20 Most Recent HP Officejet 6500 Wireless All-in-One InkJet Printer Questions & Answers


call for Free printer Support. Call Toll Free Phone Number - 877-690-9305
hp printer support -3-5y1xerifmav3c1grzoip5vgk-2-0.jpg

HP Officejet... | Answered 20 hours ago


General error 0x610000F6 actually is a Carriage Jam issue
Click Here for troubleshooting.

I’m happy to help further over the phone at https://www.6ya.com/expert/jonathan_828b54f422cbefdd

HP Officejet... | Answered on Aug 05, 2019


For severe HP OJ 6500/6500A/7000 print quality/missing color issues, or incorrect color output, there could be an air bubble in the ink cartridge(s), an air gap between cartridge and PRINTHEAD, or a portion of the PRINTHEAD is dry (quite common), so you should first perform a CLEAN PRINTHEAD procedure from your printer control panel.
It is first suggested you print the SELF TEST or PRINT QUALITY REPORT (under TOOLS menu) to aid in identifying which color is causing the issue. Check that cartridge or cartridges to ensure they have plenty of ink inside.
NOTE: If one or more the colors were previously dry fired during printing (i.e. if you continued printing using only a few colors to one, air may have been accidently ingested into the ink lines between the cartridge(s) and PRINTHEAD. To recover from this problem, you may have to run the CLEAN PRINTHEAD procedure 2-3 times.
If a problem persists then it is suggested to review the steps outlined on the following HP 920 support pages, including printhead removal/printer cleaning and service station cleaning. It is suggested you refer to printer manufacturer instructions first as the Inkjet411 procedures are provided for general guidance purposes only. A dirty service station can cause poor image quality and/or ink cross-contamination between different colors:
http://inkjet411.retailinkjet.com/?page_id=1495
If the problem still cannot be corrected, then the PRINTHEAD may be dry and may need to be flushed (i.e. with warm water as it could have dried out, but this is a function of how much you print). Remove and thoroughly flush all ink ports for 2-3 minutes...thoroughly dry printhead prior to re-installing. Retest. For complete instructions refer to video here: http://inkjet411.com/?page_id=2412
Worst case scenario the PRINTHEAD may simply be electrically damaged or at end-of-life (while Officejet 6500/6500/7000 printer PRINTHEADS are rated for an estimated 15,000 pages, the average consumer may only see up to a 10,000 printed page throughput) and may require replacement. A severe failure of the PRINTHEAD is typically accompanied by error messages such as INCOMPATIBLE PRINTHEAD, REPLACE PRINTHEAD or INK SYSTEM FAILURE. NOTE: The PRINTHEAD will eventually fail in time. For more information on the how the PRINTHEAD works, watch the video here: http://inkjet411.retailinkjet.com/?page_id=1983
To verify Printhead electrical performance, activate the Tap 41 diagnostic test, (i.e. Pen Status: Pen OK).....for printer model instructions please visit: http://inkjet411.com/?page_id=1813
To solve other HP920 ink-series printer/printing related issues please visit http://www.inkjet411.com

HP Officejet... | Answered on Jul 14, 2019


Send the cartridges back! HP cartridges are coded and will only work with HP printers. Hp has had problems with their coded cartridges. Especially if they were manufactured overseas. Their own product won't recognize the cartridges. It is not the printer it is the cartridges.

HP Officejet... | Answered on Jun 30, 2019


Check this repair tip out. Works for me almost everytime:

HP Officejet... | Answered on Jan 30, 2019


This is a common error, but usually can be fixed without replacing any parts. See video:

HP Officejet... | Answered on Jan 30, 2019


1. Plug it directly into the wall, rather than into a UPS
2. Verify that the unit is switched on. Disconnect the USB/Ethernet cable from the All-in-One and also disconnect power cable from All-in-One and also from wall outlet.
3. Wait 30 seconds.
4. Plug in the power cable to All-in-One and also to wall outlet.
5. Check for the functionality.

I still had the error message, so they said to reset the printer to factory default settings:
1. Unplug the power cable from printer when the printer is powered on and wait for 20 seconds.
2. Then, press and hold # and 6 while plugging in the power cord.
Continue holding until it displays Semi Full Reset message in the front panel of the All-in-One.

If those two steps do not resolve the problem then its is hardware related and can't be solved here.

HP Officejet... | Answered on Jan 30, 2019


Try this. It worked for me a few times:

HP Officejet... | Answered on Jan 30, 2019


Here are a few suggestions or tips on how to fix this issue:

HP Officejet... | Answered on Jan 30, 2019


Download the manual for HP 6500,

HP OfficeJet 6500 Wireless Manual.

It is clearly mentioned in it.

-Rate if it helped you.

HP Officejet... | Answered on Oct 01, 2018


Software (driver) can be found at driverupdate us.
Take a look... I hope this was helpful.
Cheers

HP Officejet... | Answered on Sep 17, 2018


Hello
Same problem for me. found a procedure to get back to Service Menu which works for HP 8600 :
https://h30434.www3.hp.com/t5/Printers-Archive-Read-Only/X476dw-doesn-t-boot-Help/td-p/5044674
1. Unplug the power cord (!)
2. Insert power plug while keeping power button pressed.
3. While the HP logo appears on the screen, keep the button pressed. The screen will go dark. KEEP THE BUTTON PRESSED for another 5-10 seconds.
4. Let go of the button. The screen remains black.
5. Push Home-Back-Home-Home button. The buttons are usually not visible, so refer to the manual, where they are on the touch screen. (Home is left of the upper left corner of the touchscreen, Back is left of the lower left corner)
6. A blue menu comes up, with four choices.
7. MENU on the lower right has a FULL RESET option.

HP Officejet... | Answered on Sep 12, 2018


You use the Copy button to get to Reduce/Enlarge. It will offer different sizes (i.e. actual size, full page 91%, custom 100%, etc.) you enter OK at the Custom 100%, then you can enter whatever % you want up to 400. I hope this helps.

HP Officejet... | Answered on Aug 14, 2018


1-800-281-3707 is the Number of HP Printer Technical Support Phone Number. get Instant HP support by Dialing this Toll Free Number. We Provide HP Printer Technical Support Phone Number -800-281-3707 for fixing HP 6500 printer.

HP Printer Support Number 1 800 281 3707HP Printer Technical Support

HP Officejet... | Answered on Aug 11, 2018


first of all.. make sure that you remove the packing material from the cart or print heads and put them in properly.
then also if it it gives the same probem then try it with the old print heads.. if it doesnt gives any eror with the old ones then replace the new ones..
new ones are bad..
return them to store

HP Officejet... | Answered on Apr 05, 2018


Get the Diagnostic download for your 6500 from HP.com. It will trace the problem for you. Check you power supply to see if it is operational. Press all connections in tight.

HP Officejet... | Answered on Feb 04, 2018


reboot (unplug) both the mac and the printer. happen to my imac and 7620 at least once a week

HP Officejet... | Answered on Feb 04, 2018

Not finding what you are looking for?
HP Officejet 6500 Wireless All-in-One InkJet Printer Logo

1,534 questions posted

Ask a Question

Usually answered in minutes!

Top HP Office Equipment & Supplies Experts

Clive
Clive

Level 3 Expert

4345 Answers

Ekse

Level 3 Expert

13434 Answers

Thomas F. Schneider

Level 3 Expert

2715 Answers

Are you a HP Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

OfficeJet HP

  • OfficeJet HP

Most Popular Question

hp solution center software

  • Office Equipment & Supplies
Loading...