i have searched the web , as i'm sure you have to, and can not find anything relating to this issue, i would contact honda motorcyle dealer and either get them to do it or get a driver's manual or just live with it,sorry could'nt have been more helpful
madaming pwedeng posibilidad yan, poor compression, poor spark, poor combustion. Check mo muna yung carburador niya.. dapat ang ikot ng fuel-air mixture e 2.5 turns out. Tanggalin mo yung air box at linisan yung filter nito.. tro mo din patagbuhin panandalian na walang air filter.. kasi pwede barado na ang intake nito. Check mo spark plug at siguraduhing malinis pa ito. Panigurado e palitan mo nalang ng bago.. check mo din na dumadaloy na maayos yung fuel papunta carburador.
kung ayaw mga to, pa-compression check mo para masuri ito ng maigi baka kasi maluwag na yung piston rings or piston nito.
parate naman kung sakaling natulungan ka nito salamat
Hi, Dickson and the usual suspects are:
1. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. A failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, stator, magneto, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Faulty neutral, side stand or clutch lever safety switch.
10. Faulty or corroded kill switch.
11. Accelerator pump damaged or not working.
12. Water or dirt in the fuel system, carburetor or filter.
13. Restricted, blocked or kinked fuel line.
14. Fuel tank empty.
15. The gas cap is not venting properly or fuel tank venting system blocked, loosen the gas cap and go for a test ride.
16. A failed fuel pump, pressure regulator and or fuel injectors.
17. Vacuum line from the intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
18. Needle and seat stuck closed in the float bowl.
19. Petcock clogged or damaged.
20. Lean angle switch is faulty or needs adjustment.
21. Catastrophic engine failure, perform a compression test.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day. How to Fully Troubleshoot Your Motorcycles Charging System MotorcycleMD How to Check Your Motorcycle Charging System https://www.manualslib.com/manual/989554/Honda-S90.html#product-CD90 https://www.partsfish.com/page/oem-parts-for-honda https://www.ebay.ie/sch/sis.html?_itemId=191073136720&_nkw=HONDA+CD90+CD90Z+OWNERS+MANUAL+RIDERS+handbook+Inc+WIRING+DIAGRAMS+1969&_mPrRngCbx=1