Question about 2002 Mitsubishi Lancer
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
I had exactly same problem. I could not use my GPS or charge my cell phone.
In front of the driver sit, there are actually 2 fuse boxes. You probably found the first one. A second one is located above well hidden. Once you find it, you'll find the fuse you are looking for.
Posted on Mar 14, 2009
contrary to what the dealership tells you you don't have to take out the entire dash to fix the heater switch, all you have to do is first locate a heater switch which I thought was imposible to find too, but I found one online for 165 bucks from a used autoparts store, then all you do is take off the molding that surrounds your stereo, then take out your stereo, then you will see a blue cable on the right side and a black one on the left carefully disconnect those and the two wireing harnesses in the back the upper one is white the lower is black, then pull the unit out and put the other back in the same way, now it's still going to stick cause of those moron engineers so if you kneel on the ground and look next to your gas pedal you will see to pieces of white plastic that is why you can't switch to heat that flimsy cabel has to push that gear forward, that gear is sticky so it won't go forward, there is a replacement gear to fix that problem that should be about 18.00 from the dealership. it took me about an hour or less to do the whole operation. I just literally finished it 20 minutes ago in my wifes lancer which i broke that knob off of. Good luck if you havent figured it out yet.
Posted on Apr 22, 2009
SOURCE: Where is the starter located
I replaced the starter on my daughters 2002 lancer and did it the hard way by crawling under the car to figure out where it was first, and then working underneath to get it out. After performing the procedure I realized there is a much easier way to do it.
- The starter is located on the back side of the engine under the intake manifold towards the drivers side of center. It is very difficult to see from the top with everything still assembled.
Replacing the easy way:
1. Disconnect negative battery cable.
2. Remove the plastic air filter box first. After it is off you can easily see the starter down by the shifter linkage bracket.
3. Remove two bolds holding the shifter linkage bracket so it can be moved out of the way.
4. Remove wiring connectors from back of starter solenoid. One connector is just a slide on, the other main wire is held on by a metric nut. That one may look impossible to get at, but if you configure a 1/4 drive ratchet with the right sized deep well socket you have room to work it through a cut out in large mounting bracket that you will see below. I'm thinking the Japanese engineers put the cut out there for this purpose.
5. Remove two starter mounting bolts and allow the starter to slide down and back so as to rest on the bracket below.
6. Walk around to the passenger side of engine and reach down under intake manifold to pull starter up and out.
7. Reverse procedure to reassemble.
8. Done without ever crawling under the car!
Posted on Feb 11, 2011
Tips for a great answer:
Mar 20, 2016 | 2002 Mitsubishi Lancer
Jun 25, 2015 | 2002 Mitsubishi Lancer
Sep 17, 2011 | 2002 Mitsubishi Lancer
Apr 20, 2011 | 2008 Mitsubishi Lancer
Apr 04, 2010 | 2002 Mitsubishi Lancer
Nov 24, 2009 | 2003 Ford Explorer
Aug 12, 2009 | 2002 Nissan Maxima
45 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: