Question about 1992 Toyota Camry V6

2 Answers

1992 Toyota Camry won't crank

Won't crank.No sound from starter.Starter tested ok. Battery new.Dash lights light up.Fuses not blown. Replaced starter relay and ignition switch. Can't find fusible link.
1992 Toyota Camry XLE V6 automatic

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 184 Answers

Check the ground cable going from the battery to
alternator, then to chassis. Make sure there is no
rust at the chassis ground wire terminal, and that it
is very tight. The fusible link will be off the alternator
red power cable,usually, but not 100% on that car.
Good luck.

Posted on Mar 30, 2010

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 73 Answers

Make sure the starter solinoid is kicking in.

There is an enable switch in the Park position of the transmission gear shifter. It goes bad in some cars. Try starting in nuetral. Wiggle the shifter in the start position.in park with the key in start,

Also smart keys go bad and will not allow start

Posted on Mar 30, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1989 toyota camry starter cranks with a high whinning sound but no spark to start engine


TOYOTA IS NOTORIOUSLY KNOWN FOR BAD STARTERS!!!! OPEN THE HOOD AND HAVE SOMEONE CRANK THE STARTER WHILE YOU LOOK TO SEE IF THE ENGINE IS ROTATES, WHEN THE STARTER IS ON.

IF THE ENGINE TURNS VERY SLOWLY OR NOT AT ALL, THE ENGINE IS FINE. BUT, THE STARTER HAS A BAD SOLENOID AND IT'S NOT ENGAGING THE FLYWHEEL. THERE FOR IT'S SPINNING AT VERY HIGH SPEED MAKING A LOUD HI-PITCH WHINNING. BUY A NEW SOLENOID AND FIX IT YOURSELF!!! BUT TOYOTA WON'T SELLL YOU JUST A SOLENOID BECAUSE THEIR GREEDY!!! A NEW STARTER FROM TOYOTA IS AROUND $350.00. AT AUTOZONE AROUND $100.00 WITH A LIFETIME WARRANTY! BUT IF THE SOLENOID SWITCH IS BAD IT COST AROUND $250.00 AT TOYOTA, & $99.00 AT AUTOZONE. ALSO CHECK THE THE STARTER RELAY, COST ABOUT $150.00 AT TOYOTA AND AROUND $40.00 AT AUTOZONE. PULL THE STARTER OUT AND GET IT TESTED AT AUTOZONE...( FREE!!!)
" I'M ABOUT 100% SURE YOU STARTER IS BAD!!!!" GOOD-LUCK!!!

Oct 19, 2012 | 1989 Toyota Camry

1 Answer

Won't start


So it's a no crank condition? Do dash lights, gauges, and everything else work when the car won't crank over? If so, buy a cheap $5.00 testlight, and when the car won't crank, pull the small black wire off the starter solenoid. While someone holds the key in start (cranking) position and clutch pedal depressed, see if the black wire has power as it should. (Ground the testlight and just touch the wire's end terminal. If powered, the testlight will light up.) If power there, then the starter solenoid is failing. Toyota starters are very good units, but the solenoid's internal contacts get old and pitted.
If no power at the black wire, then the start circuit from ignition switch to clutch safety switch (on the clutch pedal) to starter relay to starter solenoid will have to be diagnosed. To double-check: take a single battery jumper cable and put it on the positive battery post connection. Put the other end of the jumper cable on the solenoid terminal where black wire was removed. Key can be off. Make sure car is in neutral, brake set. If starter now operates, solenoid is O.K., and it is a problem in the start circuit, -ignition switch, neutral start switch, or in the wiring.
Now find a grounding place for testlight under the dash. When car won't crank, check for power coming out of ignition switch on the black wire with white stripe. This is the start wire for the starter solenoid. Key must be in crank position. Wire shoud be powered-ignition switch is working. If no power, switch is failing. You can do the same for the clutch start switch-it's a simple switch, that when clutch is depressed switch is closed and passes power on from ignition switch to the starter relay (thus allowing power to the starter solenoid). Black wire, red stripe-this is wire from clutch switch to starter relay. When key is in crank, clutch depressed, this wire should be hot.
With me so far? Still haven't found a problem, or any loose connections? Next and last is the starter relay. It is located under dash, close to gas pedal, but under the center console, just forward and left of gear shifter. It can be tested and the wiring diagnosed there, but relays are cheap, so just swap in another and see if that helps.
If you have tried everything, and still no help, you could try a new wire from the relay to the starter solenoid. This is that black wire we started with. Older toyotas sometimes have a problem with degraded wiring not passing enough current to operate the starter

