20 Most Recent Motorola Talkabout T5420 (14 Channels) 2-Way Radio Questions & Answers


There is no repair guide. M never wanted these repaired. I suspect liquid damage. Get a small Torx screwdriver, likely a T-6 and unscrew all the screws, making certain you located the one near the antenna. Open? Look at the main board. If there is a whiteish coating, it is liquid corrosion. If you want to try repair, get some rubbing alcohol, a clean rag and q tips. Start with the rag, dip and rub, but not hard. Do not dislodge the small parts on the board! Then move onto the q tips for smaller areas. This can easily take 30 minutes to do a good job. So, you have an hour a radio into the repair, maybe more and no guarantee it will work when done. You can test the radio while apart by holding the battery to the contacts. Best of luck!

Motorola... | Answered on Jan 18, 2018


Take the radios back to a very basic setting with all special features turned off. If the radios have a Qt filter check to see it is turned off, and set your Code to zero (off) on both units. Also, check to see your battery is good in both units. Trade the battery with a known good radio to see if the problem moves to the other radio, is a simple test.

Motorola... | Answered on Sep 10, 2017


http://shop.giantintl.com/Manuals.asp?offset=30

Motorola... | Answered on Dec 17, 2015


See the red LED is lit when you pressing the PTT. If it is working then you need to see the Radio hardware side specially PA and associated circuit. Also see when you press the faulty Radio PTT your good radio have any response. See its green LED lit or you hear any click sound.

Motorola... | Answered on Nov 06, 2015


Here is a link to the user guide for the T5420 http://content.giantintl.com/manuals/Moto/T5320_T5410_T5420_User_Manual_E.pdf
Programming instructions start around page 15.

Best regards.

Motorola... | Answered on Oct 27, 2014


The rubber key cover is one piece and not sold as a spare part. Take the radio apart, remove the pad and put a thin tape, such as a very high quality electrical tape and a small amount of RTV silicone under the tear. Reassemble, wiping off any extra RTV as you go.

Motorola... | Answered on Nov 12, 2013


The CTCSS (receive code) is not set to match the transmitting radio. They must both have the same code set in order for you to hear each other.

Motorola... | Answered on Nov 07, 2013


A few things you might check:
1) Be certain the radio is turned off when plugging in any audio device.
2) Be certain the device is plugged in all the way. You should feel it seat, or click into place.
3) Use a device designed for your model radio. Aftermarket accessories don't always have the functionality of the OEM device.
4) Be certain you have special features such as VOX turned off on your radio.

Hope one of these helps.
Best regards.

Motorola... | Answered on Mar 27, 2013


The corroded batteries may have been one indication of a more serious problem

Motorola... | Answered on Mar 01, 2013


I am looking for the same wiring diagram. The headset Moto sells is a single earpiece with microphone, so how does that end up being a stereo connection Neto? Just curious how, or is there also a full headset with microphone? ( I dont' know, just asking)

Would this be a 4 ring TRS connector? Sleeve = ground, then left, right, and the tip as the microphone??

Motorola... | Answered on Nov 17, 2011


Hi,

You can download and print the instruction manual in PDF format by clicking this link.

Adobe PDF Reader is required to view this manual. Download Adobe Reader

Hope this helps. Kindly let me know if you have any difficulty in downloading the manual.
Thanks for using FixYa

Your feedback is important to us!

Kindly rate and accept the solution if it helps you.

Motorola... | Answered on Sep 08, 2011


Possible that the earpiece is defective or there are errors in the circuit. The earpiece can be checked using multimeter, if open must be replaced.
If not there is fault in the circuit and must be probed with a signal tracer

Motorola... | Answered on Feb 19, 2011


Check to see your interference eliminator code and Qt filter (if any) are set identical among your radios. For basic operation, set these to off (zero).

Here is a link to the user guide: http://www.giantintl.com/ContentManage/manuals/Moto/T5320_T5410_T5420_User_Manual_E.pdf

Best regards.

Motorola... | Answered on Jan 11, 2011

Not finding what you are looking for?
Motorola Talkabout T5420 (14 Channels) 2-Way Radio Logo

45 questions posted

Ask a Question

Usually answered in minutes!

Top Motorola Radio Communications Experts

eradiostore
eradiostore

Level 3 Expert

1655 Answers

Anthony Ward
Anthony Ward

Level 2 Expert

396 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Motorola Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Motorola Radio Communications

  • Motorola Radio Communications

Most Popular Question

am looking

  • Radio Communications
Loading...