Question about 2012 Chevrolet Sonic

1 Answer

Chevrolet Sonic 2012 model.

ABS warning light comes on only when foot is on brake for a period of time and goes off when you let go and start driving. Engine warning light comes on and diagnostic indicate in led manifold pipe or sensor faulty/error

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 351 Answers

Take to dealer for dignosis, this might be a safety issue.

Posted on Oct 31, 2018

  • Riaan Janse van Rensburg

    Already taken car to dealer for diagnostics. Will maybe try different dealer.

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: My 2006 F150 abs light

It sounds like you might be having a problem with your Electronic control module. Are the only codes coming up just for the sensor? Have you recently cleaned your engine or driven in very wet weather? If so, water could have gotten into your connections at the modules and causing odd codes. I hope this helps. Jay

Posted on Apr 24, 2009

  • 119 Answers

SOURCE: The ABS,Brake Light,Battery light go on and off sporadically while driving.Does this indicate an Alternator failure or a sensor/computer problem?

yes it's most likely a alternator problem,usually the internal diode bridge breaks causing all lights you mentioned to come on,if this happens at a idle open the hood and remove green connector on alt.if lights go out you've found the problem

Posted on Jul 19, 2009

matney68
  • 426 Answers

SOURCE: ABS & Brake warning lights turn on

it is possible but its also possible you have a wheel speed sensor acting up. you would have to have it scanned for codes

Posted on Jul 30, 2009

  • 22408 Answers

SOURCE: ABS, traction control and hill descent warning

check abs sensors and controls for loose or damaged connections if none have vehicle scanned for fault or pending codes a part or sensor may be going bad at an auto store such as auto zone and advance auto do it for free

Posted on Oct 19, 2009

  • 1 Answer

SOURCE: Saab '02 9-3 "electrical"problem

Most likely it is the ABS module is going bad and needs to be replaced or rebuilt at www.bba-reman.com, hope this helps.

Posted on Jan 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause the Emergency Brake light to not go off when the emergency light is released? What causes the ABS warning light to come on?


When I had that problem with the emergency light it was the sensor for emergency brake
The abs and brakes sounds like you are loosing pressure in the system

Apr 18, 2015 | 2004 Toyota Prius

1 Answer

Start engin why abs and 4 wheel lights on and abs goes off and pull 4 wheel drive lever to get it off


the 4wd defeats/changes the ABS , just as the operators guide tells you.
i don't understand this post at all, my guess is you have the ABS warning stuck on, all the time. (forget 4wd)
right and dont know why, ?

  1. The brakes are bad. get a brake job or inspect them all.
  2. that includes all parts for damage and conditions, (ask or get it dont by any brake man... lots to do there.
  3. The ABS system is failing , scan it. SCAN THE ABS NOW.
  4. There is air in the system. and worse. up stream of ABS modulator
  5. and more per the FSM. no books?

here is the manual, read the brake pages, carefully and ask questions.

https://www.techauthority.com/en-US/Pages/FacetSearchResults.aspx?make=Jeep&year=2010&model=PATRIOT+4X4&engine=2.4L+4+CYL+DOHC+16V+DUAL+V.V.T.&producttype=Service+Manuals&ptCatId=3083


Aug 12, 2014 | 2010 Jeep Patriot Sport

1 Answer

Brake and abs light


Check to see if your emergency brake is partially on. Also the abs light goes on when the sensors on the hubs get corroded from salt. They either need to be cleaned or replaced. Mine are on from corrosion from road salt so rather than pay the hefty fee to fix the issue until I can do it myself I just pulled the fuse for ABS in my panel to shut that system off. Perfectly safe to drive without them and not an inspection requirement. Now your abs is probably going on every time you apply the brakes and that is not a good thing!

Apr 16, 2014 | 2002 Chevrolet Avalanche

1 Answer

Meaning of ABS light


On vehicles equipped with antilock brakes (ABS), a second warning light is provided to warn if a problem occurs within the ABS system. The ABS lamp comes on when the ignition is turned on for a bulb check, then goes out after the engine starts. If the ABS warning light remains on or comes on while driving, it indicates a fault has occurred in the ABS system.

What happens next depends on the nature of the fault. On most applications, the ABS system disables itself if the ABS warning light comes on and remains on.

Oct 24, 2012 | 1999 Ford Ranger SuperCab

1 Answer

Intermittent electrical fault Saab 9-5


Check connectors,pins grimping force,bad contact between pins in main plug connector(abs unit)or connectors near pilar A left.
Good luck!

Sep 29, 2009 | 2000 Saab 9-3 Viggen

1 Answer

I have the same problem. While driving, all of a


its all the TCS they fail all the time they run 1200,00 new or 450.00 used..
Elite foreign auto used saabs parts

Sep 19, 2009 | 2000 Saab 9-3 Viggen

1 Answer

Warning lights


have obd  scanner run on vehicle 

Sep 12, 2009 | 2000 Saab 9-3 Viggen

1 Answer

Saab '02 9-3 "electrical"problem


Most likely it is the ABS module is going bad and needs to be replaced or rebuilt at www.bba-reman.com, hope this helps.

Sep 02, 2009 | 2000 Saab 9-3 Viggen

2 Answers

Anti lock brakes


depending on the system if it is 2 channel or 4 channel one of the sensors that are located on the backing plate located behind calipers is eithier faulty or dirty you can try brake cleaner these sensors use a small magnet pickup device to sense when the wheel "locks up"

Jul 20, 2008 | 1985 Audi 5000 S

Not finding what you are looking for?
2012 Chevrolet Sonic Logo

Related Topics:

235 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...