Cars & Trucks - Page 6 - Recent Questions, Troubleshooting & Support


As long as the voltage is correct, the motor will only draw what power (amps) it needs, regardless if the battery is a 500 amp or 710 amp battery. It will be fine. Greater amps will allow the motor to run longer.

Cars & Trucks | Answered 13 hours ago


P0121 is normally a bad throttle position sensor - since you've already replaced it, check for damage in the wiring harness.

If you have a scan tool that can read the values, check to see what you get at the idle and WOT positions.

Toyota Cars &... | Answered 14 hours ago


How replaced, it is a big job you need to remove the crankshaft pulley.

2006 Chrysler... | Answered 14 hours ago


You need to check if you have power giing to the motor still inside door if theres power replace motor

Toyota Cars &... | Answered 15 hours ago


Main relay? What's it control?

Honda Cars &... | Answered 16 hours ago


Its number 23, fuse box in engine compartment. Fuse locations are in the owners manual and on the cover of the fuse panel.

Ford Cars &... | Answered 16 hours ago


Sounds like your turn signal/wiper switch on the side of your steering column is having problems. Like you said, it could very well be your computer. There is no way to reset the computer without the right software tools. I would try wiggling the switch to see if you can get it to work momentarily, if they work for a split second, then you know your switch is bad.

2007 Chrysler... | Answered 16 hours ago


You need to bled the air out of the cooling system.

Cars & Trucks | Answered 16 hours ago


Most vehicles have a small rectangular hole near the base of shifter for override. Sometime you need to flip up the little cover on it. Insert key into that hole and press shifter button and change gear. If the vehicle is not starting, try starting in neutral. Also, turn steering wheel and make sure brake is pressed while trying to start or change gears.

Cars & Trucks | Answered 16 hours ago


I have the same problem, I am able to get the car to start by jumping the car battery red terminal to the engine compartment red terminal (this bypasses the Internal Battery Management system), the car stayed running after disconnecting the jump. I then tried disconnecting the black battery terminal secondary which is supposed to control the IBM system, but that did not work. There is supposed to be a unit under the spare tire that could be a problem.

BMW Cars &... | Answered 17 hours ago


You need a scan of the system to determine what is going on, could be as simple as a door ajar sensor.

Daewoo Cars &... | Answered 17 hours ago

Not finding what you are looking for?
Cars & Trucks Logo

2,147,671 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

84966 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

21061 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...