Question about 1972 Yamaha XS2

1 Answer

Dead pw 50 and sad boy.

Bike was running but would quit every once in awhile and then we reved it up and quit like it ran out of gas. took tank off and cleaned took carb off and cleaned.have fuel and spark but wont fire.could it be reed valves?how do you check without tearing them out? has compression

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,567 Answers

Many things could cause the problem. Let me see if I can help out.
You have spark, but is it enough spark? A weak battery can rob power from the coil so only a weak spark is present. Get a new stock NGK spark plug to eliminate the possibility of a problem plug.

It is good that you cleaned the carb because that would be my second target. Reset the air and idle screws. IMPORTANT > do not tighten these two screws down. Only screw these in until they LIGHTLY seat. Now turn each screw one and one half turns outward. Clean or replace the air filter and be sure the bolts are tight on the carb manifold. INSTALL AN IN-LINE FUEL FILTER. Let the float bowl fill then start the engine. Set the idle speed with the idle screw.

Remove the cylinder head. run the piston down to the bottom of the cylinder. look inside the cylinder. On th carb side (intake) you will see an intake port > a large hole that lets gas into the cylinder. Now look at the exhaust port. It is possible the exhaust port is pretty plugged up with carbon. The intake and exhaust ports should be approximately the same size. Are they? If not then remove the muffler and take a screw driver and plastic hammer and knock the carbon into the cylinder, thus enlarging the exhaust port to its' proper size and allowing the exhaust gases to escape. Vacuum the carbon out of the cylinder. De-carbon the piston top and the cylinder head.

Get back to me and tell me what you find. If more is needed we will go further.

Posted on Apr 12, 2009

  • tombones Apr 16, 2009

    Is the bike running now? What did you find was the problem?

  • richardgwynn
    richardgwynn Sep 18, 2012

    tombone id quite agree nice answer. !!

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2003 V Star 1100, I always run hi test gas and it has always ran fine . a couple of weeks ago on vacation it started to bog intermittantly(running on one cylinder)and would clear when the thr


There is no need to run anything other than regular gas in the bike, the extra octane only makes the VMax engines run hotter. I would start by adding about a half a can of Sea Foam to about a half tank of gas. Run it at idle until the new mixture is in the carbs 7 or 8 minutes ought to do it. Leave the bike sit overnight, then top off the gas tank and take the bike for a hard ride, ride it like you stole it, this should clear your problem. CV carbs also need to be synced once in awhile and should have been done if you rejetted.

Sep 09, 2014 | Yamaha V Star 1100 Classic Motorcycles

1 Answer

I have a honda 50 2007 and i took apart the carb cleaned it thoroughly, replace the on off valve and sdpark plug. it ran great for a couple of days. now it starts first kick runs for a minute or so then...


sticky float needle- run some seafoam through a tank of gas- also check for vacuum leaks as the petcock on bikes with a petcock are usually vacuum operated off engine vacuum.. if disconnected or leaky- that will starve the engine once the fuel in the float bowl is used up.

Jul 11, 2014 | 2007 Honda Shadow Aero

1 Answer

ProForce PWC102350 2,350 PSI 2.3 GPM 163CC MagnaForce Gas Powered Pressure Washer will not start


If you have compression then the first thing you check is for spark. If you have spark then you move on to the fuel system. You will have to pull off hoses at a couple of points to see if gas is at the carb and further along. If it is the carb then a simple carb kit will work.

Apr 13, 2014 | ProForce PWC102350 2,350 PSI 2.3 GPM 163CC...

2 Answers

Just turns off on it's own, Wait 60 sec. restart press pedel it dies.


This engine is electronically controlled so the first thing that must be done here is to have the systems control computer tested for fault codes and then do the proper diagnostics based on those codes.

Jun 07, 2012 | 1995 Plymouth Voyager

1 Answer

Pw50 leaks gas


Hi, Anonymous "ABSOLUTELY" and the usual suspects are:
1. Damaged or restricted fuel tank venting system.
2. Loose float bowl screws.
3. Damaged float bowl o-ring.
4. improper fuel level in the float bowl.
5. Worn or dirty inlet valve or seat.
6. Damaged or leaking float assembly.
7. Particle contamination in inlet fitting cavity.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
PW50 carb won stop leaking fuel
Yamaha PW 50 checking carb
https://books.google.com/books?id=ozV8-Aer4N8C&pg=PA84&dq=pw50+manual&hl=en&ei=TCS2TcbdJ4PW0QG0z9jmDw&sa=X&oi=book_result&ct=result&resnum=1&ved=0CGUQ6AEwAA#v=onepage&q=pw50%20manual&f=false
OEM parts for Yamaha
Yamaha PW50Y Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


Jun 01, 2012 | 2005 Yamaha PW 50

1 Answer

My bike seems to bog im not sure if its the gas or a stretched throttle cable but it sat for awhile and i took it into getting everthing fixed it runs great just feels sluggish threw my throttle


If the bike sat for quite a while, and you didn't drain the tank and carbs, your gas probably gummed up the carbs, jets, needles, etc. If you had them cleaned... this wouldn't be the problem although it could still be a fuel problem. Have you checked the fuel filter? I have found that using a gas stabilizer when the bike is not in use, keeps this from happening.

Before I ever take my bike into the shop, after winter sitting, I always run a mixture of Sea Foam (get it at Wal-Mart) with a full tank of gas for the 1st run of the season. This will take care of most fuel issues.

Hope this helps!

Jan 08, 2011 | 1975 Yamaha RD 250

1 Answer

Have 87 Evinrude outboard 48hp 2cylinder hesitations at high rpm ,but only very seldom like every few hundred yards cleaned carbs ,new plugs, checked spark, compression120 both cylinders newfuel lines new...


Make sure "advance/****** linkages are working properly, look for play and broken springs.
Check exhaust is not obstructed , may need cleaning.
Is fuel old or incorrect oil mix?

Mar 24, 2010 | Boating

1 Answer

93 fat boy will not continue to run once started and wont restart


sounds like a fuel supply problem it probably has some build up in the fuel system from sitting so much, if it has a screen in the bottom of the tank it could be clogged with sediment from the fuel sitting. or in the filter if it has one could be clogged with old gas or dirt particles. Clean the tank if needed, unhook fuel line at engine and make sure there is flow from the tank. I sometimes blow air through the line back up to the tank to back wash any problems.

good luck

Mar 28, 2009 | 1993 Harley Davidson FLSTF Fat boy

Not finding what you are looking for?
1972 Yamaha XS2 Logo

466 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

vince

Level 3 Expert

1234 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1176 Answers

D. E. Hev

Level 3 Expert

1187 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...