20 Most Recent 1998 Ford Windstar - Page 9 Questions & Answers


Usually Located by the master cylinder by the power brake booster, on the firewall, drivers side.

1998 Ford... | Answered on Jun 17, 2014


your door switches are probably dirty spray them with wd40 then scrub them with a tooth brush

1998 Ford... | Answered on Jun 11, 2014


I\'m assuming you have the 3.8 engine,although i believe the firing order is the same on all there v6 sideways mounted front wheel drive Windstars. That firing order is 1-4-2-5-3-6, with 1-2-3 going from left to right on the back side of the engine and 4-5-6 left to right on the front side of the engine.Looking straight down at the coil from the front of the car,you\'ll see 2 rows of coil terminals.The row on the right side is 1-2-3 going from top to bottom,row on left side is 6-5-4 going from top to bottom. Hook the number 1 coil terminal to the number 1 spark plug ,being careful to use the spark plug wire that is closest in length to the length you need. If your just replacing wires,yuo shouldn\'t have to much trouble. If your nreplacing the spark plugs you will find the ones in the rear,especially the number 2 [the middle one} are pretty difficult without removing the cowling. A total pain brought to you by the designers at Ford!

1998 Ford... | Answered on Jun 10, 2014


do you have the keys in it? if not there is a sensor that connects to the key cylinder i had that problem i fixed it and so far it worked it only dings now only when the key is in it.

1998 Ford... | Answered on Jun 07, 2014


Try to get at them from under the vehicle.

1998 Ford... | Answered on Jun 05, 2014


could be warped rotors.

1998 Ford... | Answered on May 28, 2014


Do you mean the size of the engine? Or the stamped number on the block.

The engine size is on an identification plate usually at the rad support.
The number on the block is hidden, normally you can't see it unless you dismantle quite a bit of the surrounding parts.

If there is more information you need, you can take your VIN number off the dash and call a dealer with it. They can supply you with almost all the information about your vehicle from that number.

1998 Ford... | Answered on May 21, 2014


is the switch in the always on position ? did they stay on for 30 seconds or so after locking /unlocking vehicle prior to this ? so i'd check the the light switch function, if ok then there may be a timer relay for the light that has failed , most likely located in fusebox lower dash drivers side or behind the kick panel drivers side keep me posted if you wish
















?

1998 Ford... | Answered on May 17, 2014


PCV Valve is located in front of the engine on valve cover gasket under the rubber hose that goes from valve cover to intake manifold

1998 Ford... | Answered on May 05, 2014


Did your windstar do this all the time or only when is cold started?

1998 Ford... | Answered on May 05, 2014


Does you motor turns and blows cold air ?

1998 Ford... | Answered on May 05, 2014


Belt pulley and belt tensioner. Belt pulley is fxhed and tensioner is movable. You need to have belt tensioner relased of the pressure using belt tool (long handle and 15'' wrench) .. Then you can folow belt routing diagram located on fan shroud or underneath front hood!

1998 Ford... | Answered on May 05, 2014


PCM (computers) don't fail too often

You need to have the vehicle proper diagnosed
& repaired

You didn't say what the issues were.

Any new PCM will have to be reprogrammed,
most likely at a dealer, as not too many shops
will pay for the access to the MFG Site

Forget anything you were told & just have it diagnosed first

1998 Ford... | Answered on May 05, 2014


high mileage-time for a transmission or properly reinstall a newly installed transmission filter

1998 Ford... | Answered on Apr 30, 2014


Remove gas cap,reset the code,look what happen.Could be bad gas cap,Could be leak,like vacuum,cuts and holes.

1998 Ford... | Answered on Apr 28, 2014


rack and-or pinion... Good thing the 98 is a very good and popular windstar, its not as bad as it sounds.

1998 Ford... | Answered on Apr 25, 2014


Mr. MOMODU, as you said looks like the brakes master cylinder is faulty. is blocking the front wheels.Renew the brakes Master cylinder and bled the system and would be okay.

1998 Ford... | Answered on Apr 22, 2014

Not finding what you are looking for?

2,609 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2001 Ford Windstar
2001 Ford Windstar

1,796 Questions

2000 Ford Windstar
2000 Ford Windstar

1,464 Questions

1999 Ford Windstar
1999 Ford Windstar

1,185 Questions

2003 Ford Windstar
2003 Ford Windstar

996 Questions

1996 Ford Windstar
1996 Ford Windstar

582 Questions

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Windstar Ford

  • Windstar Ford

Most Popular Question

1998 ford windstar

  • Cars & Trucks
Loading...