Question about Peugeot 206

1 Answer

Peugeot 206 engine vibrating, misfiring, erratic revs fault code p0563

Just bought car, serviced 10,000ks ago, was running good for a few days, then battery died I replaced it and now my dash cuts in and out and engine vibrates worse. Spark plugs all seem ok and fuses are good too.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Peugeot Master
  • 1,417 Answers

Did you get the car plugged into a diagnostic reader after the battery change?
Some newer car ECU's need to be reset to 'new battery' settings. Over time the system alters the battery charge rate as the battery gets older and weaker so a new battery will overcharge if not reset..
The error code, (P0563), reads as "system voltage high".
Get the car plugged into a good diagnostic system and that will allow you to correct the error code and battery settings.
The other symptoms may settle down once the error code is sorted out.

Posted on Apr 14, 2018

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Engine vibrates, shakes car at 1700 rpm, smooth at 2000 rpm

Something similar happened to my van, and it ended up being that I needed to replace a tie rod in one of my wheels. Hope this helps! I know this was posted awhile ago.

Posted on Dec 28, 2008

TLRogue
  • 99 Answers

SOURCE: peugeot 206 2001 petrol intermitant fault with starter motor

If the starter motor is sticking, it can draw a large current. If there is power down to the starter motor while its not starting then the starter is faulty. You can test this with a multimeter or just a test bulb connected to the smaller of the two wires on the starter, while cranking.Check you have a good earth from the battery to the engine. If the bulb lights up but no engine cranking then its a faulty starter.

TL

Posted on Jan 24, 2009

  • 1 Answer

SOURCE: 2003 saab 95 Aero - stalled...can't get it started

Fixed it myself. I checked power and ground on fuel pump, then w/rubber mallet I banged the fuel tank and the fuel pump went on for a few seconds while someone cranked car, it started for arou 20 -30 seconds. This helped me diagn. the problem and I put in a new fuel assembly.\

Cfirms

Posted on Mar 25, 2009

  • 17 Answers

SOURCE: peugeot 206 1.4lx misfiring engine light flashing

Probably a defect lambdasonde or inlet pressure sensor (MAP sensor) it will show many different errors on the test readout ex: inlet manifold pressure, knock sensor, lambda value wrong, idle speed out of range, etc.
read out the faults,after delete the readout, then drive one day, read faults out again , compare the results, and change the components from test

Posted on Nov 05, 2009

emissionwiz
  • 85178 Answers

SOURCE: 2001 ford taurus 3.0 v6 code p0306 misfire

Please go to this page for engine misfire causes.

Posted on Aug 08, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Peugeot 206 14i lx 2002 petrol erratic(mostly low revs) idling and lost of power sound like blown exhaust almost cuts out with foot off accel, oil on one spark plug no smoke white or blue


Carry out a compression check on all cylinders to see if thats shows a fault. If its nil or low, check valve clearances and then head gasket.

Jan 01, 2017 | Peugeot 206 Cars & Trucks

1 Answer

Hi I have a peugeot 206 1.1 2004


you need to read the engine management light when its lit up on dash that will then give you the error code to the problem.

Aug 27, 2016 | 2004 Peugeot 206

1 Answer

My peugeot 206 model doesn't have revs whats the problem?


could be in limp mode
run the fault codes to see what is reported

May 07, 2016 | 2005 Peugeot 206 1.4

1 Answer

Misfiring


code p0303 refers to cyl 3 misfire detected ===causes engine mechanical fault--wiring--ignition/fuel system--injector--ECT/MAF sensor--ECM
code p0316 refers to misfire detected during start up --first 1000 revs===causes --engine mechanical fault--wiring--ignition/furl system--injector
the common fault cause is ignition/ fuel system and injectors so I would be checking fuel pressure and injector systems for clean and wiring connections are good especially on no 3 injector.

Apr 19, 2014 | Mazda 626 Cars & Trucks

1 Answer

Multiple cylinder misfire


Trouble Code: P0300

Multiple Cylinder Misfire Detected

Possible Causes:


Air leak in the intake manifold, or in the EGR or EVAP system.Base engine mechanical fault that affects two or more cylinders.Erratic or interrupted CKP or CMP Sensor signals.Fuel delivery component fault that affects two or more cylinders. (i.e., a contaminated, dirty or sticking fuel injector).Ignition system problem (coil or plug) in two or more cylinders.Vehicle driven with low fuel pressure or while very low on fuel.

Jan 11, 2013 | 2003 Dodge Stratus

1 Answer

Engine runs in idle +/- 2500 rpm


Without checking your car physically, its not possible to give you any idea what it could be or not

Dec 10, 2017 | 1999 Peugeot 206

2 Answers

Peugeot 206 1.4 hdi wont rev up sometimes it will and sometimes it wont


Is the check engine light on all the time or it is it off?

I know same problem happening in another Peugeot was told he has a tubro problem but his check engine light is on all the time but accidentally it goes off sometimes for few days.

Do you see alot of heat/air or smoke coming out when you open the oil chamber?

Probably oil leakage going to a sensor?

Anything to do with the pistons seals?

Jul 13, 2012 | Peugeot Cars & Trucks

2 Answers

Peugeot 206 1.4lx misfiring engine light flashing run fine for a few days then start problem again diagnostic showed too many faults to determine problem


i would reset the light and start over. it sounds like things were unplugged for testing purposes. dont let it intimedate you. let me know what else you find. you can e mail me at iambanshee74@yahoo.com

Nov 04, 2009 | 2005 Peugeot 405

4 Answers

Peugeot 206 1.4 HDI Power Loss


i have a 206 1.4 hdi 52 plate and the last couple of days it has started to loose pwer and the revs drop what could it be

Dec 15, 2008 | 1991 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Marvin
Marvin

Level 3 Expert

85178 Answers

scj103

Level 2 Expert

89 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...