Question about 2002 Mitsubishi Lancer

1 Answer

Where is the flasher fuse located

Turn signal and emergency flashers don't work

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

Eather under the hood, same side of ur car battery just a little above, its big plastic thing pull that off should be marked on plastic which is flasher fuse or check inside just a little left below ur steering wheel

Posted on Nov 15, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 134 Answers

SOURCE: my turn signals and my emergency flashers went out

it sounds to me that your flasher went bad buy one and install it it should be under the dash somewhere.

Posted on Oct 15, 2009

  • 359 Answers

SOURCE: turn signals do not work

pretty sure its the same flasher for both check your fuses and also your blinker switch.

Posted on Jun 07, 2008

  • 23 Answers

SOURCE: turn signals

turn on the emergency flashers follow the clicking noise and that is where you will find it is the same relay for the right and left

Posted on Jul 19, 2009

  • 811 Answers

SOURCE: Turn signals not working

check bulbs

Posted on Oct 10, 2009

  • 1509 Answers

SOURCE: i drive a 2000 mitsu.

The emergency flasher switch is also the turn signal flasher It pops out of the dash and can be replaced easy. do chaeck the fuses before going to this much troble. check all the fuses as some work backup circuits that you wouldn;t think would be important. Before replacing the flasher switch ( you may only be able to buy it from the dealer) work the switch several times and the flashers will come on cheak to see if allthe lights work thenturn the flashers off and see ( with the key on if the turn signals now work. Now if during the test with the four way flashers you see a bulb or more out you know that the turn signals wouldn't work, but the four ways will. they work on different fuses so chak the turnsignal fuse too. after cycling the switch try the turn signals again as the switch is likly to stick and sometimes cycling it will get the turn signals working again. Fooling around with the switch you may find a position that the turn signals work. if you can't get it to stay working then you'll have to change the flasher emergency switch.

Posted on Sep 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 tacoma flashers don't work but turn sig do work!


The hazard switch gets power from the horn fuse which is hot all the time, and from the turn signal fuse which is hot when the key switch is on. The turn signal switch gets power from the hazard switch and both use the same flasher.
So if the turn signals work but the hazard switch does not power the lights, and both fuses have power, I would say the problem is inside the hazard switch.

Feb 19, 2013 | Cars & Trucks

2 Answers

Chrysler 300M turn signals and flashers don't work


The Combination Flasher, also refered to as the combo-flasher, is mounted to the in-line bracket which is located to the right of the Junction Block. The Junction Block (JB) is located in the left endcap of the instrument panel. REMOVAL Open hood and disconnect the negative battery cable remote terminal from the remote battery post. Remove the left instrument panel silencer. Refer to Body Instrument Panel Silencer, REMOVAL. The flasher can be removed by pulling in a rearward direction. INSTALLATION Install the flasher by firmly pushing it into place. Install the left instrument panel silencer. Refer to Instrument Panel Silencer, INSTALLATION. Connect the negative battery cable remote terminal to the remote battery post.

Aug 06, 2012 | 2002 Chrysler 300M

1 Answer

Turn signals don't work


near your fuses, in the fuse panel you will find a silver/grey colored, often round thing, this is called a "flasher" this is probably your problem, replace the "flasher"

Jul 13, 2012 | 1990 Dodge Ram

1 Answer

Brake lights and turn signal don't work???


turn on the emergency flashers(e-flashers)if they work check the bulbs at the same time.if this is good then check the fuses.you may have a problem with the turn signal flasher needing replacing.this is a different flasher than that of the e-flasher,looks the same but a different flasher.usually located on or around the fuse panel under the dash.the brake light problem could be a misadjusted switch or a bad switch.the switch is at the base of the brake pedal and has two wires to it.one wire will have power all the time and the other wire will only have power on it when the brake pedal is pushed.if not then the switch will need replacing.check for broken wires at the switch as these sometimes break causing a problem.

Feb 08, 2012 | 1996 Pontiac Sunfire

1 Answer

My turning signal don't work but the flashers do work. I have changed all fuses and they still don't work.


since you know where the fuses are, you also know where the flashers are. the flashers are the same part so unplug the one for the emergency flasher and put it into the socket for the turn signals and vice versa. if the signals now work but not the emergency flasher you know to get a new flasher unit at any parts store. the flasher units are cubes about an inch on each side plugged into the fuse panel.

Jun 27, 2011 | 1995 Chevrolet Caprice Classic

1 Answer

1997 Chevy Tahoe both turn signals stopped working


Sounds like the flasher unit to me. Normally the emergency flasher and turn signal are separate.

Jul 21, 2009 | 2001 Chevrolet Tahoe

Not finding what you are looking for?
2002 Mitsubishi Lancer Logo

293 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...