Question about 2003 Mitsubishi Lancer
Starts when cold, after running for sometime if I stop it wont re starts. it starts for 2 seconds and dies off
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
ok here we go and you aren't going to believe it...
I replaced the thermostat step one
I noticed that I had a small leak at the engine side of upper hose fixed that by taking it off and cleaning it and putting the hose back on Step two
then while refilling the reservoir with coolant i found that the hose that was supposed to be in the fluid was curled up on top and not sticking down in the fluid where it should be.
played with the hose until i got it to fall down in the reservoir where it should be Step 3
I started the car with the radiator cap off and let it run until it got to normal operating temp. and keep filling the radiator with fluid until the level stayed constant. Then put the cap back on and test drove. Everything worked fine haven't had that much heat in awhile and it kept blowing hot even when i stopped and let it idle for ten min.during test drive. Checked reservoir when I got home and had to add a small amount of coolant but not much.
I really think that the hose in the reservoir not being in the right place and pulling air into the system instead of coolant is the real culprit of this drama, but i replaced the thermostat to be safe.
Posted on Feb 21, 2009
The cable that pulls the cool/heat switch on the a/c gets weak and it doesnt allow the dial to switch over to heat. You can see that cable and the way its supposed to work on the right side of the gas pedal over it. I usually just use my foot to push that switch over to heat and reach with and pull on it with my right hand to cool.
Posted on Jan 22, 2010
Posted on Mar 06, 2010
Testimonial: "It's the fuel pump indeed. Also the gas tank found to be very dirty. The fuel pump was replaced, fuel system cleaned, now the car runs perfectly."
Sorry for the delay. I am personally going back to answer your unanswered question.
I do not know if you still need the answer, but I am going to answer it in case you still do.
Click on the following direct Link. It has the Timing Belt Diagrams with Marks for the Camshaft and Crankshaft that you will need.
Again my apologies...
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!
Posted on Mar 22, 2010
very poss it could be crank sensor ,broken wire ? timing belt? advise installing scan tool that reads live data check eng rpm on scan tool see if shows eng rpm while cranking , poss remove upper timing belt cover make sure is turning and not damaged, poss computer related problem or power to eng systems would have to check for power at fuel injs and check for ground pulse with logic probe or led test light if crank sensor ok also check for spark at plugs with special plug tester and check codes first
Posted on Sep 21, 2010
Tips for a great answer:
Sep 23, 2013 | 2005 Mitsubishi Lancer Cedia
Nov 26, 2012 | 2003 Mitsubishi Lancer
Apr 19, 2011 | 2003 Mitsubishi Lancer
Nov 04, 2010 | 2005 Mitsubishi Lancer
Dec 07, 2009 | 2003 Mitsubishi Lancer
Oct 26, 2009 | 2003 Mitsubishi Lancer
Jun 07, 2009 | 2003 Mitsubishi Lancer
113 people viewed this question
Usually answered in minutes!