Question about 2006 Nissan Altima

2 Answers

Reset Nissan Altima seatbelt light which is flashing

I removed the passenger sweat and disconnected the wires. When I reinstalled the seat and reconnected the wires, the seatbelt light is flashing in the dash.

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 5,763 Answers

A scan tool is needed to reset the seatbelt light, unhooking the wires turned the light on as a fault, a scan tool will reset code. also make sure all connectors are connected good, the computer may reset itself after it sees a few key cycles and tests the system and it passes but it may take awhile. i have seen some that will stay on until they are reset, if the light is still on after all this time then a scan tool will be needed to turn off the light. good day.

Posted on Feb 04, 2012

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My seat belt light is staying on what can I do

Posted on Jul 10, 2019

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Anonymous

  • 324 Answers

SOURCE: 1994 Nissan Altima Passenger Door won't open

Since you have the door panel off, pul the rod for the door lock manually inside the door, this should unlock it, if it does not, there is a small push button, basicly a little peice of metal on the latch itself on the door latch inside the door, push it down this should pop the door open, you may need to spray all of the mechinisms with white lithium grease in a arosol can.....

Posted on Nov 26, 2008

Anonymous

  • 14 Answers

SOURCE: 2004 Nissan Altima passenger side low beam

I would look at the fuses also. these newer cars have seperate fuses for driver an passenger headlights.

Posted on Oct 13, 2009

techbuster

INDIRA KUMAR

  • 5081 Answers

SOURCE: How do I change the passenger side headlight bulb on 2001 Altima

Open up the hood, and go in behind the fixture where the light is located. Sometimes there is an access panel on top. Open it and reach down inside and grab the bulb’s socket. Twist the socket a quarter turn counter clockwise, and pull out the socket. Grab the bulb, and pull it straight out. To replace the new bulb, never touch it with your bare fingers, as this will greatly shorten the bulb's life, if it even work's at all. Use a tissue or something else in that order to handle the new bulb. Push the new bulb into the socket, put the socket back into the housing, and twist a quarter turn clockwise to secure the socket into the fix.Seems that you have to remove the coolant bottle(two screws), and also the unscrew the washer fluid bottle, after that you can reach the socket that holds the bulb. There is a wire that holds the bulb in. if you loosen the screw you can tip up the wire and be careful to leave it in place...also the long side of the wire seems to connect to ground wire for the light...

Posted on Oct 14, 2009

Anonymous

  • 10 Answers

SOURCE: 2000 nissan altima: driver side seatbelt is in

Take the bolt out of the top of the seat belt and release the pressure on it.If this doesnt work the safety module will have to be replaced.

Posted on Jan 18, 2010

fingaz22

michael schultz

  • 1068 Answers

SOURCE: 2001 Nissan Altima front power seat does not move

needs a forward/rearward motor. it has two separate motors under the seat. very common and i replace them all the time. good luck

Posted on Mar 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1998 Nissan Terrano R50 with a seatbelt light flashing .


If you have a heavy enough object sitting in the passenger seat, the sensor may think a person is sitting there without a seatbelt on....or in a case that I ran into a few years back, a small coin had lodged inside my locking side seat belt. The side with the release button. Or lastly, have you vacuumed your car recently? You may have unplugged your seatbelt sensor wires while vacuuming.
Your car is getting up in age too, so check to see if the retracting spring is still pulling the seatbelt back into its holster, check the general condition of your locks on the belts....not sure if there is a fuse link for a seatbelt system in your car...but you could check your owners manual to see if there is, and while in the manual...check for reasons the seatbelt light comes on too. You can get a copy of your owners manual on line from Nissan or a aftermarket source. Good luck and sorry I couldn't be more specific. Your owners manual or an on line search of the trouble code and the specific working generated by the readout will give some information I'm sure....Work safely please. and beware of air bags when messing with seat safety issues. If you deploy an air bag on yourself while messing with the safety controls.....you could be killed or injured....so be careful.

Apr 03, 2015 | Nissan Terrano Cars & Trucks

1 Answer

Seatbelts locked after wreck


It is possible that the belt is locked from the crash which activated the reel lock pin. The only way will be to replace the whole unit including the gas container.

Jan 13, 2014 | 2009 Nissan Altima 2.5

1 Answer

The abs light is on


Try disconnecting the negative battery terminal and after about a minute put it back on. This will cause computer to reset and could bring things back to normal.

