Question about Chevrolet Cars & Trucks

2 Answers

My chevy s10 jerks going down the road the code reader said emission problem

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Y.t.a.m.e.h.e.

Posted on Jan 12, 2019

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 76 Answers

What is the code #?. Most common is gas cap, tightening or replacing solves this issue. Once you list the code #, I can help figure out the real issue.

Posted on Jan 12, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

leetamara
  • 702 Answers

SOURCE: my chevy s10 failed emissions

Have your cat. converter checked out. I just had one of these for the same reason in my shop today.

Posted on Jul 09, 2008

SOURCE: 1991 chevy s10 pickup 4.3 engine

Check for vac. leaks and timing.

Posted on Jul 13, 2008

bunnydawg
  • 5158 Answers

SOURCE: 1992 Chevy Cav jerking while driving hard to start

buy a couple bottles of gas line antifreeze and add them to your tank.... each time you fill up add one to the tank

Posted on Jan 28, 2009

  • 462 Answers

SOURCE: Vehicle cut off going down the road. The scan

Check the mass air flow sensor. Unplug it, then try to start the engine. If it starts and runs ok replace the sensor. Make sure the wiring is good to the sensor, The wires may break inside the covering near the connector ends.

Posted on Sep 09, 2009

ftw1952
  • 10319 Answers

SOURCE: 1993 Chevy S10 Blazer transmission problem...

the trans is electronic so the PCM is at fault

Posted on Sep 28, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My chevy s10 died going down the road. It turns over but wont start


I have 94 s 10..4.3 v6. it does the same thing have replaced fuel pump and filter,ignition module,cap rotor plugs wires,coil,ground strap...driving down the road jus dies like the key got shut off....for a while when troubleshooting through the parts you could get it to restart.....now when it dies it cranks really hard when trying to restart..ive checked the timeing its fine....if i wait a few min it will usually start...sometimes it will show a check engine light sometimes not......never know when it will happen sometimes jus down the the road from the house sometimes 100miles down the road......sometimes three times in a mile sometimes not for weeks at a time..Wtf...Im ready to shoot it like a lame horse....its a shame too its a sharp lil truck thats a two owner and never spent a night outside in its life...i knew the original owner ...i bought it with 90,000 on it it only has 148,000 now and still looks like new...

Apr 22, 2013 | 1994 Chevrolet S-10

1 Answer

1988 Chevy S10 cranks fine but when driving down road when you go to shift into second it starts bogging down and cuts off.


thinking maybe the neutral safety switch may have a short in it or be broken...also check emissions vacuum equipment for leaks under load..now Im thinking there is an electric interlock (on manual transmission models that was make into the clutch pedal also) check this for proper operation..repost findings please..

Jan 22, 2013 | Cars & Trucks

2 Answers

1997 chevy silverado pu 4x4 keeps blowing eng 1 fuse runs for about 15 seconds when fuse blows engine almost quits but keeps running and runs fine. The transmission jerks in overdrive going down the road...


ENG 1 - 20 amp fuse - under hood fuse Box . This fuse powers the O2 sensors heater circuits , Emission - purge an vent solenoids , mass air flow sensor , camshaft position sensor an A.I.R. intake recirculation relay - if your vehicle has it , L31 only
I would look for wires for o2 sensor melted on a exhaust pipe or manifold . Isn't your check engine light on ?

Feb 22, 2018 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

Vehicle cut off going down the road. The scan


Check the mass air flow sensor. Unplug it, then try to start the engine. If it starts and runs ok replace the sensor. Make sure the wiring is good to the sensor, The wires may break inside the covering near the connector ends.

Sep 09, 2009 | 2001 Chevrolet Blazer

1 Answer

1992 Chevy Cav jerking while driving hard to start


buy a couple bottles of gas line antifreeze and add them to your tank.... each time you fill up add one to the tank

Jan 28, 2009 | 1992 Chevrolet Cavalier

1 Answer

My chevy s10 failed emissions


Have your cat. converter checked out. I just had one of these for the same reason in my shop today.

Jul 09, 2008 | 1991 Chevrolet S-10

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

83850 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...