2006 GMC Envoy - Answered Questions & Fixed issues


was it jerking before change out --check installation of unit

2006 GMC Envoy | Answered on Jul 06, 2019 | 22 views


The fuel filter on your vehicle is located inside the fuel tank and is part of the fuel pump module. It is, in theory, a lifetime filter and can only be changed by replacing the entire pump module assembly.

2006 GMC Envoy | Answered on Mar 18, 2019 | 2,112 views


I dont believe its used in your situation .

here is a rundown

Car Radio Battery Constant 12v+ Wire: Orange
Car Radio Accessory Switched 12v+ Wire: The radio harness does not provide a switched power source. Run a wire to the fusebox or ignition switch harness for switched power.
Car Radio Ground Wire: Black/White
Car Radio Illumination Wire: Brown
Car Stereo Dimmer Wire: Gray
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue

2006 GMC Envoy | Answered on Dec 19, 2018 | 7,055 views


Dave, good news for you. There is a recall for the master switch on the drivers door. The recall involves water being able to get into the switch. I wouldn't say anything, just call and ask about the the recall. This "module" is the switch itself. Pop the plastic trim upwards, the switch comes right up.

2006 GMC Envoy | Answered on Feb 26, 2018 | 53 views


Hello, Janice -

I can only think you do not have the owner's manual for your vehicle. The information about turning the curb view assist mirror on and off can be found in the manual.

This is the link to the PDF format user's manual for the 2006 GMC Envoy:
https://my.gmc.com/content/dam/gmownercenter/gmna/dynamic/manuals/2006/gmc/envoy/2006_gmc_envoy_owners.pdf

You will need Adobe Acrobat Reader software (free) to download/save the manual. If you download and save the manual to your Documents folder, be sure to save it using a file name you can find again easily, something like: GMC Envoy 2006 Manual.

The instructions to turn the Curb View off is on page 3-64 (Image 208) of the manual.

Best wishes.

2006 GMC Envoy | Answered on Feb 25, 2018 | 52 views


Mirror Tilt in Reverse Controls
This feature is capable of tilting the passenger side power mirror when the transmission is placed in reverse to provide enhanced visibility during parking or backing maneuvers. This feature is turned OFF or ON through the DIC. The passenger mirror on domestic vehicles can not be changed from the factory setting, but on export vehicles, the passenger mirror position may by changed using the same procedure as the driver mirror. For further information, refer to Driver Personalization in Personalization.

Tilt Mirror In Reverse
Continue with the following steps in order to personalize the tilt mirror in reverse.
Press the Select button in order to enter the menu. The first choice seen is the current setting.
Press the Select button in order to scroll through the following options:
• CURB VIEW: OFF (Default)
• CURB VIEW: PASSENGER
Press the Personalization button in order to advance to the next option.

2006 GMC Envoy | Answered on Feb 25, 2018 | 90 views


It's part of the mass air flow sensor ,

2006 GMC Envoy | Answered on Feb 19, 2018 | 226 views


Here is for the 4.2l ENGINE

2006 GMC Envoy | Answered on Dec 22, 2017 | 55 views


A rod problem is a steady knock which increases with rpm. More likely you have a plugged air filter , a plugged fuel filter or a vacuum leak, ( vote fuel filter , people never change those often enough)

2006 GMC Envoy | Answered on Nov 17, 2017 | 71 views


the release at the bottom of hatch can be ---rusted normal in northeast --- linkage popped or broken --linkage clip popped or broken --- need to crawl into back and remove the plug [ lower center of rear hatch panel will need a long screw driver and light will see linkage and latch push down on linkage arm and push open hatch when opened you can remove the rear panel and assess the problem but lube the latch and upper window latch

2006 GMC Envoy | Answered on Nov 06, 2017 | 232 views


With as many sensors as that thing has, go to Autozone and ask for a free diagnostic tool check.

2006 GMC Envoy | Answered on Oct 30, 2017 | 101 views


It is nothing to do with the canister or associated pipework.

There would be no problem if the filler pipe entered the tank at the highest point but mostly they don't. Realistically the problem is like filling an old-fashioned teapot through the spout if the lid was sealed down tight and there was no vent - once the level has risen to a point equivalent to the top of where the spout enters the teapot a pressure begins to build under the top that resists further filling.

To overcome this problem in the fuel tank and to allow complete filling, the high points have a vent and each vent is joined together by a hose that is terminated at a vent in the filler pipe at a height above the tank top.

When fuel blowback happens during filling the cause is mostly one or more of those vents or hoses is blocked or squashed or otherwise damaged...

2006 GMC Envoy | Answered on Oct 07, 2017 | 67 views


Check the belt tensioner and the idle pulley... (looks just like the pulley on the tensioner, but bolts straight in.).. - from experience...my single pulley was bad... after replacing the tensioner TWICE... (duhh!!)

2006 GMC Envoy | Answered on Aug 10, 2017 | 86 views


there will be codes but the scanner they used was not the right protocol to read them
take it to an accredited professional auto transmission specialist shop and get it properly diagnosed
it will not need a new transmission as it is servo/ solenoid --tcm or TR unit problem

2006 GMC Envoy | Answered on Aug 03, 2017 | 114 views


Disconnecting your battery on our platform has a habit of blowing actuators. Takes quite a bit of time to replace them, not hard, just takes forever to get to them in the dash.

2006 GMC Envoy | Answered on Apr 11, 2017 | 83 views


A few things....there are 2 fuse boxes to check, one in engine compartment, and one under back seat drivers side. 2nd, check and see if your socket is getting power. 3rd, there is a recall for the rear brake lights, so if all else fails, call the dealer with your VIN #.

2006 GMC Envoy | Answered on Mar 31, 2017 | 242 views


Question isn't clear. If you want to BUY pigtails, rockauto is the best place to buy them.

2006 GMC Envoy | Answered on Mar 31, 2017 | 21 views


Have you checked under the hood to see if the cap is on the overflow/expansion tank ?

2006 GMC Envoy | Answered on Feb 23, 2017 | 81 views


2006 GMC Envoy | Answered on Jan 23, 2017 | 137 views

Not finding what you are looking for?

932 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2004 GMC Envoy
2004 GMC Envoy

2,174 Questions

2002 GMC Envoy
2002 GMC Envoy

1,364 Questions

2003 GMC Envoy
2003 GMC Envoy

1,327 Questions

2005 GMC Envoy
2005 GMC Envoy

521 Questions

Top GMC Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...