Question about 2002 Mitsubishi Lancer
Drivers side door lock will not lock the car with the key or from the inside of car either. Also NONE of the windows go down or up with ANY of the window buttons.(right now windows are up& will not go down) I can lock the car from the passengers side door though.I had the car checked out & i was told the fuses & relay switch were working fine. That it was the circuit board in drivers side door window controller. I bought a used one & tried putting it on & it also did not work. I was told it could possibly be the wire harness that connects to the circuit board. Could this be it & how would i go about fixing this in an affordable manor?? Please help me!
Posted by Anonymous on
Posted on Feb 07, 2019
does the master switch have a other door lock button
so central locking and windows dont work as they should
driver side window motor faulty
individual door lock actuator motors not getting power
it is possible the central locking module wont work unless reset to the other cars electronics with the correct scanner
Posted on Apr 05, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
I had the same problem with my driver side window, so I just replaced the power window motor. It took less than an hour, cost about $35 or $40 and it works perfectly now.
Posted on Aug 17, 2008
the switches need cleaning ,they have contacts in them that get dirty you can spray contact cleaner on them or use emery paper to file them, they are not to hard to pull apart
Posted on Jan 16, 2009
You'll need to replace the solenoid (motor) that doesn't work. Not hard once you get the door panel off. I suggest you buy the correct part, not a universal one.
Posted on Jul 14, 2009
Check your fuses first. Then check for power at the switches, and power from the switches to the respective solenoid and motor. Most likely it's fuses. Also check where the wiring runs through the door into the car for bare spots in the wiring that might have blown the fuses.
Posted on Jan 21, 2010
Tips for a great answer:
Jul 11, 2016 | Cars & Trucks
Mar 06, 2016 | 2007 Opel Corsa Utility
Jan 27, 2016 | Cars & Trucks
Feb 11, 2011 | 1995 Toyota Camry
Nov 26, 2017 | 2001 Volkswagen Cabrio
Jun 05, 2009 | 2001 Jeep Grand Cherokee
Aug 07, 2008 | 1997 Volkswagen Jetta
Aug 02, 2008 | 2000 Dodge Durango
87 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: