Question about 1992 Ford Taurus

Open Question

Loud clunking noise back rear tire

There is a slight vibration it gets worse with higher speeds

Posted by on

  • sillychic65
    sillychic65 Nov 25, 2012

    Put new tire on and the clunking didn't go away and the clunking goes away when I push on my breaks.

  • Anonymous Nov 25, 2012

    Might consider taking the brakes apart & doing what is necessary to correct the issue. How did that get by you? Keek waiting on things you will eventually damage your car or have a big bill

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 196 Answers

SOURCE: ABS Light Came on and Loud Whining in Rear End?

Well you can remove the sensor in the diff and make sure that looks ok they g obad quiet often also woulnd not hurt too remove the rear diff cover and inspect the rear end if it is whining and you dont see anything wrong i would refill it with lucas oil/grease and start praying check the pinion too and see if it has any play in it

Posted on Jan 18, 2009

Ad
  • 112 Answers

SOURCE: Van rumbles and vibrates

Does this van have a carrier bearing in the center of the driveshaft? If it does this could be your culprit,you can tell if it has a carrier bearing by looking at the drive shaft in the middle it will around the driveshaft and bolted to floor support of the van.

Posted on Mar 29, 2009

Molson02536
  • 3854 Answers

SOURCE: unbearable humming vibration in rear of car

It sounds like one of your rear wheel bearing hub has gone bad and needs to be replaced before you lose your wheel. I am thinking to pay attention to the right rear wheel hub bearing than needs to be replaced, they go for around $170.00 at Auto Zone and they can give you the step by step instructions to get the job done with common tools or you can use there loner program if you need to borrow a tool you may not have. With the car parked walk to the rear wheels and push and pull on the top of the tire (Side to side), feel and listen for any play. You should not hear or feel any play at all unless the wheel hub has gone bad. It take less then 1-1/2 hour to change the wheel hub and less if your good with tools. Good luck and keep me posted friend. Be safe.

Posted on Jul 06, 2009

  • 114 Answers

SOURCE: My front end makes a loud humming noise.

Alignment will not create a sound by it's self. The most common cause of humming (especially if you have an agressive tread design)is a wear pattern in the tires...check for that or rotate the tires around & see if the noise changes. If it does then you know it's in the tires. & Not always, but most of the time a bearing noise will increase or decrease in intensity if you load up one side at a time by doing 35-50 mph & turning slightly to each side.

Posted on Sep 30, 2009

  • 85 Answers

SOURCE: LOUD CLUNKING NOISE IN REAR WHEEL AREA WHEN TURNING LEFT

sounds like either a sway bar end link or shock, more towards the end link tho

Posted on Feb 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

REAR passenger tire makes loud clunking and grinding noises when turning more than 30-45 degrees above 5-15 mph


I don`t think you have cv axles in the rear of that.My guess would be wheel bearings could be grinding. Donut spares are strickly to be used for short periods of time and not to be driven at any higher rates of speed. Some damage may have occurred during the actual incident when you had the flat initially.Damage to the rear axle itself,

Oct 12, 2012 | 1996 Dodge Caravan

1 Answer

Vibration on 2004 Cadillac Deville


If a hub bearing was bad, it almost always would make noise, more so when changing lanes at higher speed. Outer CV joints make a loud low pitched rattle when turning (corners). Inner CV joints raise hell at high speed- bad shake! Sway links affect cornering and clunk when hitting rough patches of road surface.
Is the vibration worse at 65 than at 50? If so, you are dealing with a wheel balance situation. Find an old time front end shop that will check the balance on the vehicle. You will have to turn off the traction control to do this or use an on-the-car wheel balancer.
If you feel it at some low speeds at it comes back at other higher speeds, then you are dealing with tire roundness. Possible more than 1. More common than we would like.

Jul 17, 2017 | 2004 Cadillac Deville

2 Answers

Vibration at highway speeds loud humming noise,


Possibly a wheel bearing issue, does it `get progressively worse as speed increases or better as it decreases? does it stop when applying the brakes or get worse?

Oct 30, 2011 | 2006 Ford Escape

1 Answer

2000 Honda Accord - very loud road noise


caster,camber and, wheel bearings
have your car 4 wheel aligned this will adjust your rear caster and, camber.
have your wheel bearings checked

Sep 06, 2009 | 2006 Toyota Camry

1 Answer

Bmw e46 loud vibration noise from front wheel


usually noise complaint can be pretty tricky to repair. especially if its intermittent. since you say it only when its cold my first guess would have to be a wheel bearing. some other things you can check is how the tires are wearing. when you rub your hand along the tread is it smooth or does the tread catch your hand. if your tires aren't wearing smooth noise complaints can be heard while slightly turning, braking, or even accelerating.also if its a wheel bearing you can lift the vehicle up in the rear (turn off your dsc) and run the rear tires up to speed. usually you can hear a loud wheel bearing. also you can drive the vehicle and swerve back and forth and see if the nosie changes. depending on which side of the vehicle suspension is being loaded

May 03, 2009 | BMW 3 Series Cars & Trucks

1 Answer

Acura Integra '92 loud clunking when accelerating


you can check the wheels make sure there on tight and make sure you tie rods and wheel bearings are good

Dec 30, 2008 | 1992 Acura Integra Hatchback

Not finding what you are looking for?
1992 Ford Taurus Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85160 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

gerry bissi

Level 3 Expert

4387 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...