2002 Mitsubishi Lancer - Answered Questions & Fixed issues


The first step is to check the bulbs in the tail lights. The brake light switch (on the brake pedal) is OK, as the center light works.

2002 Mitsubishi... | Answered on May 02, 2019 | 101 views


hummm strange
does the master switch have a other door lock button

so central locking and windows dont work as they should

driver side window motor faulty

individual door lock actuator motors not getting power


it is possible the central locking module wont work unless reset to the other cars electronics with the correct scanner

2002 Mitsubishi... | Answered on Feb 07, 2019 | 105 views


The first step is to see what error code(s) are present. I suspect that a sensor or two may have been left unplugged or the harness is damaged during the trans swap. Check for bent pins in the connectors.

2002 Mitsubishi... | Answered on Jan 15, 2019 | 129 views


either check the circuitry , will need workshop grade equipment and expertise , which is the preferred option , or just change the sensor and hope it's that and not in the circuit , no real short cuts with these electronic problems

2002 Mitsubishi... | Answered on Dec 31, 2018 | 338 views


Here are instructions on how to remove a glove box on a Honda Accord: 1. Remove these items: Dashboard center lower cover and Passenger's dashboard lower cover. 2. Remove the screws from bottom of the glove box. 3. Wrap a flat-tip screwdriver with protective tape, and apply protective tape around the related parts, to prevent damage. Insert a flat-tip screwdriver in the notch of the cap, and release the hooks by prying up the cap. 4. Remove the screws. 5. Release the hooks, then pull down on
-------------------------------------------------------------------------------------------

Car Diagnostic Tools

2002 Mitsubishi... | Answered on Jul 09, 2018 | 169 views


I tried the DIY
service and repair manuals from a website and it actually helped me repair transmission problem in my jcb 3cx site-master. it wont move forward or reverse, engine is good both solenoids for forward and reverse work.
I don't have much technical knowledge but I just followed it step-wise, and works perfect! got it from www.reliable-store.com

2002 Mitsubishi... | Answered on Mar 23, 2018 | 43 views


Sell the vehicle and purchase another.
Or determine that the cost of transmission replacement and having an operable vehicle is worth more to you, than the value of the car.

2002 Mitsubishi... | Answered on Jan 28, 2018 | 48 views


Anytime you are getting oil inside of the combustion chamber you are looking at an internal issue. Either valve stem seals, piston rings, or head gasket would be the most viable suspects.

2002 Mitsubishi... | Answered on Jan 05, 2018 | 154 views


There may be and indication if the battery is not being charged by the alternator, normally the ignition light will say on. Sounds like a bad diode pack in the alternator. Take it to and auto electrical shop to get that checked

2002 Mitsubishi... | Answered on Jan 03, 2018 | 28 views


Some you tube videos might help

2002 Mitsubishi... | Answered on Nov 02, 2017 | 326 views


run the fault codes
solenoids and servos do not operate unless they get a signal from the transmission ratio sensor , the Transmission control module or the VSS it will be revealed by a problem code

2002 Mitsubishi... | Answered on Oct 21, 2017 | 112 views


15w-30 engine oil and ATF transmission oil probably an atf -4 oil
ring any automatic transmission shop for the oil specs
make sure that it is a genuine automatic transmission and not a cv transmission ( constant velocity )transmission as using ATF oil will destroy the belt and the transmission

2002 Mitsubishi... | Answered on Oct 17, 2017 | 67 views


Repair your vehicle right away. Just click on the link I attached 2001 2003 Mitsubishi Lancer Evolution 7 EVO VII Service Repair Workshop...

2002 Mitsubishi... | Answered on Oct 13, 2017 | 148 views


Did you service the caliper slide pins to ensure the caliper slides freely? A rusted pin causes vibration.

Also check your ball joints and ties rod ends for wear. New bigger rims can accentuate worn components.

Do your new rims include hub adapter rings to EXACTLY center the rims on the hubs?

2002 Mitsubishi... | Answered on Sep 06, 2017 | 88 views


Start by verifying that the timing belt has not jumped a few teeth. You may also have a vacuum leak or poor fuel pressure. Undo the gas cap and see if the problem goes away. If it does, the fuel pump may be worn out.

2002 Mitsubishi... | Answered on Sep 06, 2017 | 108 views


Its just a relay they are cheap try replacing it , if that does not work,look for a bare wire and replace it. Or simply run a wire from fuse box that is key on hot only into the hot side of fan connector and a ground off other side of connector. It sounds harder than what it is.This way it comes on when you start it and off when you shut the vehicle down.

2002 Mitsubishi... | Answered on Sep 01, 2017 | 225 views


You are on the right track clean dirty throttle body.

2002 Mitsubishi... | Answered on Aug 05, 2017 | 38 views


Sounds like outer carrier axel bearing problem. Safety hazard exist. It could lockdown and damage your brake components. Investigate soon. Change both CV axels when you replace the bearings. You will be money and time ahead.

2002 Mitsubishi... | Answered on May 22, 2017 | 54 views


hydraulic clutch
replace the master and slave cylinders
cable clutch
replace the cable
if cable also check the engine mounts for failure as if the engine is allowed to move , the clutch action is affected

2002 Mitsubishi... | Answered on May 04, 2017 | 86 views

Not finding what you are looking for?

1,446 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85160 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...