Question about 2003 Hyosung GV 125 Aquila
When cold my hyosung aquilla will only start on a push start but not on the electric start. When started she runs fine and there is no problem with compression had a engine rebuild as i brought the bike as a none runner. petrol is getting through to the carbs and there is a good spark.
Posted by Anonymous on
Do you get anything at the push button? Might be worth checking the condition of the battery, the starter solenoid, the main fuse and the starter itself as this sounds like an electrical issue. See if you can get the battery tested 'under load' as the cold can make old batteries sluggish.
Posted on Aug 21, 2018
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
When you rebuil the top end and pulled the power valve off did you put the screws bacvk in to the valve arm before puting the case and top end on cause you will either be closed or wide open on valve.and did you put the reeds back in? and make sure the floats are right and all jets are back in it the right way. try that
Posted on Jul 08, 2009
possible bad rings allowing excessive oil seep up and wash spark out on next fire. do a compression check, ck for proper spark, and fuel....hope this helps
Posted on Sep 13, 2009
Testimonial: "cheers i will compresion test and let you know"
recheck the carbuator...blow compressed air to its jets.Check the float level.Try fitting a new spark plug.
Hope this helps!
Posted on Oct 13, 2009
Tips for a great answer:
Mar 30, 2018 | Hyosung GV 650 Aquila Motorcycles
Jan 20, 2014 | 2003 Honda XL 125 V Varadero
Mar 15, 2017 | 2008 Hyosung GT250R
Dec 25, 2017 | 2009 Hyosung GT 250 R
May 23, 2017 | 2008 Hyosung GT250R
Jul 04, 2009 | 2001 Hyosung RX 125
Apr 03, 2009 | 2001 Hyosung RX 125
26 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: