20 Most Recent 2006 Zongshen GS 250 - Page 4 Questions & Answers


There are a set of 4 steel springs that press the clutch plates and a heavy pin that pushes the plates apart. You need to engage the clutch to check. If the clutch will not disengage then it is the pin. If the clutch slips while riding, it's probably the springs.

Motorcycles | Answered on Oct 05, 2019


Hey Mike, I did a generic search for electric bicycle batteries, then searched specifically for Timco electric bike batteries. $150 seems the price-point break near the bottom of the new batteries on up into $300+ ranges (and sometimes much more). It may be based on your specific needs and requirements tailored to your particular model of electric bike (which was not stated in your question).

Pay particular attention to your battery voltage and ampere per hour needs as determined by your bike's requirements, or simply look it up in your manual (if available). You can find some cheaper batteries (used and new) on ebay, but if looking for a good quality new battery with a warranty I would probably search Amazon for a new replacement battery. Batteries in bikes last about two years before they start to lose their abilities to hold a full-charge. Best of luck to you & happy biking! ~Andy K.

Motorcycles | Answered on Oct 05, 2019


It should long as you got the right chain and the same size sprocket on the new motor as the one on your back tire. Also make sure the motor Wil mount proper .

Motorcycles | Answered on Oct 05, 2019


I would suggest maybe look on wish or eBay for starter. Just go to wish.com and then type in there search box what you meed.

Motorcycles | Answered on Oct 05, 2019


Replace the Piston rings

Motorcycles | Answered on Oct 04, 2019


No. Volt/Ohm meter is all.

Motorcycles | Answered on Oct 03, 2019


Cylinder not firing. Remove plug and verify spark. Also verify fuel to cylinder.

Motorcycles | Answered on Oct 03, 2019


Unable to test. Must verify other components in system, if they are all in spec. Than it's down to cdi.

Motorcycles | Answered on Oct 03, 2019


Make sure plates are seated and not loose when assembled. There should be no slack in plates.

Motorcycles | Answered on Oct 03, 2019


Yikes, self running machine, eh?
One thing to look at is you can have that condition when all of the parts are okay, but the battery condition is low. So that is my first question: what is the state of charge on the battery? If is is low, recharge, test it independently, and then try it in your machine.
For some reason at low battery voltage, contact points in the starter relay weld together.
Happens often on Harleys, which feature high cranking amps.
On a car, when this condition happens, one could tap on the relay and cause disengagement, but the relay is rarely accessible on a bike.
When you are all said and done, there is exposure of your starter relay, from all of this contact point welding. But most of the time the relay is fine.
Very interesting failure.
Battery is where you start.

Cheers,

Doc

Motorcycles | Answered on Oct 02, 2019


.30 should work OK

Motorcycles | Answered on Sep 30, 2019

Not finding what you are looking for?
Motorcycles Logo

19 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Zongshen Experts

Joseph Hoffmann

Level 3 Expert

1755 Answers

Tom Chichester

Level 3 Expert

54182 Answers

Terry
Terry

Level 3 Expert

10313 Answers

Are you a Zongshen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

985 C3 V4 Zongshen

  • 985 C3 V4 Zongshen

Most Popular Question

arranca en baja pero cuando acelera se

  • Motorcycles
Loading...