20 Most Recent GE GSS20IEPWW / GSS20IEPCC Side by Side Refrigerator - Page 2 Questions & Answers


Check and make sure you are getting water to the icemaker, If sothe lines may be frozen. You can thaw them with a hair drywe.

GE GSS20IEPWW /... | Answered on Apr 19, 2012


If your not getting any power to the unit and the breaker is not not tripped, you will need to replace the control board located on the rear of the refrigerator. Here is a link to the part you need.
http://www.appliancepartspros.com/Appliance-Parts/ge-main-control-board-assembly-item-number-ap4436216.aspx

GE GSS20IEPWW /... | Answered on Dec 04, 2011


:
Hi!
A relay starts the compressor with a higher voltage and then quickly kicks out
It does a lot of clicking (trying to start over and over again)
If thats what is happening with yours
Its best for a tech to replace The relay but you can do it
Take your model number to your Local Appliance parts store they will have a diagram
showing you how to install the relay. Its called a hard start relay
I use part no ERP410 POWER START RELAY, CAPACITOR AND OVERLOAD all in one. (110 v)

If you still have trouble Go Here:

http://www.applianceaid.com/procedures.html

Thank you for using fixya
Leo Ponder
PLEASE VOTE FOR ME IF THIS WAS HELPFUL

GE GSS20IEPWW /... | Answered on Sep 06, 2011


Most of these units will have a filter in the refrigerator side in the upper right corner. If someone removed it and maybe couldn't afford a new one at the time they could have used the bypass plug. It will just be a flat 3-4" white handle that you must twist out counterclockwise. Hope this helps.

GE GSS20IEPWW /... | Answered on Jun 19, 2011


Most ice makers have a control arm that raises and lowers to check for a full condition. It usually raises during the dump cycle and lowers during the fill cyle. If it is unable to lower (because the bin in full) it should shut off the fill cycle. If that function is not working, then if you move that control arm to the fully raised position, it should shut of the fill cycle, until you manually lower it again.

GE GSS20IEPWW /... | Answered on Jun 04, 2011


If there is no frost on the rear wall , inside the freezer , then the main control board is bad . This board , is located behind the refrig , behind an 8 " X 10 " panel . The part number is WR55X10656 . This board , probably has a burnt compressor module , keeping the compressor from running . The board is easily replaceable .

GE GSS20IEPWW /... | Answered on May 16, 2011


Empty the freezer. Unplug the fridge. Take all the shelves and drawer out of the freezer. Remove the lightbulb cover and bulb. Take out the screws that hold the panel on the back of the freezer wall. Slide the panel up slightly to clear the thermistor housing (a small 'bump' on the bottom left side) and remove the panel pulling from the left side forward. The defrost heater is on the bottom of the coils held on by two screws, and the thermostat is clipped on to the top coil and has pink and blue (sometimes orange) wires going to it. Don't worry if the wire colors on the new one are not the same. Unclip the thermostat and cut the wires, leaving yourself enough wire to strip them back and connect them with the new ones. Use crimp connectors or wire nuts (for wet applications) and then clip the thermostat back on. To replace the defrost heater, remove the two screws and disconnect the wires. The new defroster might have both wires on one side, rather than one on each side. That's okay, just move the wire on the left over to the right along side the other wire, and connect. Put everything back together, and plug back in.

GE GSS20IEPWW /... | Answered on Mar 19, 2011


your mother board is acting up you will need to find the model number its in the ref. towards the top on the right or left.I saw this once before and it blew my mind to until I talked to tech line.

GE GSS20IEPWW /... | Answered on Mar 15, 2011


there is a anti-freeze kit available. u will have to completely dry the motor first. (if you hold it long enough the heat will build up in the motor and thaw itself)but will freeze right back.

