Question about 2008 Ford Escape
Where is the fuel pump drive module located on an 08 Ford Escape
On the bottom of the car near the gas tank, looks like a small square box with wires connected to it.
Posted on Jan 18, 2016
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: 2005 FORD ESCAPE
It is in the right front side of the center console. It is also a programable module.
.They don't call it the GEM anymore it is now called the Smart Junction Box.
Posted on Feb 07, 2009
Actually, even in 1982 Ford produced fuel injected vehicles. They used electric pumps, rarther than the mechanical one r_clark is referring to. So, the question is, is it fuel injected, or is it carbureted? If it's carubureted, r_clark is correct. The timing cover is on the front of the motor as you are facing it. If you look behind the large main pulley at the bottom front of the motor you'll see an oval shaped cover. That metal oval cover is the timing chain cover. Look to the left of it, still facing the front of the engine and you should see the fuel pump if you have a carbureter. If, on the other hand you have throttle body injection, the Ford F250 uses two electric fuel pumps. One is a low pressure pump which is inside the fuel tank, the other is the high pressure pump which is mounted on the vehicle's frame. That one will normally be located just in front of the tank on the inside rail of the frame assembly. It looks like a large cylinder mounted on a bracket with wires going to it. If you see a cylinder that just has a fuel input and output line with no wires, that is an inline filter, not the pump.
Also, keep in mind if you are asking about the pump because you are not getting fuel, you might want to check to see if you have a large canister style filter down there on the frame. If that's plugged, you won't get adequate fuel!
Posted on Feb 08, 2009
SOURCE: Water Pump Drive Belt
there is no water pump drive belt...there's a "Serpentine" belt that powers ALL the accessories and cooling...If you've never done this before, take it to a mechanic (NOT THE DEALER) and have it done ($75)
Posted on Jun 23, 2009
there is also a trianary switch in the cargo area (trunk) make sure this swith has not poped up just push it down if you hear it click it was probably tripped. If it tripped it may need replaced. These switches were used by Ford for many years to stop the fuel pump from running in the event of a crash. Also have you checked the fuse or the relay these are the areas to start before pulling the tank
Posted on Oct 17, 2009
the fuel pump and radio are not on the same circuit, most liokely the fuel pump is shorted, that is the most common cause, get under the truck and disconnect the fuel pump connector at the tank, if the fuse doesn't blow then u need a new pump.
Posted on Dec 05, 2009
Tips for a great answer:
Feb 24, 2018 | 2006 Ford Escape
Dec 19, 2017 | Ford Cars & Trucks
Oct 09, 2016 | Ford Cars & Trucks
Dec 01, 2015 | Cars & Trucks
Feb 18, 2015 | Ford Cars & Trucks
Feb 07, 2015 | Ford Cars & Trucks
Jan 26, 2015 | 2005 Ford Escape
Jan 15, 2011 | 2003 Ford Escape
Oct 14, 2010 | Ford Escape Cars & Trucks
Oct 09, 2010 | 2001 Ford Escape
Nov 27, 2017 | 2008 Ford Escape
Jun 30, 2017 | 2008 Ford Escape
3,384 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: