Question about Motorcycles

1 Answer

Suzuki gsxf 1250 bandit

I have a Suzuki bandit 1250 09 plate model starts fine no misfire but splutters at 2000 revs ive changed air filter spark plugs and fuel filter no f1 light on clock problem still not solved any ideas?

Posted by Anonymous on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 2 Answers

Sounds like you need to remove the pairs system (lots of people are having this ) popping , coughing in the exhaust but not a misfire

thank to the eu for this system

Posted on Nov 03, 2013

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 1 Answer

SOURCE: why wont my suzuki bandit 250 start?

If you tried to start the engine for any length of time, the plug would be damp and smell of petrol because fuel was being drawn into the combustion chamber. Without spark to ingnite the mixture, it would cause the plug to become damp. I am assuming you fitted the correct spark plug and that it is gapped correctly.

I don't mean this to sound foolish, but I would suggest you make certain the emergency kill switch has not been accidentally switched off. Also, if you have a sidestand safety interlock that prevents the engine being started while the side stand is down, flip up the sidestand and try again to start it.

Additionally, to make sure the plug wire is securely fitted to the plug. It is possible that the inside of the plug wire cap has gathered moisture and may need to be wiped dry.

If none of the above suggestions solve the problem, remove the plug then reconnect it to the plug wire and hold it near the cylinder - but not near the plug hole in the cylinder head (fuel vapors) - while pressing the starter . You should see an obvious spark. No spark likely means the coil is faulty.

Posted on Mar 14, 2009

Anonymous

  • 292 Answers

SOURCE: 1999 suzuki 800 maurader misfiring

did this just start all of a sudden or after being stored for a while? if it was stored then try new fuel, check and change fuel filter, and get some fuel system cleaner that goes in the gas tank, run til hot then let stand overnight. and try, old gas can gum up carbs starving the enging of fuel.

Posted on Apr 02, 2009

shreckstar

  • 5 Answers

SOURCE: suzuki 1200 bandit 1997 running rough at low revs

i had a similar problem on a suzuki gs250t custom, my bike would not start some times and if did start, would run erratically, and cut out, this was after i changed the spark plugs, found out that the supplier gave me the incorrect graded plugs.

Posted on Jun 11, 2009

Colin

  • 1584 Answers

SOURCE: my 2003 suzuki 1200s bandit, does not start I am

Is choke engaged and working?
Are all plugs clean / new?
Is petrol fresh?
Are compressions OK?

Posted on Feb 17, 2010

omaromid

omaromid

  • 332 Answers

SOURCE: Suzuki bandit 1996 will not start

If you have spark and still the bike is not starting ( and the timing on the spark is correct) make sure you got fuel flowing to the engine, if fuel is getting there and still the engine doesn't start, check the cylinder head and pistons and make sure you got compression. These are the problems that can cause a bike not starting. Hope it helps

Posted on Mar 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Removing 2001 suzuki bandit seat


Hi, Khanh for this scenario you will need your service, parts fiche, and owners manual if you can't find the best tool you ever bought for your Suzuki, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Suzuki Bandit gsf 1250 Seat Removal
1996 suzuki bandit how to remove seat gas tank and air filter
Suzuki GSF600S Service Manual
OEM parts for Suzuki
http://mybikemanuals.com/suzuki/suzuki-gs-owners-manuals

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


Oct 06, 2017 | 2001 Suzuki GSF 600 S Bandit

1 Answer

Wont rev past 6000


Hi, Maxwell and the usual suspects are:
1. Severely drained or faulty battery.
2. Faulty regulator/rectifier or high output coil.
3. Faulty power valve, solenoid or installation.
4. Clogged air filter or exhaust.
5. Cracked or incorrect float level.
6. Float needle is not seating.
7. Faulty reed valve.
For more information about your question please visit the website below. Good luck and have a nice day.
https://www.tradebit.com/filesharing.php/search/0/2007+suzuki+bandit+1250+abs

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Aug 16, 2015 | 2007 Suzuki Bandit 1250 ABS

2 Answers

GSF 600 won't idle and has poor throttle response.


Hi, Anonymous electrical contact cleaner is what you need and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Float needle and seat sticking.
5. Float level too low.
6. Carburetor bowl vent line clogged/blocked/pinched.
7. Idle adjusting screw set too low.
8. Air/fuel mixture screw set too lean.
9. Idle port, transfer ports, slow air jet clogged.
10. Slow fuel jet clogged.
11. Faulty fuel pump.
For more information about your issue and valuable "Free" downloads that you will need please Click on blue links below. Good luck and have a wonderful day.
http://www.motorcycleforum.com/59-motorcycle-repair/121210-2000-suzuki-gsf600s-problem.html
https://miles-by-motorcycle.com/136/forums/881/m-by-mc-public-forum/7892/suzuki-gsf600s-bandit-s-tech-thread?ROW=50
Suzuki GSF600S Service Manual
OEM parts for Suzuki
http://mybikemanuals.com/suzuki/suzuki-gs-owners-manuals

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Apr 13, 2017 | 1998 Suzuki GSF 600 N Bandit

1 Answer

Hello I have a 1998 bandit n600 22000 miles, it's been great but now all of a sudden it's developed this misfire....heres the run if events: from cold it's fine then after 7-10 miles i approached a...


Hi, G_beck nice novella and the usual suspects are:
1. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
2. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
3. Spark plugs in bad condition or partially fouled.
4. Spark plug cables in bad condition and leaking check for spark leakage in the dark
5. Spark plug gap too close or too wide.
6. Faulty ignition coil, module, and or sensor.
7. Loose, dirty, or corroded ignition module connector at crankcase.
8. Faulty CKP or CMP, MAP, ETS, ATS, TPS, O2 sensor.
9. Dirty air filter.
10. Intake air leak.
11. Water, dirt, or rust in the fuel system.
12. Carburetor damaged, contaminated, sticky float, plugged jets.
13. Multiple carburetors out of sync.
14. Fuel filter clogged.
15. Old or contaminated fuel.
16. Fuel tank vent system plugged or carb vent line closed off.
17. Gas cap diaphragm valve faulty.
18. Vacuum line from intake manifold to fuel valve is broken, cracked, pinched, or missing.
19. Carburetor controls misadjusted.
20. Incorrect valve timing.
21. Valve springs floating, weak, or broken.
22. Damaged intake or exhaust valve.
23. Incompatible performance parts.
24. Control module may be in "LIMP" mode
25. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Suzuki Bandit 600 is misfiring
Bandit 1998 600 very annoying misfire
Suzuki GSF600S Service Manual
OEM parts for Suzuki
http://mybikemanuals.com/suzuki/suzuki-gs-owners-manuals

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Feb 28, 2017 | 1998 Suzuki GSF 600 N Bandit

1 Answer

My 2005 Bandit 1200S seems to misfire when I cross 7500 rpms while riding. No starting problem no other issues. Please help.


Check you air cleaner ,and change your plugs ,they could be breaking down and not giving a good spark at high revs .

Mar 12, 2010 | 2005 Suzuki GSF 1200 Bandit S

2 Answers

Suzuki 1200 bandit 1997 running rough at low revs


unlikely. If u don't work on your bike the best thing u can do is take it back to whoever did the plugs and tell them to fix it.

Mar 22, 2009 | 1997 Suzuki GSF 1200 Bandit S

2 Answers

Increasing the sound


wont realy change the sound at all, would be a waste of money. in my opinion dump the whole exhaust system because it stranles the engine and replace with a de-catted system, you may still be able to use the yoshi end can

Nov 10, 2008 | 2007 Suzuki GSF 1250 Bandit S

1 Answer

Increasing the sound


wont realy change the sound at all, would be a waste of money. in my opinion dump the whole exhaust system because it stranles the engine and replace with a de-catted system, you may still be able to use the yoshi end can

Nov 10, 2008 | 2007 Suzuki GSF 1250 Bandit

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

469 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5954 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

richard libby

Level 2 Expert

209 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...