GE GSS20IEPWW /... | Answered on Mar 12, 2011


Hi,

Check out these tips...they can help you figure out what is going wrong with your refrigerator and why it is not cooling

Refrigerator not Cooling or Fridge not Cooling

How to Defrost Refrigerator
Defrost Timer Problem

Water Running in refrigerator from Freezer

Refrigerator or Freezer not Cooling or Getting Cold


heatman101

';';

GE GSS20IEPWW /... | Answered on Mar 11, 2011


Is there food near any of the vents? if ther is then you have to make sure that all of the food near the vents is clear and there is not a solid block of ice behind the racks in the freezer neer the coils.

GE GSS20IEPWW /... | Answered on Feb 28, 2011


. The next time the noise starts , open the freezer door and see if that is where the noises coming from . If yes , replace the circulation fan located in front of the evaporator assembly . If the noise is coming from the bottom of the unit and you can hear it clearly with the doors closed , more than likely it would be the condenser fan located next to and sometimes even mounted on the condenser assembly . If the unit has a static condenser , which will be indicated by the metal lines running up and down and all around the back of the unit itself , there is no condenser fan . The squealing noise you hear is a bad bearing in one of the motors . As the motor shaft spins , it actually wobbles within the bad bearing as too much clearance between the two exists .

GE GSS20IEPWW /... | Answered on Feb 19, 2011


not that long.did you turn the controls on in the fridge side?also did you follow the instructions that came with the new board.if there's a wire in the second pin on j1 you have to cut it,then behind the inside freezer wall there's a sensor that you have to look at,if it has a black ring around it it has to be changed and should of been when you changed out the board or you could have cooked the new board too.the part number is WR55X10025 and it's 7 dollars on the sears site.it's on top of the evap coil and it's white and looks like a bullet.what were you using the hair dryer for?g.e. has a recall on the boards you could of called them and they will come and change it out for you but i don't think they will now because you touched it,maybe just don't tell them that you touched it and put the old board back in.also go here and check out this site
http://fixitnow.com/wp/2009/11/30/ge-refrigerator-motherboard-recall-list/

GE GSS20IEPWW /... | Answered on Feb 01, 2011


Chances are if they are getting cool -

1) the evaporator fan in the freezer is not running
2) Defrost heater has failed
3) Defrost sensor has failed
4) Defrost timer/refrigerator control has failed.

Check for ice build-up on the back wall of the freezer. If there is ice, unplug or turn the unit off for 6-8 hours with the doors open (put any food in a cooler with ice to maintain). Note water may come out of the refrigerator.
Plug the unit back in or turn it back on, close the doors, and check temperature after a couple of hours of operation. If all OK, you will need to have the above tested, or, if you know how to use a multimeter and can read a schematic/wiring diagram, I can instruct you on how to check the above.

GE GSS20IEPWW /... | Answered on Jan 29, 2011


first thing is to check the defrost heater if it looks black it is bad the part number for the heater is wr51x10053
i have replaced a ton of these

GE GSS20IEPWW /... | Answered on Dec 17, 2010


no it is not possible because while assembling the fridge all the parts are assembled saperately

GE GSS20IEPWW /... | Answered on Dec 13, 2010


With GE this is a common problem. There is a control board located on the back of the machine that operates everything to do wih the machine. If you pull the machine out from the wall, you'll notice an aluminum plate with 1/4 inch screws around it (not the one that runs across the bottom of the machine.) Its usually on the right side if you are standing behind the refrigerator. If you remove the plate, you'll be able to see the board and more than likely, but not always, see a burnt spot in the board. You part number for this is WR55X10942 and will run you about 161.28 from apdepot but you may be able to find it cheaper else where.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3

GE GSS20IEPWW /... | Answered on Dec 06, 2010

Not finding what you are looking for?
GE GSS20IEPWW / GSS20IEPCC Side by Side Refrigerator Logo

116 questions posted

Ask a Question

Usually answered in minutes!

Top Refrigerators Experts

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Ron Beer
Ron Beer

Level 1 Expert

11 Answers

vince

Level 3 Expert

1234 Answers

Are you a Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

GE Refrigerators

  • GE Refrigerators

Most Popular Question

replace board upon replacement

  • Refrigerators
Loading...