20 Most Recent 2003 Buick Park Avenue Questions & Answers


On this website you find fuse box diagram and description for Buick Park Avenue (2003)

Buick Park Avenue 2003 2005 fuse box diagram CARKNOWLEDGE

2003 Buick Park... | Answered on Oct 25, 2018


That bulb/wire may have been for one of those red marker lights on the side of the car. If it got all full of slush it may have shorted something else, and those other two items may be in the same circuit that is now shorted out.

2003 Buick Park... | Answered on Nov 17, 2017


You could be hearing the air compressor for the air shocks running. This would indicate an air hose cracked or fallen off the shock.

2003 Buick Park... | Answered on Sep 09, 2016


From where , any switch ? driver door switch or either passenger door switch . This is a very complex system controlled by modules (microprocessors)
?€¢
The driver door switch assembly (DDSA)


?€¢
The driver door module (DDM)


?€¢
The passenger door module (PDM)


?€¢
The rear door module (RDM)


?€¢
The LH front power door lock switch


?€¢
The RH front power door lock switch


?€¢
The LH front door lock actuator


?€¢
The RH front door lock actuator


?€¢
The LH rear door lock actuator


?€¢
The RH rear door lock actuator


?€¢
The remote control door lock receiver (RCDLR)


?€¢
The power door serial data circuit


?€¢
The class 2 serial data circuit


?€¢
The DRVMDL Fuse - 10 amp


?€¢
The PDM Fuse - 10 amp


?€¢
The RRINMDL Fuse - 10 a
Class 2 and Power Door Serial Data Links
The class 2 and power door data circuits are both serial data links. The serial data circuits replace cables in the vehicle by multiplexing (time-sharing) data to and from each device over a single wire referenced to ground. If the power door serial data is lost, both the rear door module (RDM) and the passenger door module (PDM) enters the sleep mode. With the RDM and the PDM in sleep mode, no power door operations are possible.
Your best bet is to take it to the dealer or an ASE certified repair shop .

2003 Buick Park... | Answered on Feb 20, 2016


parts store. there cheap. less than what you would need to buy for a temp fix.

Hope this helps Mike

2003 Buick Park... | Answered on Feb 10, 2016


get it to a dealer and have it serviced

2003 Buick Park... | Answered on Aug 05, 2015


It is part of the ABS wheel sensors.So yes it is part of the ABS system.

2003 Buick Park... | Answered on Jul 31, 2015


Idle speed is normally controlled by the idle air control motor. These units get dirty and fail, but can often be cleaned and restored to normal function. You will need to remove the unit to clean it, but be careful not to damage the plunger and seat. Use carb + choke cleaner and maybe a small screwdriver (carefully), then blow unit out with compressed air. Replace gaskets as needed. Also low idle can be caused by vacuum leaks, bad O2 sensor, clogged exhaust (cat converter), dirty MAF, bad coolant temp sensor.

2003 Buick Park... | Answered on Jun 15, 2015


Is the check engine light on/flashing? You may have a cylinder misfire causing a rough idle and poor hesitation like acceleration

2003 Buick Park... | Answered on Apr 11, 2015


sounds like the linkage is broken/disaconnected, under the hood against the firewall is the wiper motor assy, behind that is the linkage something must be broken/disconnected

2003 Buick Park... | Answered on Apr 04, 2015


The fuse box is located under the clove box you may need to remover the clove box door to have a good view

2003 Buick Park... | Answered on Mar 24, 2015


To start you have to run the codes from the stability control module, and once that's done then you can beging to look for the problem, only a tech II scanner can reset this module, also make sure all tires are the same size

2003 Buick Park... | Answered on Mar 17, 2015


Did you also replace the spark plug wires? The burn lines on the ceramic would indicate that it's jumping fire. Are the burn lines on ALL the plugs or just one or two? If you look closely at the wires in the dark, you will be able to see the spark jumping to ground if the wires are bad. If you have already replaced the wires and still have that issue, it's possible that you have a bad coil pack or ignition module.

2003 Buick Park... | Answered on Dec 18, 2014


Remove a couple bolts holding it on

2003 Buick Park... | Answered on Sep 29, 2014


The springs are bad. Shocks will not correct worn out springs.

2003 Buick Park... | Answered on Aug 31, 2014


Sounds like an emission problem. Take it to your local parts store (AutoZone. Advance, Oreilly's). They usually connect the scan tool and check for free.

2003 Buick Park... | Answered on Jul 30, 2014

Not finding what you are looking for?
2003 Buick Park Avenue Logo

210 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Buick Experts

Marvin
Marvin

Level 3 Expert

85160 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Park Avenue Buick

  • Park Avenue Buick

Most Popular Question

windshield wipers working fine now not

  • Cars & Trucks
Loading...