Question about Volkswagen Polo
Just because a part is new does not mean it is good, or even the correct part. Double check and test part with multimeter for short circuit.
Posted on Apr 02, 2018
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: camshaft sensor
Do you know if the engine timing is correct? If you get the timing a tooth out you very similar issues, has the cambelt been replaced recently - or is it over due??
Another posibility is the cam chain adjuster. This is oil pressure fed and I think controled by a solnoid, it applies a force between the chain that drives the inlet camshaft from the cambelt driven exhaust camshaft. (Making any sense? Let me know if you want me to simplify) This operating correctly advances and retards the valve timing, when faulty it can make it incorrect. Non start is a fault caused, but more often they become very noisey.
The cam chain adjuster is fed oil when the car is started, you can breifly here it before it has reached operating pressure on normal start up, sounds like a diesel knock for a second, then goes, this is normal. If it continues, its more than likely faulty.
Let me know if you want any more info. If the sensor and wiring is good you'll probably have a timing issue.
Posted on Mar 25, 2009
an approved/competent peugeot dealer with peugeot diagnostic equipment can connect it to your vehicle and check the signals from the camshaft and crankshaft sensors. there shouldn't be any doubt about it. the engine control unit(ecu) needs both sensor readings(to identify which cylinder to inject fuel into)before it can start. a new cam sensor has a plastic nipple which should be in contact with the target plate when first fitted, this brakes off when the engine is started. it is used to ensure the correct gap between sensor and target plate. to large a gap and the sensor may not work correctly. once engine is started this info' is ignored by the ecu. the fuel pressure(measured by another sensor) can also be checked and is displayed on the equipment in "bars". 250bars of pressure are needed for engine to start. one of these (cam, crank, or fuel pressure signals) must be wrong if engine is not starting(assuming uncontaminated fuel). which one determines diagnostic path to be followed.
Posted on Mar 05, 2010
Check fuses under the hood. When the crankshaft sensor shorts, it often blows this fuse. It is a 10 amp fuse. I don't remember what number it is off hand but it will be efi related.
Posted on Feb 18, 2011
Tips for a great answer:
Apr 19, 2018 | Cars & Trucks
Feb 17, 2014 | Cars & Trucks
Dec 23, 2013 | 2001 Volkswagen Golf
Aug 07, 2012 | Cars & Trucks
Nov 30, 2011 | Volkswagen Golf Cars & Trucks
Apr 17, 2010 | 2002 Audi A6
Jan 17, 2009 | 2000 Volkswagen Jetta TDI
Sep 13, 2019 | 2003 Volkswagen Passat
34 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: