20 Most Recent 2003 Mitsubishi Lancer - Page 8 Questions & Answers


If i'm not mistaken the light beside the battery sign is the check engine light. this lights up if anything under the hood is not functioning the way it should. Unfortunately i cannot be more specific on this. It just means that you could be staring at a major repair, or your gas cap could be too loose (no kidding).

Well as you've mention your oil is dropping at a very fast rate then its a good place to start checking. You can check if your oil seals are ok and might as well check all the filters...oil filters, fule filters air filters.

Hope i have answered your question. Goodluck!

2003 Mitsubishi... | Answered on Jun 16, 2013


you can service the EGR valves using carb spray....but first you will need to have compression test to all of the cylinder....if compression all okay...check spark plugs to see if engine oil sticking on the plugs...that means your valve stem seals is worn out need replace...

2003 Mitsubishi... | Answered on May 14, 2013


hi do u hear aclicking nise when turn ingnition on if so try the fuel pump or relay, or short in ecu

2003 Mitsubishi... | Answered on May 14, 2013


ck compression probley bent valves

2003 Mitsubishi... | Answered on May 14, 2013


Cause it IS hot after driving it :) as long as its not running hot on ur temp inside ur car ur fine

2003 Mitsubishi... | Answered on May 03, 2013


Sorry you have to replace the control panel. the bezel just pops off, then you can access the screws to remove it.
Randy

2003 Mitsubishi... | Answered on Apr 28, 2013


Take a look at the air delivery system,also look for a detached vacume hose.
could be that something got loose while you were changing the battery.
look near the battery area for any loose hoses or for that matter any loose wires or
plugs
Good luck,Gary.

2003 Mitsubishi... | Answered on Apr 21, 2013


exact same problem happened with my lancer i took it to an auto instrument shop and it cost me $330 to fix and hasnt stopped working since.

2003 Mitsubishi... | Answered on Apr 20, 2013


po421 catalytic converter code [warm up catalyst efficiency below threshold bank 1] means the o2 sensor is detecting low oxygen in exhaust problem can be cat conv going bad---o2 sensor faulty-and or bad spark plug ....as to the p0441 evap system[-evap emissions control system incorrect purge flow ] this is a system code meaning any part of the evap can have problem will need to check the fuel lines vapor lines for damage or breaks-check purge valve -purge valve solenoid- canister- and vacuum lines

2003 Mitsubishi... | Answered on Apr 10, 2013


Could be a worn out ignition switch & the
starter solenoid could be bad

Don't personally care how or what was tested,
based on what I see on this site, not much is done
correctly, when you pay someone

2003 Mitsubishi... | Answered on Apr 03, 2013


may be you should make a diagnostic and you can do it in a garage or you can do it by yourself if you want to do it by yourself you need some tools and you can find some good ones here: chinasinoy.com

2003 Mitsubishi... | Answered on Mar 13, 2013

Not finding what you are looking for?

945 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Lancer Mitsubishi

  • Lancer Mitsubishi

Most Popular Question

slave cylinder located motor

  • Cars & Trucks
Loading...