Question about 2001 Cadillac DeVille

2 Answers

Abs, brake and traction control light stay on. how do i reset them

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    New Friend:

    An expert that has 1 follower.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I have a 2001 Cadillac Deville with 105,000 miles. The ABS and Traction Control light stay on. What could be the problem? Could I reset the ABS and Traction Control light?

Posted on Apr 22, 2011

Ad
  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that has over 10 points.

  • Contributor
  • 2 Answers

There is a little grey sensor that is very easy to dislodge on the passenger side against the firewall. be certain that it is seated properly. It is easy to bump and will throw all of the codes listed even if it is siting crooked.

Posted on Jun 12, 2013

Ad

5 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

tommy

  • 27 Answers

SOURCE: ABS LIGHT AND TRACTION CONTROL LIGHT ON DASH

make sure u didnt break a wire, there are sensors on the brakes, make sure theyre plugged in

Posted on Jun 10, 2009

Anonymous

  • 8 Answers

SOURCE: traction control light and abs light

ok your problem is that your brakes are under force you shold get new brake pads ok

Posted on Jul 14, 2008

tripletauto

TripleTauto

  • 1450 Answers

SOURCE: 2005 Impala abs & traction control problem

The traction control works off of the abs.So when abs has problem traction is disabled. If problem started when brakes changed most likely one of these sensors. Check rear wiring and see if you can see any physical damage.

Posted on Nov 11, 2008

bluebirdmate

Darryl Kazemba

  • 1190 Answers

SOURCE: I have a 2001 Cadillac Deville with the ABS and

Hello: There are many things that will cause the lights to come on. You can check the brake fluid if it is low that will cause the light to come on. you can clear the code with a up scale scanner but if the problem is not corrected the light will come back on.

Posted on Apr 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Abslight stays on. How to fix? This is a2007trailblazer?


First you need to have EBCM - electronic brake control module check for DTC'S - diagnostic trouble code's . If the light is on there is a code stored . I think most part stores can do this and for free . After you find out what code is stored , looking up that code in service repair information for diagnostic trouble shooting chart would be next step . There are a few codes too.
DTC C0035 or C0040
DTC C0045 or C0050
DTC C0110
DTC C0131
DTC C0161
DTC C0186
DTC C0196
DTC C0201
DTC C0240
DTC C0241 or P0856
DTC C0244 or P1689
DTC C0245
DTC C0283
DTC C0287
DTC C0290 or C0292
DTC C0455
DTC C0550
DTC C0558

Find the code do the diagnostic's , fix the problem , wiring issue's , a sensor , bad module ,what ever it is . The light will go out then . Here is a sample of code discription .
• DTC C0035 Left Front Wheel Speed Sensor Circuit
• DTC C0040 Right Front Wheel Speed Sensor Circuit

Dec 30, 2016 | 2007 Chevrolet Trailblazer

2 Answers

Why does my ABS light stays on and sometimes i get a vibration in the brake petal causing my 2002 Cadillac escalade not wanting to stop?


Sounds like a fault with the Antilock Braking System. The vibration in the pedal is the ABS working. With your foot on the brake pedal, it releases and re-applies the brakes to stop a skid from the wheels locking up. You need professional service for brakes.

Seems to be a known issue on all Cadillac and requires the ABS module to be replaced.

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > DeVille Cadillac DeVille ABS Light Due to ABS Control Module Failure. This is a verified problem based on 126 reports. Learn more about this problem, when it occurs ...

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > Seville STS Traction control and ABS lights stay on dash. This is due to ecbtm Module gone bad. replace Module and this should fix the problem. You can go by the VIN and ...

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > DeVille DTS ABS Light Due to Control Module Failure on Cadillac DeVille DTS. The anti-lock ... ABS and Traction control light stays on. ... abs light to abs control stay on.

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > Seville SLS ABS Light Due to Control Module Failure on Cadillac Seville SLS. The anti-lock brake ... SLS135,000Jumsee. Abs and traction lights stay on when started.

