Question about 2000 Cadillac Escalade

1 Answer

Replacing power steering hose on a 2000 Escalade

Any tips or tricks to replacing the power steering hose on a 2000 Escalade like getting air out of the lines or anything like that?? Seems like an easy enough job even for a novice like myself.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cadillac Master
  • 14,750 Answers
Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: pitman arm 2000 escalade

I'm in the middle of doing mine now. The steering box needs to be pulled out of the truck. Arm will need a puller to be taken off the output shaft of the steering box.

Posted on Feb 27, 2009

michigan man
  • 3533 Answers

SOURCE: Power Steering Pressure hose, 1976 Cadillac Eldorado

yes you can repair it and you are right about the flang try this website to see if they have your car listed www.autozone.com to get pictures and diagram i also would like to give you this information website www.schramauto.com if you ever have any hard to find GM-parts Schram auto & truck parts sells only GM-parts and i hope i have been some help to you and you have a nice car.

Posted on Apr 25, 2009

motor1258
  • 6674 Answers

SOURCE: power steering

Checked fluid level & belt?

Posted on May 10, 2009

  • 105 Answers

SOURCE: suddenly without brakes or power steering

check belt and check p/s fluid if ok pump is probably bad with truck running you should be abel to see the fluid flowing threw th reservior when running

Posted on Jun 04, 2009

Mike258
  • 1498 Answers

SOURCE: I HAVE A 2000 CADILLAC ESCALADE IT IS LEAKING POWER STERRING

Hi ydz,

Sounds like it's pumping out a lot of fluid..

There is something else that happens periodically, The fittin\gs on the hi pressure hoses get loose. Happened to me the first week of Summer.

All I had to do was tighten them back up, add some more fluid and drive away.

If this is not the case, the leaking component does need to be replaced.

Best regards
Mike

Posted on Sep 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace suction and return hoses on power steering reservoir


How-to: Replacing the power steering reservoir to pump hose - CEG ...

contour.org/.../82138-how-to-replacing-the-power-steering-reservoir-to-...
Jul 3, 2013 - How-to: Replacing the power steering reservoir to pump hose ... to allow air into the suction side of the PS pump, aerating the fluid. ... off the spring hoseclamps from the smaller return hose and the large hose to the pump.
images for How to replace suction and return hoses

Dec 01, 2015 | Cars & Trucks

1 Answer

How to replace the power steering hose on a 2000 Escalade


keep reservoir topped up and lockwheels left and right should take fluid down and and clear air from pipe

Oct 15, 2012 | 2000 Cadillac Escalade

1 Answer

2000 mercury cougar keeps overheating, first couple of times it was the hose on the radiator, now it is hard to steer and blowing steam from power steering area? please help


Hello, blessed_13 and thank you for asking your question on Fixya!

Here is a simple process that will walk you through a few steps that will pinpoint the overheating problem on your
2000 Mercury Cougar, without even using any tools. It has helped millions of people, and I am certain that it will help you, because I wrote it for people in your exact situation.
How to diagnose your overheating
2000 Mercury Cougar
I would pay close attention to the belt tension part of the instructions.

Get more great money saving tips and tricks about your vehicle from: twitter.com/acoates23234

Thanks for the vote, and good luck!

Dec 08, 2010 | 2000 Mercury Cougar

2 Answers

I HAVE A 2000 CADILLAC ESCALADE IT IS LEAKING POWER STERRING


Use a degreaser to clean the pump and hoses, then start the engine and you should then be able to see exactly what is leaking to then determine what to replace.
I hope this helps and good luck.

Sep 19, 2009 | 2000 Cadillac Escalade

1 Answer

Need to replace high pressure power steering hose on 2004 Monte Carlo SS. Need tips to effectively do the job myself. Tools needed, tricks to make the job easier, what not to do...etc. Thank yiou so much...


Power Steering Line/Hose: Service and Repair
Pressure Hose
Power Steering Pressure Pipe/Hose Replacement (3.8L)
Removal Procedure
1. Place a drain pan under the vehicle.
2. Remove the accessory drive belt.
3. Raise and support the vehicle. Refer to Vehicle Lifting.
4. Remove the tire and wheel assembly.
5. The power steering pressure hose is the lower hose at the power steering gear.
Remove the power steering pressure hose from the power steering gear.
6. Remove the power steering pressure hose from the power steering pump.
7. Remove the power steering pressure hose from the clamps on the power steering gear.
8. Remove the power steering pressure hose from the vehicle.
Installation Procedure
1. Install the power steering pressure hose to the vehicle.
2. Install the power steering pressure hose to the clamps on the power steering gear.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the power steering pressure hose to the power steering pump.
^ Tighten the fitting to 27 Nm (20 ft. lbs.).
4. Install the power steering pressure hose to the power steering gear.
^ Tighten the pressure hose fitting to 27 Nm (20 ft. lbs.).
5. Install the tire and wheel assembly.
6. Remove the drain pan from under the vehicle.
7. Lower the vehicle.
8. Install the accessory drive belt.
9. Fill the power steering system with power steering fluid.
10. Bleed the power steering system.
11. Inspect the power steering system for leaks.

00d203e.jpg

Sep 15, 2009 | 2004 Chevrolet Monte Carlo

1 Answer

Pitman arm 2000 escalade


I'm in the middle of doing mine now. The steering box needs to be pulled out of the truck. Arm will need a puller to be taken off the output shaft of the steering box.

Feb 16, 2009 | 2000 Cadillac Escalade

1 Answer

Mazda popwer steering


probably air in the system . you have to work the pump by turning the steering wheel left to right to get the air out of the system

Jan 18, 2009 | 2005 Mazda Tribute

1 Answer

2001 hyundai tiburon power steering hose


Take the old hose to a parts dealer and they should be able to tell you exactly which hose is the proper hose.

Dec 26, 2008 | 2003 Hyundai Tiburon

2 Answers

Replace power steering hose on 2000 Jeep Grand Cherokee


Parts are not cheap. I'm not sure how hard it is to get to your lines but line wrench/crows foot are probably needed. They are like a boxend wrench with cutout to go over line.

Nov 29, 2008 | 2000 Jeep Grand Cherokee

2 Answers

I need to rplace tke power steering hose on a 2000 kia sephia


we tried fixing the old power steering hose, finally just had it taken off and another made up by an auto shop, cost $65 to have one made. very easy to fix, just undo at each end. this is a pressure hose though so make sure and get the same kind made.

Nov 08, 2008 | 2000 Kia Sephia

Not finding what you are looking for?
2000 Cadillac Escalade Logo

278 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...