Nov 07, 2013 | 2007 Nissan Altima 3.5 Sedan

1 Answer

Seat belt light flashes after seat belt is on


The new 2013 Bentley Mulsanne Mulliner has the same thing.I know on the Bat Mobile it means the ejector seat is not fully charged.

The only generic answer I can conclude with information you provide is ;

1) The passenger seat of a newer general motors car

2) The seatbelt light does not light up when the seat is not occupied

3) The passenger side Airbag (SRS) has been turned OFF

4) While occupied , the seatbelt light on the insrument cluster lights steady

5) when the seatbelt is active (buckled with a passenger) the light flashes.

6) anybody?

Mar 31, 2013 | Cars & Trucks

1 Answer

I have a 2005 ford crown victoria P71 ( interceptor). It has cruise but dosent work. I just bought it from the county. It was a active patrol car that was up for replacement (so its in excellent mechanical...


I also have that same vehicle but, I'm sorry to say it does not have cruise. I also have a wiring issue. I replaced the interior (seats, carpet, door panels, and a few dash moldings) with duel power seats, however I through out the old seats before I noted the "wiring colors" for the passenger seat 'seatbelt' and 'airbag' sensor connections. The new seats came out of a 2003 crown vic (not a p71) and had totally different connections under the passenger seat. My '05 p71 did not even have the wires there for a power passenger seat, so I had to replace and wire them in from the harness that I removed from donor car. That actually wasn't TOO bad, and the seats work fine, but I don't know which wires go together for the seatbelt and airbag sensors, as the old wire 'colors' under the seat do not match the 'colors' on the connectors under the new power passenger seat. If you could tell me the colors of the wires to your original seat (passenger), for the seatbelt and airbag plugs you would be a great help in solving my issue with the "airbag" and "seatbelt" light that stays lit on the dash. If I can help with your problem in some way, even though my car does not have cruise, e-mail me and let me know how (ccandrllc@aol.com) .

Dec 18, 2011 | 2005 Ford Crown Victoria

1 Answer

The seatbelt light in the gauge on the dashboard keeps flashing on and off. Passengers wear seat belts when driving..... I have disconnected the battery, recently to replace a burned out head light bulb....


Dear,

the blinking light only indicates the belt position of the Driver seat only.
if you click the seat belt in the fixer.......you will find the light getting off....

thanx

May 16, 2011 | 2004 Nissan XTerra

2 Answers

Seat belt alarm wont stop beeping


Check for wire disconnected where you plug your seatbelt into. it will probably go under the carpet a bit, but it is there. If it is broken/disconnected, the alarm will continue to sound. There is one in the passenger side too, but should only sound when a passenger is seated unless you have more than one problem here...

Oct 09, 2010 | 1987 Toyota Camry

1 Answer

Flashing light on dash - seatbelt indicator


you did'nt state year, make, model. If you are talking about the seat belt light, check your seat belt(the one with the push/release button. check this top to bottom for a broken wire. ckeck under the seat the harness may be damaged as well. If it is the air-bag light bring it to your mechanic. air-bag circuits should be touched without the right knowledge and tools.

Apr 20, 2009 | 2003 Nissan Altima

1 Answer

Seatbelt light on


There is a tiny switch under the **** area of the seat that tells the car someone is sitting there... and a tiny switch in the seatbelt CLICK mechanism. These only have 2 wires which go down to the floor, alongside the running board and up to the dash. The switch nder your **** is NormallyOPEN and CLOSES (makes contact) when someone weighing 50lb or more sits in the seat (smart huh) It could be bent, broken, come loose from its moorings or have a wire loose... At the same time, the passenger seat also has shcu a switch and it might be STUCK or shorted. Same for the seatbelt CLICK mechanisms on both sides. If you don't like loosening seat bolts, pulling up carpeting and removing the inside panels, etc. what we call 'troubleshooting'. find someone that does - or take it to a dealer.

Jan 15, 2009 | 1999 Ford Crown Victoria

1 Answer

Air bag light


hi this may be a long shot ? but if you have auto seat belt pretensioners ie activate on impact ? try under your seat and look for the wire/plug connector these sometimes are cause of light illuminating try this? disconnect plug and clean then re connect see if light off do same on passenger seat constant moving/adjusting seat position ? or inadvertantly catching the wire underseat when vacuuming car are a common cause of loose contacts ?

Oct 13, 2008 | 2005 Hyundai Tiburon

Not finding what you are looking for?
2006 Nissan Altima Logo

2,086 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...