20 Most Recent 2000 GMC Envoy - Page 2 Questions & Answers


It is furthest back, closest to the left(driver side) of the valve body. It will have a red and light green wire going to it.
AC Delco part number: 24230298
You can get it from places like rockauto.com for $15 plus shipping.
Please let me know if I can further assist you.

Regards, TXTEXAN

2000 GMC Envoy | Answered on Mar 28, 2011


There has been a problem with the Dex cool orange antifreeze deteriorating the upper and lower intake manifold gaskets, causing coolant to leak in to engine.If there is antifreeze in your oil, it will ruin your engine. If you find antifreeze in the oil it will cause the oil to become thick and frothy and will not lubricate the bearings and other moving parts, causing an engine failure. If there is evidence of coolant in the oil, do not drive the vehicle. Have it towed to a repair shop and have the gaskets replaced, oil and filter changed, cooling system flushed and refilled with GREEN antifreeze that is compatible with aluminum radiators and engine parts.

2000 GMC Envoy | Answered on Dec 29, 2010


Before attempting to remove the supports get a wooden 2x3 and prop the hatch securely open, next look at the rods carefully, you will see they have a clipping device that secures them to a small ball type joint both top and bottom, be careful as some have the rear window electric grid plugged into them, disconnect with care as not to damage the connectors or the wire.

2000 GMC Envoy | Answered on Jul 02, 2010


mcdevito75 here, That"s an expesive job approx. $500.00--------$800.00

2000 GMC Envoy | Answered on Jun 18, 2010


this truck has problems with the instrument cluster i would say thats the problem but the only people that can test that system is the dealer

2000 GMC Envoy | Answered on Mar 16, 2010


you may need a instrument cluster

2000 GMC Envoy | Answered on Mar 11, 2010


There should be two small threaded holes, insert the proper size bolt inside and screw the bolts in, alternating a few turns at a time. This will force the drum off the brake shoes.

2000 GMC Envoy | Answered on Feb 23, 2010


no it is sequential fuel injection

2000 GMC Envoy | Answered on Jan 20, 2010


if you have the door panel off, you can give power directly to the motor to test it. I would use wires long enough to go from the battery to the motor plug. the wires are ground and hot to make the window operate in one direction and reverse them for opposite direction. this will tell you if the problem is the motor.good luck

2000 GMC Envoy | Answered on Dec 27, 2009


GET TUNEUP CAP&ROTOR PLUGSWIRES,CHANGE THE FUEL FILTER

2000 GMC Envoy | Answered on Oct 30, 2009


you will see a brass "nut" on the engine block near the oil filter, with a wire attached to it and yes, you can get a leak from it, it's a common fault on most engines.

2000 GMC Envoy | Answered on Oct 09, 2009


Your injectors could be dirty, or bad, also plugs could be filed.

2000 GMC Envoy | Answered on Sep 23, 2009


I would check the turn signal flasher relay which is usually located in the fuse box.

2000 GMC Envoy | Answered on Jul 28, 2009


it probably means you have a faulty headlight bulb

2000 GMC Envoy | Answered on Jun 22, 2009


I would start by looking at the cigarette lighter. Sometimes they build up such a large amount of corrosion that it actually can cause a draw on the battery.

2000 GMC Envoy | Answered on Jun 20, 2009


If this low beam is on one headlight only, I would say that the light is burnt out. Both hi and low beams are on the same bulb.The bulb has 2 filiments, one low and one hi. If you get just one light out , it is most likely a bulb. If you get both sides not working at the same time, it could be something else. You have checked the fuses and deemed them to be o/k. Then you should be checking for headlight bulbs.

2000 GMC Envoy | Answered on May 05, 2009


The cylinder head is a crucial part of all combustion engines, and cylinder head cracking can result in catastrophic damage to the engine. In some cases, cylinder head cracking may result in such severe injury to the engine that it must be replaced. As a result, most motorists try to prevent cylinder head cracking, as an ounce of prevention in this case is worth many pounds of cure. The causes of cylinder head cracking are all relatively simple and easy to prevent, except in the case of mechanical parts failure through no fault of the operator. The cylinder head, used in combination with a head gasket, seals the cylinders of the car, along with other parts associated with them. The cylinder head is customized for the vehicle, and has very precisely milled surfaces to provide a smooth and flush fit with all connecting parts. In the case of a minor crack, the cylinders may lose compression and misfire. Major cracks can cause severe damage to the cylinders of the engine. For this reason, when replacing either the cylinder head or the head gasket, make sure that you are using the correct parts, including bolts, for the job. Even a brand new car can experience cylinder head cracking if parts have been installed incorrectly or if there are weaknesses in the metal. Especially in the case of a vehicle which is still under warranty, drivers should contest the cylinder head cracking with the dealer. Be certain to inspect any vehicle before you purchase to check for weak spots in the metal or incorrectly installed components. This includes the cylinder head gasket, because improper installation of this vital part can cause cylinder head cracking. Cylinder head cracking has become more common as car manufacturers use mixed metals in their engines. Many vehicles, for example, have a solid cast iron engine block but an aluminum cylinder head. These two metals expand at different rates, and this can lead to cylinder head cracking. The most common cause of cylinder head cracking is overheating. When a vehicle overheats, it puts stress on all of its metal components, including the cylinder head, which is often at the center of the heat. This can cause the head gasket to fail, which may lead to cylinder head cracking as the components warp and pressure begins to leak. All drivers should properly maintain their vehicles to prevent overheating. Many drivers mistakenly pour cool water into the radiator when their vehicles overheat, in an attempt to bring the temperature down. This is not a good idea, because the rapid temperature change will cause cylinder head cracking due to thermal stress. In a case where the cylinder head survives overheating, the driver may inadvertently destroy it by trying to do good. To prevent overheating, make sure that your radiator is filled and in good condition, with a tightly sealed cap. Check to be certain that your engine thermostat is in good working order, and accurately reflecting the temperature. Make sure that you have no leaky belts or stretched hoses, and that the fan is working effectively. If your car does overheat, stop, turn off the engine, and allow it to cool completely before adding water. Cylinder head cracking can also be caused by localized hot spots in the engine, which usually represent a failure in some portion of the cooling system. Always make sure that hot spots are addressed, particularly if your head gasket has failed and required replacement recently. Hot spots are often caused by uneven expansion of engine parts, leaky hoses, and pre-ignition in the cylinders of the engine. If your car has overheated, check the cylinder head and gasket for signs of cracking or warping. If the cylinder head has warped even slightly out a flush state, it will cause cylinder head cracking. In this case, the head gasket may need to be replaced and the cylinder head should be ground even again before it cracks. Thanks for using FiXya - a FiXya rating is appreciated!

2000 GMC Envoy | Answered on Jan 21, 2009

Not finding what you are looking for?
2000 GMC Envoy Logo

72 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2004 GMC Envoy
2004 GMC Envoy

2,175 Questions

2002 GMC Envoy
2002 GMC Envoy

1,364 Questions

2003 GMC Envoy
2003 GMC Envoy

1,327 Questions

2006 GMC Envoy
2006 GMC Envoy

569 Questions

2005 GMC Envoy
2005 GMC Envoy

521 Questions

Top GMC Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Envoy GMC

  • Envoy GMC

Most Popular Question

coolant in oil

  • Cars & Trucks
Loading...