Question about 2002 Oldsmobile Silhouette
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: radio wiring color codes
u need the colors of the radio or the car wires.... here are the car wires and the radio are below that. I suggest however gettiing a wiring kit..They are around 8 dollars and well worth the money. It makes is so easy to connect a radio.
RADIO 12V|orange + at radio
RADIO GROUND Black
RADIO SWITCH yellow
POWER ANTENNA dk. green at radio LF SPEAKER tan - gray at radio or LF speaker
RF SPEAKER lt. grn - dk. grn at radio or RF speaker LR SPEAKER brown - yellow at radio or LR speaker
RR SPEAKER dk. blu - lt. blu at radio or RR speaker
constant power yellow
switched power red
power antenna/amp turn on blue
illumination is orange
all speakers the one with the black stripe is the negative connection.
right rear is purple
left rear is green
left front is white
right front is grey
hope that helps ya...
Posted on Sep 02, 2008
The first thing i would check is all 4 abs sensors at the wheels.You can do this with a volt meter set on ac voltage and spin the wheel if it generates voltage at all on the meter its good.
Posted on Mar 06, 2009
This is basicly a very time consuming job rather than a physically hard one to complete. In order to replace the gasket you must remove the intake plenum,throttle body, and misc. vacuum hoses. The wiring harness connections must also be disconnected. Finally the intake manifold is exposed. The bolts holding the manifold to the block are removed exposing the leaking gasket. After removing the push rods and placing them in the correct order to be replaced the gasket and sealants can be removed. Finally replace everything in reverse order. Be sure to consult a GM manual for correct bolt torch specs. The correct specs for the manifold bolts usually come with the gasket. Make sure to change your oil a few times after this job in case any coolant entered the block. Also,change the thermostat and the oil seal on the distributor half shaft cap while you have everything off. Good Luck
Posted on May 12, 2009
Before you go changing out the starter check for a burnt out fusible link going to the starter it will look like a wire but acts as a fuse and they burn in two just like a fuse. The symptoms you just describe are those of a burnt fusible link.
Posted on Mar 26, 2010
Tips for a great answer:
Nov 17, 2016 | 2002 Oldsmobile Silhouette
Mar 21, 2015 | 2003 Oldsmobile Silhouette
Dec 08, 2013 | 2002 Oldsmobile Silhouette
May 01, 2012 | 2002 Oldsmobile Silhouette
Feb 27, 2012 | 2000 Oldsmobile Silhouette
Sep 10, 2010 | 2002 Oldsmobile Silhouette
Jul 06, 2010 | 2003 Oldsmobile Silhouette
Mar 09, 2016 | 2002 Oldsmobile Silhouette
37 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: