Question about Cars & Trucks

1 Answer

When i get gas( with car on or off) it sputters as if its going to die. hesitates idle roughly

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Loyalty:

    Visited the website for 30 consecutive days.

  • Cars & Trucks Master
  • 613 Answers

Get the OBD codes read, this will give a number for the faulty sensor/component

Posted on Jan 12, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
ourhowse
  • 2007 Answers

SOURCE: Car hesitates when excelerating from

Check timing chain. Sounds like it may have jumped a cog.

Posted on Apr 28, 2009

Murphybanton
  • 2004 Answers

SOURCE: 1999 jeep wrangler idles rough almost dies out now has a slight miss or hesitation while driving

Please be fast about checking your fuel pump. It is not giving enough fuel pressure.

Cheers.

Rate this.

Posted on May 25, 2009

  • 14 Answers

SOURCE: 2003 Monte Carlo SS Hesitates and Dies after running for awhile

The ck engine light should not be ignored, what sensor was shown to be bad ? Have it scanned again and replace the sensor that is bad if it still runs rough you might want to consider a tune up. Plugs, wires, fuel and air filter's and clean the throttle body with some gumout. It could also be the IAC motor Idle Air Control. Good Luck

Posted on Jun 23, 2009

  • 1 Answer

SOURCE: Sputtering backfiring, stalling randomly when i engage the clutch. help!

everytime i try to start my truck, it turns over then stalls out on me. any idea?

Posted on Jul 10, 2009

  • 1986 Answers

SOURCE: rough idle, dies when trying to give it gas

it'll either be your ignition system (spark plugs, distributor cap, etc) or more likely your fuel system (most likely your fuel pump or your fuel filter)

Posted on Sep 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine sputters accelerating seems like its missing


Sounds like you need to check your filter's there is one in the tank also.

Jan 12, 2018 | 1995 Nissan Pathfinder

1 Answer

Hard to start, dies, missing out, hesitation, low rpm take off missing out


Fuel filter clogged, weak or faulty fuel pump. Have fuel pressure checked, if its ok, then check igniton coil or module.

Dec 13, 2013 | 2000 Chevrolet Silverado 1500

1 Answer

My truck sputters when i hit rough roads and when i press the gas pedal fast it hesitates


The cause of your Ford Ranger hesitating while pressing the gas pedal can be the fuel filter, change it first since its the cheapest, next would be bad spark plug boots cracked, or spark plug gaps to wide, then lastly dirty fuel injectors.-------------------------------------------autel ds708

Nov 28, 2012 | 1985 Dodge Pickup 4WD

1 Answer

Rough idle, gas fumes, sputters while driving


You have an air leak around the throttle body

Sep 21, 2017 | 1988 Jeep Wrangler

1 Answer

Sputtering on 1991 nissan maxima from a stop then at 2000 rpm or so it will run grat


its your idyll. You need to turn up the gas flow to the fuel injection or the carburetor.

Aug 26, 2012 | 1991 Nissan Maxima

1 Answer

Truck sputters and doesnt have power at lower rpms


Possible fuel pump about to die. They will work if revs kept up

Aug 12, 2012 | 1990 Isuzu Pickup

1 Answer

99 sportage engine shaking, hesitates when accelerating


use a couple of quality injector cleaner in the tank
run fault codes
remove and clean injectors
check fuel pressure

Oct 22, 2017 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Very hard to start and idles rough


Cold start injector could be bad, or you could have a small vacuum leak, like a cracked hose. A vacuum leak is most noticeable at idle, when engine cold.

Jan 03, 2010 | 1994 Toyota Pickup

1 Answer

Car dies-hard to start


EPC= electronic pedal control it is a sensor and is located in front of the brake pedal . Depress brake with one hand ,the sensor with the other and release fast. this should disengauge the EPC lock listen for a thunk made by the EPC lock disengaging.

Go to auto zone. They will use a code reader to help you find exact component or components having errors. If its not the EPC.
it sounds like your mass air sensor or the throttle control sensor may be bad. Your gas and air may not be mixing properly thus causing your car to sputter, hesitate, and idle rough. It could be some other thinks like a bad plug or wire etc. Good Luck hope this helps. Please rate me if this helps thank you.

May 15, 2009 | 2004 Volkswagen Jetta

1 Answer

Sputtering and hesitating


Try replacing the PCV valve, and spray the carb, or throttlebody, with a good carb and choke cleaner.

Apr 10, 2009 | 1995 Toyota 4Runner

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

84027 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers

john h

Level 3 Expert

19466 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...