May 04, 2012 | 1992 Toyota Tercel

1 Answer

1992 toyota pickup won't start and battery won't charge


Sounds like your battery is just too dead, has enough juice to light up the system for a minute but cranking drains it and if it wont charge then deff fried, you could try removing the battery and starting the car with cables to confirm the starter still works. If a bettery is too dead then when you are jumping it, it takes to much of the power just trying to get through the battery.

Dec 21, 2017 | 1992 Toyota Pickup

1 Answer

2002 camry wont start, has a new battery. the lights dim on dash when trying to crank. tried tapping starter, the car cranked, but once car is turned off, it would not crank without tapping starter


In all probability, your starter is drawing too much current and needs to be replaced. If you can get the car to a commercial auto parts store, they can test the load draw (there is usually no charge) to see if this is your issue.

Aug 05, 2011 | 2002 Toyota Camry

1 Answer

Won't crank.No sound from starter.Starter tested ok. Battery new.Dash lights light up


Check your wires to the starter for corrosion or breaks, high resistance will cause that issue. The ignition switch should be checked as well, even though all of your lights come on maybe when you try to crank the engine the switch is worn out in that position so it does not send the signal down to the starter.

Mar 18, 2010 | 1992 Toyota Camry V6

2 Answers

Won't crank.No sound from starter.Starter tested ok. Battery new.Dash lights light up.Fuses not blown. 1992 Toyota Camry XLE V6 automatic


Battery cables off the starter ,starter relay and ignition switch. these are the remaining items in the starting system for no crank and no start.
Get Shop manual and do the appropriate testing for each.

Feb 19, 2010 | 1992 Toyota Camry V6

1 Answer

My 1994 Camry cranks but wont fully start


As you are finding out ....this is how you kill a car. You need fuel, spark, compression, and air to run an engine. Look for spark and fuel items to be working. A computer controls much of the spark part. They canbe sensitve electrically. If you are cranking ..starter sounds ok. Alt. will act up after you get started. concentrate on spark and spark control. Fuel and fuel control. This is what you need to start.

Jul 14, 2009 | 1994 Toyota Camry

2 Answers

Will not start


Sounds like the MAIN FUSE has blown .
I would check the MAIN FUSE in the fuse box under the hood. It's going to be the one with the most amps. It might be 80 amps or so.

Apr 29, 2009 | 1984 Toyota Camry

2 Answers

04 chevy 2500HD start relay /Circuit braker turns off @ key crank


Make sure battery has a full charge and battery connections all good. Any fuses in the diagram, test for voltage, some are hot all the time, some go hot with the key on.
Use a digital multimeter across battery posts, everything off, the generic spec for a full charge is around 12.6 volts. Leave the leads hooked up to battery, have a helper turn key to crank, how far does it drop? In my opinion it shouldn't drop much under 10 volts, I wouldn't argue with 9.6 volts.
2500 starter 1-h5vtzulw5yduyapxqxcg0ngy-5-0.jpg

impala starter 2-h5vtzulw5yduyapxqxcg0ngy-5-2.jpg

Mar 28, 2017 | Chevrolet 2500 Cars & Trucks

Not finding what you are looking for?
1992 Toyota Camry V6 Logo

1,127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85111 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...