20 Most Recent GE (PSS26MSRSS) Side by Side Refrigerator - Page 9 Questions & Answers


WILL THIS HELP?

GE (PSS26MSRSS)... | Answered on Apr 20, 2014


I USUALLY REPLACE MAIN BOARD WITH EVAPORATOR FAN MOTOR AT THE SAME TIME. CHECK HOW ITS DONE ON MY YOUTUBE CHANEL. HOPE THAT WILL HELP.

GE (PSS26MSRSS)... | Answered on Apr 19, 2014


If your compressor is not running you would first check the start relay in the unit with a multimeter shown here in this diagram http://www.repairclinic.com/PartDetail/Start-Relay/WR07X10084/1091640
remove the relay from the compressor and inspect it thoroughly. If you shake the relay lightly if you hear a rattling sound inside this is one way to assure the relay is defective. If there are any electrical burns on the relay as well is also a sign of a defective relay. Here also is a video on how to check the relay as well click here http://www.youtube.com/watch?v=9kK9cJtgCXo

If you have any further questions or the relay tests good message me back for further diagnosis. I await your reply
Thank you,
Rick

GE (PSS26MSRSS)... | Answered on Apr 13, 2014


What is the question?

GE (PSS26MSRSS)... | Answered on Apr 13, 2014


Jim, Pc Er is a Communication circuit failure on main board or
Communication circuit failure on control panel board
Could be a loose or corroded connection, a bad mother board or a bad display board. Before doing anything, unplug the refrigerator for 5 min and plug it back in. This may reset the motherboard. If not, check the comm cable at the display and the motherboard. if ok, then you will need to replace either the motherboard or the display board. There is no way of determining which one to replace.

GE (PSS26MSRSS)... | Answered on Apr 11, 2014


Hi, wow a long way from the U.S., Ca. lol. This sounds as though you are having a drain problem and the condensation is building up and running out onto floor. I would remove all drawers in the area that you suspect the water to be, and see if you can locate a drain on this unit. I haven't pulled up any drawings of this model, but It is sure to have a condensation drain on it. When you find it, use what ever means you may have to clear it. A tank of compressed air would work, but most people don't have one around. Something to blow through it with enough pressure to clear it. Maybe even a small container off hot water poured into it could free what ever is in it. This is where you need to start anyway. I will check in with you later as I have service calls to make. You can let me know what you may have found then. Good Luck Mate, and keep me posted.
Sincerely,
Shastalaker7

GE (PSS26MSRSS)... | Answered on Apr 05, 2014


Hi,

You are looking for the water source, two possible places to look. Look around the water filter and the glass shelves for water, also check the water tank behind the crispers, as I have seen them crack in the past. Good luck, hit me up if you need more information.

I’m happy to help further over the phone at https://www.6ya.com/expert/gere_bf68e6055dd61249

GE (PSS26MSRSS)... | Answered on Apr 02, 2014


There is more than one fan on your refrigerator I think you mean that the bearings and not the bushings are bad which could be true just have to figure out which fan it is.

GE (PSS26MSRSS)... | Answered on Mar 30, 2014


Sounds like your Defrost heater is burned up. It is located in the back of the freezer compartment behind the lower cover. Look at the base of the condensor. Two screws hold the heater and two wire connectors. The heater is in a glass tube. Measure continuity from one end to the other, you should see a few ohms. if it is open, your heater is definitely burned. I got a good deal on a replacement heater on Ebay. I think it was $17 including shipping. The heater being bad will cause major frost buildup in the back of the freezer and stop the Ice maker from working and damage food. Be sure to thorougly dry the freezer compartment prior to putting it back in operation. If too much moisture is present, the new heater will evaporate the moisture into the Ice dispensoer motor and solenoid that swtiches from crushed to solid ice. Hope this helps. it has nothing to do with your problem, but please Check out my website www.playstationclinic.com

GE (PSS26MSRSS)... | Answered on Mar 25, 2014


There is a solinoid in the freezer section by the motor that turns the ice auger. Test it by selecting cubes and with the ice bucket out, open the door, hold the door switch so the lights turn out and push the dispenser button. It should make a loud snap and travel upward. If not then I would say you have a bad solinoid. If it does, then I would look at the bucket. the metal rod that runs along the side of the bucket opens a flap in the bucket that is supposed to let the full cubes drop. look for anything that might cause it to be hanging up.

GE (PSS26MSRSS)... | Answered on Mar 25, 2014


Press the lock button and hold it for at least 3 seconds. This locks and unlocks the dispenser.

GE (PSS26MSRSS)... | Answered on Mar 22, 2014

Not finding what you are looking for?
GE (PSS26MSRSS) Side by Side Refrigerator Logo

3,776 questions posted

Ask a Question

Usually answered in minutes!

Top Refrigerators Experts

Brad Goodale

Level 2 Expert

106 Answers

Matt Sicignano

Level 1 Expert

7 Answers

JP Meneide
JP Meneide

Level 3 Expert

483 Answers

Are you a Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

GE Refrigerators

  • GE Refrigerators

Most Popular Question

freezer sound like cessna when fan goes

  • Refrigerators
Loading...