Question about Hyundai Santa Fe
Sounds like a ecu problem but to be sure get the OBD read and this will give you the code number for the faulty sensors,component
Posted on Jan 12, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: 2002 HYUNDAI SANTA FE
I had the same problem with a 2003 Hyundai Santa Fe. While driving to work as I pressed on the gas the brake and battery light would come on. When I applied the brake, the lights would go off. When I got to work I turned the car off and then tried to start it, nothing. The car made a funny sound while running and I could smell somethig smoking. I replaced the alternator and all is good again. When removing the alternator the bottom lifts off the mounting bracket, you cannot drive the bottom bolt back through the mount as I tried to. Simply remove the nut on the bottom bolt and remove the top bolt, then lift the alternator out.
Posted on Oct 26, 2008
hi have not had pleasure of this on santa fe yet? but will try to help dependant of which side o/s or n/s ? i would first remove the screws holding the front of the under engine plastic cover/shield and drop down sufficient to gain view/access? to the rear of fog lamp then if a cover is on? try turning anti clock to remove? or if rubber cover pull off? then the bulb and clip should be visible? unplug the wire from bulb then the spring clip holding bulb in place normally just sring the 2x top ends together and swing down/clear to remove bulb? refit new bulb correctly! pay attention to position old bulb positioned? then clip securely and re connect wire at this stage it would be best to ensure bulb works ?? before you re assemble all else? wish you luck and hope this helps with your problem ?
Posted on Oct 28, 2008
SOURCE: 2001 hyundai santa fe starts with one crank but won't go into drive or reverse, only goes into park and neutural what could be the problem? i have a 2001 hyundai santa fe 2.7 l v6 all wheel drive
You do have drive and reverse,if you have park and neutral.It just the transmission cant transfer that power a new or rebuilt is the solution
Posted on Mar 20, 2012
Tips for a great answer:
Nov 04, 2014 | 2007 Hyundai Santa Fe
Apr 25, 2014 | Hyundai Santa Fe Cars & Trucks
Mar 02, 2014 | Hyundai Santa Fe Cars & Trucks
Mar 07, 2013 | 2001 Hyundai Santa Fe
Mar 20, 2012 | 2001 Hyundai Santa Fe
May 02, 2009 | 2004 Hyundai Santa Fe
Nov 30, 2008 | 2001 Hyundai Santa Fe
Aug 25, 2008 | 2002 Hyundai Santa Fe
Aug 18, 2008 | 2002 Hyundai Santa Fe
Mar 12, 2019 | Hyundai Cars & Trucks
27 people viewed this question
Usually answered in minutes!