Xerox Phaser 8500/DN Printer "drum signal" Questions

Ad

Question about Xerox Phaser Office Equipment & Supplies

1 Answer

...drum encoder wheel. This can be caused by the wave amp board. A cracked capacitor on the board causes the wave amp to produce a malformed amplified wave signal to the printhead. This in turn causes ...

Ad

Question about Xerox Phaser Office Equipment & Supplies

2 Answers

...Drum motor error DMOTRDYN signal does not go low within 2 s after DMOTONN signal goes low. The cause is; Defective harness between drum motor and engine PWB (YC11), or improper connector insertion. ...

Ad

Question about Canon Office Equipment & Supplies

4 Answers

signal cycle is not as indicated (±2%). During the WMUPR period after the power switch has been turned on or the front cover/left cover has been opened/closed, the drum unit is absent. Possible cause:

Question about Xerox Phaser Office Equipment & Supplies

1 Answer

...drum end soon" signal on for about one month You will need to replace the Drum unit with a new one. To try to get it working for a short temporary fix, clean the Drum corona wire - might work, might ...

Question about Xerox Phaser Office Equipment & Supplies

2 Answers

...Drum/ development bias output error An error signal is detected for 0.2 seconds when charging the drum or development.  High voltage leak  Broken harness  Defective drum unit or development unit  ...

Question about Toshiba Office Equipment & Supplies

1 Answer

...the imaging drum before a jam signal is issued. Did you get the drum shaft reinstalled and latched? If not, the drum won't rotate correctly which will cause poor transfer (smudged image) and

Question about Xerox Phaser Office Equipment & Supplies

1 Answer

Brother HL-5140 laser printer - drum signal light flashing on and off at 2-3 sec intervals. What do I need to do? drum life is near to end replace the drum now to solve the problem.

Question about Riso Office Equipment & Supplies

1 Answer

riso rp error t98-526 526 Drum set safety switch is ON, but drum connection signal is OFF. try to remove the drum and re-install it. hope to be of help

Question about Canon Office Equipment & Supplies

1 Answer

...signal cycle is not as indicated (±2%). During the WMUPR period after the power switch has been turned on or the front cover/left cover has been opened/closed, the drum unit is absent. Possible ...

Question about Canon Office Equipment & Supplies

1 Answer

...signal cycle is not as indicated (±2%). *During the WMUPR period after the power switch has been turned on or the front cover/left cover has been opened/closed, the drum unit is absent. Possible ...

Not finding what you are looking for?
Xerox Phaser  8500/DN Printer Logo

548 questions posted

Ask a Question

Usually answered in minutes!

Top Xerox Office Equipment & Supplies Experts

Clive
Clive

Level 3 Expert

4345 Answers

Philip Hughes

Level 2 Expert

80 Answers

docukaaf

Level 1 Expert

38 Answers

Are you a Xerox Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...