20 Most Recent 1995 Pontiac Grand Am - Page 8 Questions & Answers


Pull the stearing wheel, and the plastic shroud around the column, then it will come off

1995 Pontiac... | Answered on Oct 31, 2011


u r without a repair manual-special tools may be needed too--go to discount A etc n look over the haynes books n see if u r comfortable attemping

1995 Pontiac... | Answered on Sep 12, 2011


there is a tool that techs use that will roll the motor forward to get more room for acess to the rear plugs after the upper front motor mount(dog bone) is removed.you can buy one at the auto parts store that sells tools.

1995 Pontiac... | Answered on Sep 10, 2011


check your ignition fuse and relay fuse

1995 Pontiac... | Answered on Sep 09, 2011


change the CTS.

1995 Pontiac... | Answered on Aug 29, 2011


ECU is in front of the passenger , you should remove the right side bottom dash board it is behind that.

1995 Pontiac... | Answered on Aug 29, 2011


It is in the front of the engine attached to the frame

1995 Pontiac... | Answered on Aug 29, 2011


I could be the relay or the cts(coolant temp sensor) or the motor of the fan.

1995 Pontiac... | Answered on Aug 29, 2011


Make the FixYa experience better for everyone by voting.

Hi,

My name is Ben and I'm your guru, i.e., an influential teacher or popular expert: a management guru. - origin from Sanskrit, 'weighty, grave'.for today, for today.

As you evaluate my advise and suggestions, there are a few things you must keep in mind:

• I did not diagnose your problem and am therefore only able to evaluate what you tell me. For example, if you ask me a fuse location, that doesn't mean that I can tell you the reason why the fuse blew.
• A thorough diagnostic approach involves the use of technical equipment, xuch as voltage meters. scanning equipment and other sophisticated devices.
• Lastly, fixing one problem can very easily reveal a problem with something that you might consider unrelated. If that happens, you might want to view me as being incompetent.

Subject: The steps one must take to measure the fuel pressure on a fuel injection engine

Customer's description: where is the fuel system test port located on a 1995 grand am? the car engine has been stalling out, when first started not much power until the engine gets warm

Discussion: Provide the customer with the response requested. However the problem may well be the idle relief valve, the crankshaft sensor, the camshaft sensor, or the fuel pressure sensor.

There is a large is attached to the fuel sender assembly to the top of the intake manifold and supplies fuel to the injectors. A fuel pressure tap is located on the rail for quick pressure checks.

If you don't have a pressure gauge, AutoZone will loan you one FREE.

HINT: Try and find an Actron CP9110 code scanner so that you can perform a full diagnosis of your problem.

All the best,

Ben

1995 Pontiac... | Answered on Aug 27, 2011


Don't visually check the fuses, not a reliable way to verify if they are good or not....check all the fuses using a test light.

1995 Pontiac... | Answered on Aug 25, 2011


If a number only ..
12

1995 Pontiac... | Answered on Aug 22, 2011


It is easy to locate:
Under the hood right side directly in front of the driver in the rear right corner of the engine compartment ..there are four relays commonly the second one from the right hand side
It's wires is
red to terminal 30
red to terminal 85
dark green to terminal 86
light blue to terminal87

1995 Pontiac... | Answered on Aug 22, 2011


remove as followed :
1- upper trans cooler line.
2-upper radiator hose.
3-lower trans cooler line.
4-cooling fan electrical connection and retaining bolts .
5-coolig fan.
6-splash guard below lower radiator hose .
7-lower radiator hose from radiator.
8-condenser line retaining clip.
9- condenser to radiator bolts .
10-coolant tank small hose from the radiator .
11-radiator retaining bolts.
12-radiator ....
That's it. feel free to contact me I did this removal more than five times to your grand am type specifically .

1995 Pontiac... | Answered on Aug 22, 2011


Commonly it is the thermostat and the location is :
Follow the large hose on the left side of the radiator until you find the piece it connects to(with the engine ). This is the thermostat housing, the thermostat is inside it.

8_22_2011_10_19_58_am.gif

you'll find this view from the left side of the engine .

1995 Pontiac... | Answered on Aug 22, 2011


Which pins did you mean ?? from which side are they in the pic?

8_22_2011_9_50_10_am.jpg

1995 Pontiac... | Answered on Aug 22, 2011


You may have to reset it by putting in a code. You can find the code in your owners manual. In our Grand Am we have to reset the Check Oil light after we change the oil. For the oil light it is something like press the gas peddle in 5 times within 30 seconds....something like that. Good luck

1995 Pontiac... | Answered on Aug 14, 2011

Not finding what you are looking for?
1995 Pontiac Grand Am Logo

799 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Pontiac Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Grand Am Pontiac

  • Grand Am Pontiac

Most Popular Question

key wont turn front or back in pontiac

  • Cars & Trucks
Loading...