20 Most Recent 2005 Lexus Is 300 Questions & Answers


i presume your asking about the clutch slave cylinder ,this will be located under the hood at the bulkhead end of engine compartment ,there will be a small fluid resovoir sitting on top of the actual hydraulic slave cylinder , the clutch fluid resorvoir is smaller , and usually not opaque, than the brake fluid resorvoir, which are usually next to each other , incidentally the brake also has a slave, or more usually known as the master , cylinder

2005 Lexus Is... | Answered on May 14, 2014


P0103 OBD-II - Mass Air Flow (MAF) Circuit High Input
This DTC means that there is a problem with the Mass Air Flow High (MAF) sensor or circuit. A more technical description would be that the MAF circuit had higher than expected voltage (air flow). Other MAF sensor circuit DTC trouble codes are P0100, P0101, P0102, and P0104.

A code P0103 may mean that one or more of the following has happened:
- The MAF may be disconnected, or a wiring connection may be bad
- The MAF sensor may be damaged
- The vehicle computer may be faulty (very rare)

Feel free to contact us in this DTC P0103 code link, if you need additional details.

Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day.

2005 Lexus Is... | Answered on Oct 27, 2011


Accessing a Lexus Side Marker LightIt's actually not as difficult as it seems.
Look in the fender liner area (where the wheel wheel is) and you will see the screws that hold the liner in place.
Once you remove the bottom screws (or be it the screws that hold the edges of the fender liner), you can carefully pull it back a bit to expose the bulb and socket. To remove the socket turn it counter clockwise until you can pull it out. To reinstall the socket turn it clockwise until it locks in place
Carefully remove the bulb from the socket and replace with same type. To remove the bulb pull it straight out. Push the new bulb straight in. The bulb is a 194 5w bulb.
Note: most of the time the reason the bulbs are burning out in the bumper is due to water getting in behind the lens and not being able to drain.
What I have done is use a Dremmel tool to carfully drill a very small hole along the bottom of the lens to allow the water to drain. Another option is if you have clear silicone you can suirt some around the outside of the lens. This will prevent water from getting in. However, if there is already water in the lens you will have to drain the water first. To drain the water use a ratchet wrench and unscrew the nut that holds the lens to the bumper.
In severe cases of corroded sockets you might have to replace the socket where the bulb goes into.

2005 Lexus Is... | Answered on Oct 12, 2009


Where is my 2001 Lexus is300 coolant sensor located at can write at drevargas70@gmail.com o can text 414-856-6955 I'll appreciate

Lexus IS 300... | Answered on May 07, 2017


Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.


To confirm the problem, the basic troubleshooting is required.



From start to end troubleshooting these problems I suggest you to check the help link below and follow its procedure: -----


Mostly all types of car no start problems are discussed here with solutions:---


CAR NO START: ENGINE NOT TURNING OVER:
http://alltypesofpartsreplacing.blogspot.com/2012/11/car-no-start-engine-not-turning-over.html
---------
These will help.
Thanks.



Lexus IS 300... | Answered on Dec 07, 2012


The code is for a failed throttle control motor or circuit.
You might check to see if the throttle control is plugged in, otherwise you may need a shop manual to test the component.

Lexus IS 300... | Answered on Dec 07, 2012

Not finding what you are looking for?
Cars & Trucks Logo

15 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Lexus Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

IS 300 Lexus

  • IS 300 Lexus

Most Popular Question

slave cylinder located is300

  • Cars & Trucks
Loading...