 206 Cars... | Answered on Jan 08, 2018 | 190 views


Please Check High pressure fuel pump. In my opinion your fuel pump connected to timing belt is giving away. When you increase rev on engine, the pressure increases as well. As a result, Injector spray pattern gets steady. But on revs below 900rpm it struggle to maintains required pressure. If everything in fuel injection system is working fine then the Worst case scenario is that the head pressure is leaking aka compression leakage.

Peugeot 206 Cars... | Answered on Jan 08, 2018 | 64 views


The most likely causes will be...
A worn ball joint on the front suspension.
A broken front spring.
A worn driveshaft.
Most mechanics will have a look for you at no cost.
But you can test as follows.
(Driveshaft=) in an EMPTY car park or similar area turn your steering as far as you can to the left. Drive in a circle at about 20mph and listen. If faulty you will hear a regular "clonk, clonk, clonk" noise. Repeat this with your steering hard over to the right as well. It might be louder in one direction than the other.
(Ball joint=) DO NOT DO THIS ON JUST THE JACK!! PUT IT ON AXLE STANDS!!
Make sure the steering lock is ON.
Jack the car up and PUT IT ON AXLE STANDS for stability. Using a bit of effort grab the top and bottom of the wheel and try to rock it. Grab the wheel at left and right and repeat. Other than some steering movement it should be solid. There will be movement if the joint is worn, there may even be a click or clonk noise.
(Spring=) As for the ball joint test PUT IT ON AXLE STANDS!!
With the car off the ground take off the front wheel. Using a torch get a good look at the spring from the top all the way down to the bottom. There should be no breaks, shiny or missing pieces. Gently, but firmly, try and move the spring. It should be straight and not move. Do this both sides.

Peugeot 206 Cars... | Answered on Jan 05, 2018 | 70 views


have the fault codes read

Peugeot 206 Cars... | Answered on Dec 18, 2017 | 55 views

Not finding what you are looking for?
1999 Peugeot 206 Logo

113 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

scj103

Level 2 Expert

99 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...