Question about Chevrolet Impala

3 Answers

Reset my engine oil low in 2007 chevy impala

I just got my car and it says change engine oil soon and it says engine oil low. I want to reset my engine oil low because i have already changed and filled the oil. How should i reset the engine oil low sensor. i have a 2007 chevy impala.

Posted by on

  • 3 more comments 
  • Anonymous Apr 29, 2009

    Well I have tried that and it still did not work. Everytime I turn on the car it says it then i have to run through the options to move it from the dash. It gets tiresome. So does anyone else have a solution?

  • Anonymous Mar 17, 2014

    My 2003 chevy impala keep cutting off and runs sluggish could it be low oil pressure

  • Anonymous Mar 27, 2014

    I have changed the sensor that is on the driver side that screws into the engine block. Now engine is hot light still comes on. ?

  • Anonymous Mar 31, 2014

    What do it means when your thermostat hand goes to over heating car stalls change engine oil soon lights come on This is on a 2008 Chevrolet impala

  • Anonymous Mar 31, 2014

    What do it means when your thermostat hand goes to over heating car stalls change engine oil soon lights come on This is on a 2008 Chevrolet impala

×

Ad

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 204 Answers

It will say in your owners manual but i believe you turn your ignition key to the run position not the start. and pump the gas pedal 3 times with in 5 seconds

Posted on Apr 14, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

You sould be able to reset that from the dash ,these options beside the dash go to the end and when you get to oil and % press on the checkmark and that would do the trick.

Posted on Jul 18, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

Yes that is correct i own a 06 turn the key to run (Without Starting) And pump the gas petal 3 times and it should clear it

Posted on Sep 23, 2015

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2007 chevy cobalt the oil was just change and is now telling me to get oil changed soon


Sometimes they just fail to reset properly. Nothing to worry about. The youtube video shows the procedure to reset for a Chevy Truck, should be the same for your Chevy car.

Here's a website with explanation.
https://www.quora.com/What-does-it-mean-if-the-change-oil-light-is-lit-after-an-oil-change

Nov 17, 2016 | Cars & Trucks

7 Answers

How do I rest oil change light on a 2001 1500 silveradeo?


Place a piece of black electrical tape over it ,problem solved .you know the oil is good

Oct 10, 2014 | 2001 Chevrolet Silverado 1500

2 Answers

How to do I reset the maintenance service light on my 2007 Chevy Trail Blazer


there is no light for emissions testing on this vehicle. there is a ses light that can come on, indicationg a problem with the engine or transmission electronic system. this will require a scan tool to pull trouble codes. there is another light called oil life monitoring that needs to be reset after oil changes, which I suspect is what you are seeing. here is a picture of the light and the instructions for resetting.,

The Engine Oil Life System calculates when to change your engine oil and filter based on vehicle use. Anytime your oil is changed, reset the system so it can calculate when the next oil change is required. If a situation occurs where you change your oil prior to a CHANGE OIL SOON message being turned on, reset the system.
After changing the engine oil, the system must be reset as follows:
  1. Turn the ignition to RUN, with the engine OFF.
  2. Press the information and reset buttons on the Driver Information Center (DIC) at the same time to enter the personalization menu.
  3. Press the information button to scroll through the available personalization menu modes until the DIC display shows OIL LIFE RESET.
  4. Press and hold the reset button until the DIC display shows ACKNOWLEDGED. This will tell you the system has been reset.
  5. Turn the key to LOCK.
If the CHANGE ENGINE OIL message comes back on when you start the vehicle, the Engine Oil Life System has not reset. Repeat the reset procedure.



485d3b2.gif

Sep 09, 2010 | 2007 Chevrolet TrailBlazer SS

1 Answer

A 2003 Chevy Impala with low tire pressue signal on


On a Chevy Impala or Monte Carlo with indirect TPMS, a totally different reset procedure is required. You can use the light switch or radio to reset the system. With the light switch procedure, turn the ignition on (engine off), the turn the light switch from OFF to parking lamps three times within five seconds. With the radio technique, turn the ignition on (engine off). With the radio off, hold the DISP button until “SETTINGS” is displayed. Use the SEEK button to scroll down the menu until you see “TIRE MON.” Press the PREV or NEXT buttons until “RESET” is displayed. Then press the DISP button again. You should hear a chime and see “DONE” to indicate the TPMS system has been successfully reset. Use the SEEK button to scroll through the menu until “DONE” is shown, then press DISP once more to exit from the learn mode.
Thank you for using fixya and good luck

May 09, 2010 | 2003 Chevrolet Impala

3 Answers

How to reset the low tire pressure light in dashboad on a 2004 chevy impala


There should be a reset button in the fuse pannel. It can be used to reset the low tire pressure light , and the change oil light.
Instructions should be in owners manual , or you can google it.
Chevy dealership should do it for free in my opinion.

Feb 28, 2010 | 2004 Chevrolet Impala

1 Answer

How do i reset the change engine oil soon on my 2004 impala


Depress the accelerator pedal to the floor 3 times within 5 seconds.This is with the key on and engine not running.Hope this helps.Good luck.

Feb 25, 2010 | 2004 Chevrolet Impala

1 Answer

I have a 2008 Chevy Impala and I just had an oil change done about 3 weeks ago. Just recently the warning light turned on saying "please change oil engine soon? I checked the oil and it is still full with...


YOU HAVE TO RESET OIL LIGHT.ITS DISPLAYED ON THE DRIVER SIDE INFORMATION CENTER.IT A CHECK MARK LOOKING SYMBOL..YOU PRESS HOLD RESET BUTTON FOR 5 SECONDS.

Jan 23, 2010 | 2008 Chevrolet Impala

1 Answer

How do i reset the oil change light?


turn the key to the run position as soon as it is there hit the gass pedel three times with in 3 sec and it will reset.

Nov 19, 2009 | 2004 Chevrolet Impala

2 Answers

Change oil soon how do you shut it off after youve changed the oil


turn ignition on with engine off press gas pedal to floor 3 times & light will flash then go out.
or if you have menu button on radio press button until reset oil life appears ten press enter

Jul 11, 2009 | 2009 Chevrolet Impala

1 Answer

Reset message center window


THIS SHOULD HELP YOU

Turn the ignition to ON without starting the engine. Fully press and release the accelerator pedal three times within five seconds. If the CHG OIL SOON light flashes two times, the system is resetting. Turn the key to OFF, then start the vehicle. If the CHG OIL SOON light comes back on, the system has not reset, repeat the procedure. Follow this procedure to reset the GM Oil Life System using the DE 100 Series Radio®. Turn the ignition to ACC or ON and the radio off. Press and hold the DISP button on the radio for at least five seconds until SETTINGS is displayed. Press the SEEK up or down arrow to scroll through the main menu. Scroll until OIL LIFE appears on the display. Press the PREV or NEXT button to enter the submenu. RESET will be displayed. Press the DISP button to reset. A chime will be heard to verify the new setting and DONE will be displayed for one second. Once the message has been reset, scroll until EXIT appears on the display. Press the DISP button to exit programming. A chime will be heard to verify the exit.

Jul 02, 2009 | 2004 Chevrolet Impala

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

2,484 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...