Jan 12, 2016 | Cadillac Cars & Trucks

1 Answer

Abs light and traction control light stays on after repairs


I wonder if someone forgot to reconnect the connector from the sensor?

May 13, 2014 | 1995 Jaguar Vanden Plas

2 Answers

ABS/ Traction control light/BAS & brake light on in 2008 dodge grand caravan


It is safe to drive. You need a scan tool to get a code out of it. Could be as simple as a wheel speed sensor going bad. All of these lights will work together normally. The traction control uses the ABS to gain traction, and the Brake Assist System is part of the stability control. Also uses the ABS.

Oct 03, 2012 | 2008 Dodge Grand Caravan

1 Answer

ABS LIGHT AND TRACTION CONTROL LIGHT STAYS ON


ABS = Anti-lock Brake System.
TC = Traction Control System (Engine Control Module).
If the ABS lights on the dashboard permanently the ABS system is faulty. You must access the ABS & TC Electronic Control Units (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ABS ECU, in other words reset the ABS system and turn off the warning lamp on dashboard.

I suspect bad brake pedal switch, but you should scan the ABS & TC ECU's.

Jul 02, 2011 | 2001 Jaguar XJ8

1 Answer

Brake peddle is chattering 2003 ion and would like to pull the anti lock brake fuse (if safe ) until i can afford the repair. I would like to know witch fuse to pull?ABS is on and traction control


If brake pedal is chattering or pulsating it is most likely because you need either front or rear rotors, or both. They are rusted or out of round. If there is something wrong with either your abs or traction control,the abs or traction control light will come on & stay on. As soon as these lights come on, it automatically disables abs or traction control. If you would like to take out fuse that disables abs or traction control circuits, it will leave the lights on.You just wont have their functions. If by some strange condition your chattering goes away, then there is indeed something wrong with your abs or traction control.Fuses are labeled abs or traction either under hood or in your fuse panel in car.

Jun 13, 2010 | 2003 Saturn ION

1 Answer

ABS and Traction Control Light On


Because the brakes were changed, either one of the sensors were broken when removing brakes or it has set a code. Go to your local autoparts store and have them reset the code. See if it comes back on. If it does you will need to look at the ABS sensors on each wheel and replace if damaged

Sep 29, 2009 | 2005 Chevrolet Equinox

1 Answer

1998 Olds 88, Replaced all the brake lines (because of corosion) I took care to get lines back on anti-lock unit in same position as origonal. Brake light on dash did go out but the ABS and Traction...


you probably push air into the ABS unit when getting your lines replace but the Traction Control light might be on because the system might use the wheel speed sensor on the ABS unit to enable the Traction Control.......

Jul 09, 2009 | 1998 Oldsmobile Eighty Eight

1 Answer

Traction light stays on as well as my abs would come on and stays on and clicking noise during braking.


Sounds like you have a problem in the front brakes or a front wheel speed sensor. A common cause for a Traction light is a faulty front ABS wheel speed sensor or harness. When the Anti lock brake computer sees a problem in the ABS syetm, it disables traction control as well.

Mar 12, 2009 | 2003 Oldsmobile Silhouette

1 Answer

Transmission Traction "Off" light stays lit with Traction button


The traction control system is controlled through the Anti-lock brake system. The way it works is if one of your wheels starts spinning the ABS applys the brake to that wheel to transfer power to the oppsite wheel that is getting traction. If your ABS is bad then your Traction control won't work. To check it I would find a parking lot on a wet day. In an open space mash in the gas. if you hear the ABS system kick in and you don't squall the tires then your good. My guess is you won't. What I would be worried about is will my ABS work. When checking the traction control is a good time to check the ABS. Acclerate to around 15 mph, then mash the brake as your live depended on it. If you hear a motor run and feel a vibration or grind in the brake peddal, then it works.

Jan 09, 2009 | 1997 Buick LeSabre

Not finding what you are looking for?
2001 Cadillac DeVille Logo

9,718 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...