Question about 2003 GMC Envoy
Got it out ok. How does it go back in?
Brake switches are adjustable and so need screwing in , from the rear of the fitting
Posted on Jan 12, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
The headlights on the envoy are the easiest parts of the car to repair. You just pull the two tabs at the top of the headlights, screw out the bulb containers and you are good to go
Posted on Nov 15, 2008
sounds like a fuse look under the dash panel for fuse cover look at the back of cover and check that fuseThanks for using fix ya Please rate my response thank you very much
Posted on Jan 31, 2009
don't need any special tools, standard sockets sets, "C" clams is a must unless your a He-Man and wrench set, plyer or needle nose will do. I assumed being 2003 your rotor never have been turn and i recommend every time you change your bakes is good idea to have your rotor turn. reason is it will make your pad last lot longer, removed any vibration and better even wear on the pad and eliminate any squealing although is not necessary to do so. make sure you get extra break fluid to bleed the brakes. get your self 5 feet long smallest vacum rubber hoses and a glass jar to bleed your brake fluid in. the rubber vacum hose you going to use to fit on to the bleeding nipple and run the other end of line to your the glass jar to save the brake fluid when you bleed the brakes. when removing caliper, check inspect make sure the rubber seals around your piston look good and not crack or deteriorated. before applying new pad make sure you open the bleed valve to reduce the pressure by turning the bleed nipple counter clockwise and leave it open attach that rubber hoses to the nipple because you going to press on the piston back into it housing with the "C" clamp in order for new pad to fit. becareful not to damage the rubber seals around the piston. its going to take lots of effort to push that piston back in so be a bare with it if needs to. once the pad is back in make sure you keep the reservoir full with brake fluid and then bleed the brake. two people is a good idea to do brake. one will do the pumping the brake and holding it down and other will bleed the nipple. I bleed it 2-3 time will do the job. good luck!
Posted on Jul 17, 2009
Tips for a great answer:
Sep 04, 2013 | 2003 GMC Envoy
Jun 05, 2012 | 2003 GMC Envoy
Mar 27, 2011 | 2004 GMC Envoy
Oct 05, 2010 | 2003 GMC Envoy
Mar 12, 2010 | 2005 GMC Envoy Xl
Mar 04, 2010 | 2003 GMC Envoy
Oct 10, 2009 | 2003 GMC Envoy
Apr 20, 2009 | 2003 GMC Envoy Xl
Mar 29, 2009 | 2003 GMC Envoy
Feb 19, 2017 | 2003 GMC Envoy
112 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: