Question about 1993 Buick Park Avenue
How do you adj. drvrs. seat up or down on 2000 buick ave park ave ultra
Should have buttons on your armrest or down on the side of the seat by the drivers door if not check in front of the seat
Posted on Nov 26, 2013
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Chances are one of the motors has gone out. There are 3 motors for each of your power seats. One controls the forward/backward motion, one controls up/down/tilt, and the third controls the reclining seat back. In my '95 model, there is one fuse for the seats under the driver's side dashboard. There should be a diagram inside the fuse panel cover denoting which one controls the seats. Hope that helps!
Posted on May 08, 2009
Firt - study & write down (draw) the belt path,,
and be sure about it..
Then - put a wrench on the nut in the center of the tension pully.. Move the tension pully to loosen the belt.. Pull belt off..
Repeat to put new one on..
Should be pretty easy..
Posted on Jul 09, 2009
Yes. Put a jack under the motor and remove 3 bolts from side of engine and the long center pivot bolt in mount and the 2 bolts that go top down into the frame and loosen the 2 bolts below mount. Jack up the motor until you can separate the mount, leaving the engine side in and removing the frame side. The engine side can be moved out of the way without completely removing.
Posted on Aug 08, 2009
Testimonial: "answered the question completely and thoroughly!"
The code PO742 indicates the torque converter clutch is stuck on.
The torque converter is what connects the engine to the transmission.
It engages and disengages according to signals from the pcm, to aid in
smooth shifting. There are a couple of things you can try. make sure trans. fluid is full, if thats ok check the 20 pin connector, located on left
side of car on top of transmission bell housing. Make sure there's no
corrosion or bent pins. If this clears the code your all set, if not you may
want to ask your mechanic and see what he/she recomends.
Hope this helps.
Posted on Jan 19, 2010
Tips for a great answer:
Sep 21, 2018 | Buick Cars & Trucks
Jun 21, 2014 | 1997 Buick Park Avenue
Apr 12, 2013 | 1998 Buick Park Avenue
Nov 05, 2012 | 2000 Buick Park Avenue
Jun 01, 2012 | 2000 Buick Park Avenue
Nov 11, 2011 | 2000 Buick Park Avenue
Aug 13, 2009 | 2000 Buick Park Avenue
Jul 09, 2009 | 2000 Buick Park Avenue
Apr 26, 2009 | 1996 Buick Park Avenue
Dec 02, 2008 | Buick Regal Cars & Trucks
Jun 30, 2014 | 1993 Buick Park Avenue
326 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: