20 Most Recent 1987 Chevrolet S-10 Pickup Questions & Answers


Go to Autozone.com, become member, will give you repair manual,location of parts,diagrams.

1987 Chevrolet... | Answered on Jun 16, 2018


NOTE<< If Picture Does Not Show Please Email Me @ rejakwilson@aol.com And I Will Send it to You It IS DETAILED And COMPLETE Diagram of Exactly What You Ask For.

Vacuum and Vapor Hose Diagrams Notes Vacuum Actuation System 42242444

1987 Chevrolet... | Answered on Feb 16, 2018


The three lines hanging under the truck connect to a valve on top of the 4x4 transfer case, this is why the 4wd does not work. As for the throttle body lines there should be a diagram on the radiator support that explains that. You should have one large line that goes to the PCV valve, a small line going to the air cleaner, a small line connected to the MAP sensor and possibly another connected to a valve that controls the EGR valve. Your fifth line should connect to a port on the manifold that supplies vacuum to a tank that is the vacuum source for the HVAC control doors and the front axle engagement system. The axle engagement system is what the line hanging by the transmission under the truck is for.

1987 Chevrolet... | Answered on Jun 03, 2017


Idle set is at the side of carb on linkage. it is mechanical adjust....mixture is not mechanical but directly changes the mix of fuel to air.

1987 Chevrolet... | Answered on May 16, 2017


Did you get the alternator wet?
Have somebody measure the voltage in the alternator, just to get that out of the way.

1987 Chevrolet... | Answered on May 15, 2017


lower left dash

1987 Chevrolet... | Answered on Apr 29, 2017


Try removing one bulb or the other at one time preventing power completing the circuit if the problem in a light. Those ones are tuff to find but second place I would start is removing front door cils and cleaning out and playing with wires in there to see if you can find a problem, also wires in the boot between door and frame, usually drivers side cause it's used more often.

1987 Chevrolet... | Answered on Apr 12, 2017


Take out the #1 spark plug and turn the engine by hand until you feel compression building when your thumb is over the spark plug hole. Now continue turning the engine slowly while watching for the timing mark on the dynamic balancer line up with the TDC mark on the timing indicator. Position the distributor so that the rotor is pointing to the #1 plug wire position on the rotor cap. When you mesh it with the cam gear, it will move past the #1 position. Take it back out and move the rotor to compensate for the distance it moves when the distributor is fully seated. Install the base clamp and bolt but don't tighten the bolt yet. Make the engine ready to run. Hook up a timing light and start the engine and set the timing by rotating the distributor until the timing marks are correct, then tighten the clamp bolt.

1987 Chevrolet... | Answered on Oct 25, 2016


As long as they are both 4 wheel drive.

1987 Chevrolet... | Answered on Apr 15, 2016


When you disconnect your battery or remove the fuse and then reconnect itagain, it disables the radio. This is an anti-theft protection for your carradio.
The enable your radio the activation code is in your vehicle owner's manual. Ifyou do not have this code you need to go to your vehicle manufacrurers service centre andget them to enter this code for you.

1987 Chevrolet... | Answered on Apr 13, 2016


10-12 degrees BTDC is normal for chev motors

1987 Chevrolet... | Answered on Mar 20, 2016


no, there is no idle screw on them if it is fuel injected. although you could try changing the idle air speed sensor

1987 Chevrolet... | Answered on Feb 19, 2016


How long has it been since the truck has had a tune up?

1987 Chevrolet... | Answered on Nov 04, 2015


Many things can be the cause for high emissions. Dirty air filter, vacuum leaks, timing set wrong, wrong rpm, bad o2 sensor, defective egr, back cat. converter,sensors out of range ect. ect. It's highly unlikely anyone can guess and really help you. My best advice is find a good mechanic that deals in emission related diagnostics and have it professionally done. Will most likely be a lot cheaper than replacing a lot of parts that won't fix it.

1987 Chevrolet... | Answered on Jun 13, 2015

Not finding what you are looking for?
Cars & Trucks Logo

460 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85108 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

S 10 Chevrolet

  • S 10 Chevrolet

Most Popular Question

1987 s10 2 8lt v6 idles extremely high

  • Cars & Trucks
Loading...