20 Most Recent 2006 Peugeot 604 Questions & Answers


Try blanking off the EGR valve where it mounts on the exhaust manifild, they dont do much usefull but are unreliable and leak ehaist gasses into the inlet, also they take pressure off the torbo leading to over fuelling.

2006 Peugeot 604 | Answered on Oct 07, 2018


best advice i can give is to make a coca can gasket for the ERG valve so it blocks the hole off ,then it will run ok promise ,you do not this device and it will pass the mot without it ,nobody will even know its blocked off

2006 Peugeot 604 | Answered on Apr 28, 2018


Sounds like you could have a blockage or thermostat in backwards blockage to the radiator or the head gasket was pinched while putting it back in and it's just overheating real bad having it come out through the reservoir tells me that the cap is blowing off steam usually that happens when you don't have enough circulation through the radiator I don't know what condition the water pumps in or what not but check those things first make sure that you have flow going through the radiator never open your radiator cap when it is hot like that you'll have to let it cool down and don't add cold water after does cooldow and don't add cold water after does cool down to a hot engine you can crack the block let it cool down then protect yourself open the radiator cap very slowly look inside and if your radiator is empty after it's cooled down you can add some water first because if it's leaking you don't want to put coolant on the ground being as it is poisonous and can kill animals with one sip and not very good for humans either, you can feel about half way up with water then start the engine and then continue to add water until you have waterfall in the radiator now this point do not rev the motor just leave the cap open and look inside wear safety glasses it'll be cold for a little while and it starts to heat up you can see if it starts to flow through the radiator cuz it would be going through the bottom of the radiator into the motor through the motor and will return to the radiator at the top so you can see the water flowing by then you know at least that you have water pump working and that the flow is flowing through the block and the thermostat now if it starts to get hot right away and it's not flowing and starts to boil over new thermostats not opening in your head gaskets probably toast because sometimes when you put water back in the thermostat won't open you think that you have a full radiator and you close the cap and start driving and then the thermostat opens and now all the sudden you don't have a full radiator anymore and starts to heat up right away so check those things always be safe and good luck

2006 Peugeot 604 | Answered on Feb 18, 2018


This sounds like it is a fuel supply problem NOT an exhaust issue. It will be worth you getting a good garage to check the whole fuel system. "Back firing" is a loud bang caused by too much fuel passing all the way through the engine and exploding when it hits the hot exhaust. It is NOT very common in modern cars so get a good mechanic to check the car.

2006 Peugeot 604 | Answered on Jan 05, 2018


get the factory manual from the given link and easily fix the problem http://toolsnyou.com/

2006 Peugeot 604 | Answered on Sep 25, 2017


I want to change the side-light bulb on my Citroen Picasso off side front. I can get the near side one off, but find it difficult to turn the bulb holder inserted in the head light lens. Should I use some outside help like a HAMMER? Pete

2006 Peugeot 604 | Answered on Jan 08, 2017


Hi, I have a 2.0HDI Expert which was doing the exact same thing as yours, blowing thick black smoke, sluggish and loss of power on gradients, a hissing sound and surging. I replaced the air flow meter but that didn't help. I was told to replace the turbo but a turbo expoert told me not to as it would blow white smoke if it was faulty. I was then told to replace the injectors but a diagnostic test showed them to be functioning fine. I was then told to look at the intercooler which had thick sludge at the lower left pipe. I replaced it today - Sunday 12th July and it is now driving like a new van. It now pulls me up gradients with ease in 4th and 5th instead of having to drop gear to get to the top. I got a replacement from Euro Car Parts for £147 inc VAT. To tell if this is your problem, look through the gaps in the lower section of the bumper at what looks like the radiator and look for sludge over the inside of the bumper and all over the pipe where it joins the back of the radiator (intercooler). Also open the bonnet and look down behind the grille for the same sludge. Hope this sorts it for you. Barry, Newtownards, Northern Ireland.

2006 Peugeot 604 | Answered on Jul 09, 2015

2006 604 Manual

2006 Peugeot 604 | Uploaded on Jan 26, 2015

2006 604 Manual

2006 Peugeot 604 | Uploaded on Jan 26, 2015


The reason for the black smoke is that it is not getting enough air to burn the fuel completely.It could be a blocked air filter,obstruction in the air intake system,blown turbo,hole in tube between intake manifold and turbo,or a fault with the fuel system and injectors.

2006 Peugeot 604 | Answered on Aug 05, 2014


auxillary

where might this be?

2006 Peugeot 604 | Answered on Jul 18, 2014


Have it scanned for error code. Idle Air system may foul up. Coolant temperature sensor giving wrong readings will confuse the ECU. It may use 'warm' setting for cold starting, thus fuel would be lean. Ideally it should use 'cold' setting which provides richer air/fuel mixture.

2006 Peugeot 604 | Answered on Jun 13, 2014


use a scanner to reset the CPU program as it may be corrupted from the battery change.

2006 Peugeot 604 | Answered on May 14, 2014


Black smoke is an indication of too much fuel-running rich-in the cylinders. The air/fuel mixture is way off-too much fuel. Possible causes are cylinder misfires (runs and idles rough, a noticeable miss), leaking fuel injectors, or a failed fuel pressure regulator.
Take off the vacuum line to the regulator (on the fuel rail?)-if there is evidence of gas in the vacuum line, the regulator has failed and excess gas is being sucked into the engine through the vacuum line.

You should take a fuel pressure reading to check pressure against the specification for your car.
Also possible that the fuel metering is correct, but the air being supplied to the cylinders is lacking. A clogged air filter could cause that, but you would also experience a rough running condition. Since you didn't mention that, I would think the fuel metering is wrong-too much gas.

2006 Peugeot 604 | Answered on Apr 10, 2014

Not finding what you are looking for?
Cars & Trucks Logo

254 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1984 Peugeot 604
1984 Peugeot 604

-4 Questions

1983 Peugeot 604
1983 Peugeot 604

-6 Questions

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Marvin
Marvin

Level 3 Expert

85160 Answers

scj103

Level 2 Expert

89 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

604 Peugeot

  • 604 Peugeot

Most Popular Question

peugeot expert egr valve

  • Cars & Trucks
Loading...