Question about Cars & Trucks

1 Answer

Vs stateman v8 oilpressure light comes on wen it warns up motor seems to be getting hot an it runs rough an stalls if I leave it running

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 5,440 Answers

Engine heat may be thinning oil enough to drop pressure. Fix overheating first. Thermostat, bad cat converter or muffler, bad water pump, etc.

Posted on Jan 29, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 90 Answers

SOURCE: 2002 Toyota Tundra Stalls

The throttle body needs cleaning. It has some carbon build up, and when the battery went dead the computer lost its learned values, one of which is base throttle position. Now its reset back to factory specs, not accounting for a dirty throttle body. Seen it a million times

Posted on Jan 26, 2009

  • 2 Answers

SOURCE: Motor Control System Failure

Motor control system failure means either 2 things
1 A fault with the ecu
2 A fault with the exhaust and lambda sensors

http://forum.alfa156.net/forum/forum_posts.asp?TID=9754&PN=1

Posted on Jan 02, 2010

  • 2926 Answers

SOURCE: 96 Jeep w/5.2L V8 runs very rough and stalls

If you smell fuel, Try locating the source. It may be a fuel line leak if the smell is that strong. You may be loosing fuel preasure to the injectors if a leak is occuring. Always start with the basics along with visual over sight before repairs.

Posted on Jan 16, 2010

  • 3 Answers

SOURCE: my 2000 bonneville 3.8 v6 SE bogs, chugs, sputters

Faulty coolant system gaskets are allowing coolant into the block. You will notice a sticky sweet smell as it is running rough. You will need to replace all the gaskets (2 gaskets and one "elbow") from the coolant system to the engine. Not fixing this problem can cause a cracked head gasket. Check the area to the passenger side of the engine near the coolant tank, you will see a bolt on the block itself with an exposed nut. If this area is greasy, wet or otherwise corroded your system is leaking into the block.

Posted on Dec 13, 2010

  • 577 Answers

SOURCE: car runs but it will itermitently stall and coast to a stop runs very rough at an idle with both wrench and check egine lights on code comes up P2112 and P2112p. on a 2008 ford focus

Throttle actuator system stuck closed. Throttle body valve stuck/tight

Posted on Oct 03, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can i fix my 2003 holden barina `eps warning light from coming on


It'll pay to have the crank sensor checked. They're known for heating up and stalling the car when they're no longer any good. Usually once it has cooled down the car will start but as soon as the sensor gets hot it'll stall again

Aug 28, 2016 | Holden Cars & Trucks

2 Answers

89 ford probe hesitates when leaving a red light, then runs fine otherwise, fuel filter?


Engine Runs Rough, Stalls, Hesitates on Acceleration, Hard ...

repairpal.com > Problems > Ford > Probe
Ford Probe Engine Runs Rough, Stalls, Hesitates on Acceleration, Hard Starting, Poor Performance. This is a verified problem based on 9 reports. Learn more ...

Starting Problems - 1997 Ford Probe - RepairPal

repairpal.com > Questions > Ford > Probe > 1997 Ford Probe
Dec 5, 2010 - Starting Problems on 1997 Ford Probe ... If the engine runs rough,stalls, hesitates on acceleration, is hard to start, or has generally poor ...

A new misfire/hesitation on accel. Problem.. - ProbeTalk.com Forums

forums.probetalk.com > Tech Section > 2nd Gen (93-97) V6 2.5L

Feb 05, 2016 | Ford Cars & Trucks

1 Answer

Stalling when turn back on


all stalls end in CEL check engine light on. that is normal
but CEL glow. when engine running , means you had a failure, and it stored DTC error codes, so scan it.
lots of causes. huge list.
get a tune up , tops list.

SCAN it to be sure all sensors work. running.
all fuses in car good.
by stalls , i assume the engine stalls and engine RPM is 0 RPM.
the stall cause the whole dash to light up, all the warning lamps come
on (self test) oil , charge , CEL. come on.
what is important is the stall and the cause.

i will tell you the 3 ways.
lost electrical power to engine EFI system (seems not)
bad engine, (lost compression hot)?
bad spark , spark died.?
bad fueling, lost all fueling (starves and stalls or floods and misfires horribly and stalls (black spark plug tips are big time clue)

if non eof the rings a bell.?
get the car serviced.

this car is newer nicer car, you (we) can scan and drive and log data.
allowing faster easy diagnosis.

Mar 12, 2014 | 2004 Jeep Liberty

1 Answer

2004 chevy silverado 5.3L V8 runs rough and stalls


Well, code 336 is for a problem with the crank sensor, and code 171 is for fuel system too lean bank one which is the side with cylinder one. Since you have checked fuel pressure and I will assume fuel volume is good, the crank sensor or circuit could be at fault.

Jul 09, 2013 | Cars & Trucks

3 Answers

Rough Idle when cold runs seems to run ok hot but still almost stalls when you turn on AC and you are at a stop also noticed that the volt meter reads 9v with the AC and the lights on with the AC and...


mcdevito75 here, Sounds like a faulty voltage regulator, it"s 1 unit with the alternator, change the alternator, also the alt. supplies juice to the ignition switch, distributor abd plugs, thus a rough idle due to bad alternator.

Jun 19, 2010 | 1994 GMC Suburban

2 Answers

96 Jeep w/5.2L V8 runs very rough and stalls


Have you done the cycle key test to see if any trouble codes come up ? Turn key to on (not start) then off, then on, then off, then on, and leave in on position. Have a pen and paper ready to retrieve code numbers. "Check engine" light will flash . You'll get a number of flashes if any codes, and a pause in between each number. For example: flash,flash,pause,flash,flash will be code 22.
3 flashes, pause , then 3 more flashes, is code 33 etc. It will always be 2 digit number, with a pause in between. When you get 5 flashes,pause and 5 more, that is code 55 which means end of message.(or end of codes). Get back to me with those codes and lets go from there, as it will make it much easier to pinpoint problem, if codes are there, and much cheaper and quicker in long run.

Jan 16, 2010 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Check engine light is on, motor runs rough, sometimes stalls


Go to Advance or Auto Zone and have them run an obd scan on it and it will pin point why your light is on and could solve your problem. This is often done for free.

Apr 12, 2009 | 1998 Chevrolet Tahoe

1 Answer

RUNS ROUGH STALLS CHECK ENG LIGHT ON


The plug is located at the bottom of the steering column.The fault seems to be the mass air meter though.

Nov 26, 2008 | 1994 Volkswagen Golf

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

22406 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...