Question about 2000 Kia Sportage

Open Question

I have a 2000 kia sportage and need to replace the kick down cable but can't see where it connects to the transmission and how to replace it. Thanks

2000 Kia Sportage long body 5 door automatic petrol, australian model.

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 1 Answer

SOURCE: 1996 kia sportage 4wd transmission

I have 1996 Kia Sportage not shift right, some time RPM goes very high before it change to higher gear.

Engine run great!

please help or any sugestion will really appreciated.

Posted on Sep 06, 2008

Ad
MrScary66613

Travis Humphries

  • 1990 Answers

SOURCE: Can't find the rear washer reservoir in 2000 kia sportage

Your Rear Reservoir is the Same as the Front. Is has a Line that supplies Both the Front and Rear Washers. Please Rate my Response, I need all the Help That I can Get! Thanks!

Posted on Jan 27, 2009

localwonder

Michael Masters

  • 6784 Answers

SOURCE: the Abs light came on and will not go out after i

This is just a consequential event. the ABS sensor module was probably going out and decide the trigger the alarm at the same time you initiated the hard brake during travel. replacing or resetting this sensor module Will fix this issue. the light will go off as well.


Please rate and god bless.

Posted on Mar 17, 2009

Molson02536

Harvey N Tawatao

  • 3854 Answers

SOURCE: code for kia sportage tape and cd player

You can go to the dealer and have them help you get the code for the radio, if there going to charge you a crazy amount you can try www.radio-code.com. There cost is cheaper and can help you reprogram the code in your KIA. befor you go through all that, check for the code in the glove box, there might be a sticker in there or in your back pages to your manuel.
Good luck and hope this helps yougte your radio wokring again, keep me posted oh and try 0000 first. 

Posted on Jun 07, 2009

Jonah Oneal

  • 14092 Answers

SOURCE: 2005 Kia Sportage serpentine belt

YOU NEED THE BELT TENSIONER TOOL ITS FITS IN THE SQUARE SLOTS IN THE TENSIONER.YOU ROTATE TENSIONER CLOCKWISE TO REMOVE BELT.

Posted on Aug 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is transmission range switch on 2000 kia sportage


Under the hood. look at the transmission. locate the shifter cable. Follow it to the transmission. under where it connects is the switch you are looking for.

Nov 08, 2015 | Kia Cars & Trucks

1 Answer

2000 kia sportage fule pump works but wont kick in


if its working its typically kicking in can you explained how you have come to these conclusions so we can try to help better. also any check engine lights when did this start and has anything changed

Jan 28, 2014 | 2000 Kia Sportage

1 Answer

Kia 2002 sportage wont shift out of first gear did a head job and the trannt worked fine thanks


Did you fit back all the kick down cables and electrical connectors correctly? I think you should re check those....Regards Johngee10

Oct 16, 2010 | 2000 Kia Sportage

2 Answers

Auto transmission hold light flashes and wont shift out of 3rd gear the power buton is off but the hold still blinksComments: Dec 28, 2009- Yes that was the first thing.I did then I changed tranny...


well what i would do first is smell the transmission fluid if it smell burnt the transmission must come out,if not drop the valve body and check for a stuck valve or a check ball stuck in the separator plate try that over and out joe cool

Jan 04, 2010 | 2000 Kia Sportage

1 Answer

Starter for kia sportage 2000


  1. Before servicing the vehicle, refer to the precautions at the beginning of this section.
  2. Drain the engine oil.
  3. Remove or disconnect the following:

    Negative battery cable Intake manifold bracket upper bolts Clutch release cylinder and move it aside, if equipped Intake manifold bracket lower bolts and remove the bracket Starter from the clutch, manual transmissions only Starter from the torque converter, automatic transmissions only Starter electrical connectors Move the transmission wire harness aside Starter


    0900c152801b0603.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Exploded view of the starter

To install:
  1. Install or connect the following:

    Starter to the engine well Starter electrical connectors Lower intake manifold bracket and install the upper bolts Starter into position. When aligned properly torque the bolts to 40 ft. lbs. (54 Nm). Torque the intake manifold bracket bolts to 40 ft. lbs. (54 Nm). Properly position the clutch release cylinder, if equipped. Torque the bolts to 40 ft. lbs. (54 Nm). Torque the intake manifold bracket upper bolts to 40 ft. lbs. (54 Nm). Negative battery cable

Jun 28, 2009 | 2000 Kia Sportage

Not finding what you are looking for?
2000 Kia Sportage Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...