Question about 2009 GMC Envoy

2 Answers

How to reset "Low Tire Pressure Mesasage" on 2008 GMC Envoy

Posted by on

  • Marvin
    Marvin May 11, 2010

    the dealer must do this reset, it is a very involved procedure, but one question do u have the spare tire infalted correctly, it is monitored as well.

×

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,761 Answers

It should reset by itself after you resolve the low pressure problem and drive it a bit. The sensor will usually reset within 24 hours if the vehicle is driven a couple of times. If it does not reset, the sensor could be damaged or defective.
BillB

Posted on Feb 12, 2010

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • GMC Master
  • 22,423 Answers

Have correct pressure in the tire that is causing problem also check spare tire the low tire pressure warning is auto reset when correct tire pressure is achieved if all tires are correct then use reset button on dash its should be the button that looks like a [check ] if still no reset than u have a faulty air monitor valve that will have to be replaced not a fixable unit

Posted on Feb 12, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Warning light with exclamation point on 2008 gmc envoy


I'd toy read the Manuel for the vehicle, it's the tire pressure warning light

Feb 11, 2016 | 2008 GMC Envoy

1 Answer

Had a flat tire,reduced engine power light came on


Either the tire pressure monitoring system detected excessively low or zero tire pressure and the computer has been programmed to set the vehicle into limp mode when that happens or a wheel speed sensor or another sensor detected an issue when the tire deflated and the computer sent the vehicle into limp mode.

One way or the other, once in limp mode there would have been fault codes generated and could have be read with a scan tool. They have probably cleared now.

Jan 15, 2016 | 2004 GMC Envoy

1 Answer

Tire monitor


To troubleshoot the issue,go through the help link mentioned below:---
CARS: Working of
tire pressure monitoring system
http://technoanswers.blogspot.in/2012/10/cars-working-of-tire-pressure.html-------------
GMC ENVOY spare tire system stopped working?
http://repairhelpcenter.blogspot.com/2012/01/gmc-envoy-spare-tire-system-stopped.html

TIRE PRESSURE LIGHT COMING ON?
http://whoisbyme.blogspot.in/2012/07/tire-pressure-light-coming-on.html

What is Best Tire For the Vehicle?http://technoanswers.blogspot.in/2012/04/what-is-best-tire-for-vehicle.html------------
1998
Toyota
Camry: Tires Make Knock Rattling Noise Over Bumps?http://whatisbyme.blogspot.in/2012/05/1998-toyota-camry-tires-make-knock.html

These will help. Thanks.

Dec 17, 2012 | 2001 Oldsmobile Alero

2 Answers

Tire pressure light comes on when tires are okay. Can I reset something myself so it doesn't?


You are right, the pressure sensors can be affected by temperature. If its below 10 Degrees there is a chance they will malfunction, I had a similar problem on my Jeep Wrangler and it required a heated garage for an immediate rectification. Alternatively, some tire shops have a computer which can communicate with the tire pressure sensors and reset the sensors once they determine that the correct air pressure has been applied to the tire.

Oct 20, 2012 | Cars & Trucks

1 Answer

My 2008 Envoy has the tire sensors that connect to the computer .. I recently had two tires replaced and was having no problems but since the weather has gotten colder when I first start the engine the...


Air pressure in the tires drops when it is cold (as much a 5 PSI), as you drive they heat up and that makes them fall within the correct pressure limits to turn off the low tire pressure warning. I suggest you get an accurate tire gauge and air your tires up to 32 PSI all around.

Dec 13, 2011 | 2008 GMC Envoy

2 Answers

How do I reset the low tire pressure light on a 2008 Nissan Centra


TO RESET LOW TIRE LIGHT.JUST DRIVE VECHICLE 16 MPH TO COMPLETE THE TIRE RESET PROCEDURE.BUT FIRST PUT AIR IN TIRES FIRST.YOU NEED 33 PSI.TIRE PRESSURE.

Jan 17, 2011 | 2008 Nissan Rogue

1 Answer

How do you reset a low tire pressure warning on a 2008 Jetta?


Reset the tire pressure warning, same as you would any service issue. Insert key in ignition, hold wrench button and min button, then start engine.

Apr 30, 2009 | 2007 Volkswagen Jetta 2.5 Sedan

1 Answer

Gmc sierra 2008 low tire pressure problem


You can follow this to reset it.
Ignition ON, initiate the TPM Learn Mode
using one of the following procedures:

  1. On vehicles equipped with keyless entry, simultaneously press the keyless entry transmitters lock and unlock buttons until a double horn chirp sounds indicating the Learn Mode has been enabled. The left front turn signal will also be illuminated.
  2. On vehicles not equipped with keyless entry, press and release the driver information center (DIC) INFO button until the TIRE LEARN message appears on the DIC display. Press and hold the SET/RESET button until a double horn chirp sounds indicating the Learn Mode has been enabled. The left front turn signal will also be illuminated.
  3. Increase/decrease the tire pressure for 8-10 seconds then wait for a horn chirp. The horn chirp may occur before or up to 30 seconds after the 8-10 second pressure increase/decrease time period has been reached. Once the horn chirp has sounded, the sensor information is learned and the turn signal in the next location to be learned will illuminate.
    After the horn chirp has sounded and the right front turn signal is illuminated, repeat step 2 for the remaining 3 sensors in the following order:
    3.1. Right front

    3.2. Right rear

    3.3. Left rear

    When the left rear sensor has been learned and a double horn chirp has sounded, the learn process is complete and the RCDLR exits the learn mode.
    Ignition OFF, adjust all tires to the recommended pressures

Jan 22, 2009 | 2000 GMC New Sierra 1500

1 Answer

2008 Gmc Sierra ----- tire pressure sensors


im in cold quebec there preset i install snow tire with rim on those with regular valve light stay on because people dont whant to spsnd and extra $160.00 for those valve in cold zone tire pressure are low be ready to reset that computer many time this winter pierre

Dec 18, 2008 | 2007 GMC Sierra 1500

Not finding what you are looking for?
2009 GMC Envoy Logo

938 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...