20 Most Recent Kenmore 53092 / 53094 Side by Side Refrigerator - Page 3 Questions & Answers


Good Day,
If the water dribbles from the outlet after filling the glass normally, then the cause is the dual water valve located in the bottom rear of the machine. The diaphram inside the valve is not sealing completely when power is removed.
The valve is a dual unit for the ice maker and water in the door.
It is none servicable and must be replaced with a new one.
It's a common problem and replacing it is not difficult and the valve would be carried by any decent sized appliance parts house.

Kenmore 53092 /... | Answered on Jul 17, 2010


Hi,
There are a few reasons why the refrigerator part will not cool...here are a couple of tips that will help you to figure out why the refrigerantor is not cooling...

Refrigerator2_bing.gif not Cooling or Fridge not Cooling
http://www.fixya.com/support/r3662945-refrigerator_not_cooling_or_fridge_not

How to Defrost Refrigerator Defrost Timer Problem
http://www.fixya.com/support/r3771673-defrost_refrigerator_defrost_timer

heatman101

Kenmore 53092 /... | Answered on Jul 12, 2010


CK THE ICE MAKER WATER INLET TUBE IT MAY BE ICED AND CAUSING THE WATER TO RUN DOWN THE BACK / ALSO CK THE DRAIN IN BOTTOM OF FREEZER / A VERY COMMON PROBLEM . THIS WILL ICE THE BOTTOM OF FREEZER FLOOR AND RUN OUT ON FLOOR .. .. MM HOPE THIS HELPED ..

Kenmore 53092 /... | Answered on Jul 01, 2010


The articles here may help you debug the problem:

http://www.fixyourboard.com/techzone.html

Kenmore 53092 /... | Answered on Jun 20, 2010


You could just replace the lever. repairclinic.com should have the lever. Just put in your model number and search. You can also try appliancepartspros.com

If you want to try fixing it again, May I say that you may want to put some other kind of piece on the back side of the lever and glue that piece onto both parts of the lever to keep it from breaking.

Benjamin

Kenmore 53092 /... | Answered on May 29, 2010


No, there is a heater in the seal of the doors to keep the doors from icing up, if it is hot to the touch then the heaters are going bad and must be replaced. You can replace it yourself by removing the door seals, and then removing the heating element that runs the whole door. When you do this make sure that the unit is unplugged.

Kenmore 53092 /... | Answered on May 17, 2010


If the filter is at the bottom , under the door ,, there should be a button to push or some latch to open to release the filter ..

Please vote!!

Kenmore 53092 /... | Answered on May 13, 2010


IN THE KICK PLATE BELOW THE DOORS.

Kenmore 53092 /... | Answered on Apr 24, 2010


I'm uncertain as to your approach to the actual repair of the tubing, but when you turned the water off and then on some sediment may have clogged the water inlet screen for the icemaker. Turn the water off and check the water inlet screens for a possible clog. If not clogged, contact an appliance service company.

Kenmore 53092 /... | Answered on Apr 14, 2010


your problem is in hte freezer area open the panel in your freezer you might need a new heat element or a new thermostat unit... not so bad to do or check...
arik from 911.servicetoday.com

Kenmore 53092 /... | Answered on Jan 01, 2010


Normal 0 MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-fareast-font-family:"Times New Roman";} Is the freezer cold enough? Should be close to 10 degrees.
Is there water or ice in the ice mold? If not put water in it and see if it dumps the ice after it’s frozen. If there is ice, lift the cut off arm and let it drop to see if it will start.
If it does dump the ice but don’t refill with water.
Try swapping the wires on the dual water inlet valve. Then try the water dispenser. The water should go to the ice maker. This will tell you weather or not the ice maker valve is working and if the line is clear.

The water inlet valve on the back of unit opens when the ice maker needs water. If the valve doesn't seal good because of sediment or wear it will continue to drip and when the water reaches the ice maker supply tube it will freeze. You can take the water line off the valve and watch to see if it drips.

Kenmore 53092 /... | Answered on Dec 11, 2009


It very well could be the auto-defrost feature since it is activated at the same time. Do remove rear access panel and make sure there is water draining into the evaporator tray built on top of compressor. If the water is not draining, run a pipe cleaner inside to check for cloggs, and make sure water drain hole is big enough to drain the wire.

Kenmore 53092 /... | Answered on Nov 18, 2009


You need to replace the thermostat . When the thermostat temperature is reached , it will cycle the compressor off . When time to come back on , it will not start . Instead of turning the thermostat off , try tapping on the thermostat knob . If the unit starts , this will confirm that the thermostat needs replaced .

Kenmore 53092 /... | Answered on Oct 15, 2009


The water filter is that round looking thing at the bottom of the refrigerator on the front grill. I can see it in the picture you provided. Sometimes, in higher end models, there will be a cover that turns and snaps out. Most units just have a place to grab with your fingers and turn counter-clockwise (to the left as if you were unscrewing it), but don't unscrew it. It only takes a quarter turn to disconnect the filter.
Pull out what you just disconnected and you will have in your hand a plastic (or metal) canister that is the filter. Go buy an exact replacement and usually you have to take the "handle" you used to remove it off the old filter and place it on the new filter.
Oh, probably a good idea to turn your ice maker off and block anyone from using the water dispenser or better yet: pull the refrigerator out and turn the water off.
Good Luck!

Kenmore 53092 /... | Answered on Oct 12, 2009


Don't you mean your CONDENSER (the black tubes found at the back of your unit or below it ? Those are the ones that dissipate the heat - if they are at the bottom, there is usually a fan blowing air on it, if applicable, check to see if it is spinning, when the compressor is on.

The EVAP coils are the ones you find when you remove the freezer's back panel, you will see a fan there, blowing the cool air from the evap coils.

If the evap coils in your freezer are over frost it will cause cooling problems, in which case your defrost system is not functioning and you will need to change the control board and have the defrost components checked to make sure everthing else is working.

Kenmore 53092 /... | Answered on Sep 26, 2009


Yes, Airflow is what cools the frig. Check for frost buildup on the coils indicating a problem in the defrost components r a fan not running fast enough. Eric

Kenmore 53092 /... | Answered on Aug 19, 2009


You could either need a water valve or a new ice maker. How old is your icemaker? I'd look at the water valve first since it's less expensive. We have parts if you need to call us. We start answering our phones at seven am cst. Hope this helps! Ella :>)

Kenmore 53092 /... | Answered on Aug 18, 2009

Not finding what you are looking for?
Kenmore 53092 / 53094 Side by Side Refrigerator Logo

107 questions posted

Ask a Question

Usually answered in minutes!

Top Kenmore Refrigerators Experts

Fred Sops

Level 2 Expert

351 Answers

Audrey Messer
Audrey Messer

Level 2 Expert

182 Answers

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Are you a Kenmore Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Kenmore Refrigerators

  • Kenmore Refrigerators

Most Popular Question

door seal between fridge amp freezer

  • Refrigerators
Loading...