20 Most Recent Euro-Pro Shark 9110 Sewing Machine Questions & Answers


check and make sure the bobbin winder has returned to it's normal position for when you sew

Euro-Pro Shark... | Answered on May 10, 2016


sounds correct to me

Euro-Pro Shark... | Answered on Aug 09, 2015


First check that the thread in the bobbin is facinf the correct way. Then check tension on top. Also check to see if you have the same thread on top and in bobbin. Also needle and material can cause the bobbin to jump. Make siure that the needle thread stays where it should, if one of the threading sites come undone this can cause bobbin jump too.Hope something here helps.:-)

Euro-Pro Shark... | Answered on Mar 18, 2015


Check to be sure your bobbin is in correctly. so turn clockwise, others counterclockwise.

Euro-Pro Shark... | Answered on Mar 13, 2015


If you can turn the machine then I would say you probably need a new foot controller. Otherwise maybe something is caught in the machine.

Euro-Pro Shark... | Answered on Dec 23, 2014


Could be you are using the wrong needle. If it is too short it will not pick up the bobbin thread. Or your machine could be out of time.

Euro-Pro Shark... | Answered on Nov 04, 2014


Slide of the the little table with the accessories in.There is a feed dog adjustment lever at the back of the machine. sliding the lever to the 2 filled in arrows pointing down, will lower them and the 2 filled in arrows pointing up will raise them. The feed dogs will not rise up if you do not turn the hand wheel manually, even if the lever is slid to the right.You must make a complete turn of the wheel to raise the feed dogs.
Best wishes.

Euro-Pro Shark... | Answered on Jun 30, 2014


I have had problems with this too. But you can get them from Euro Pro about $10.00

Euro-Pro Shark... | Answered on Jan 23, 2014


There is a screw that holdsthe linkage together that rotates the bobbin holder, that screw might beloose. To replace it requires taking both the front and back covers off of theframe since the bobbin holder linkage is in the rear behind the needle area. Becareful to insure that the plastic toothed "rail" that runs thebobbin holder is positioned properly or it may break off a tooth. Once you replace it, it will catch the threadagain. AV

Euro-Pro Shark... | Answered on Sep 04, 2013


check to make sure the foot pedal is plugged into the machine correctly
also the foot pedal may need to be checked at a sewing machine repair shop to see if there is something wrong with the wiring or electronics.

Euro-Pro Shark... | Answered on Jul 12, 2013


Como puedo programar mi maquina

Euro-Pro Shark... | Answered on May 31, 2013

Not finding what you are looking for?
Euro-Pro Shark 9110 Sewing Machine Logo

65 questions posted

Ask a Question

Usually answered in minutes!

Top Euro-Pro Sewing Machines Experts

Irene Tulloch

Level 2 Expert

498 Answers

MissFixIt828

Level 1 Expert

70 Answers

Thomas F. Schneider

Level 3 Expert

2715 Answers

Are you an Euro-Pro Sewing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Euro-Pro Sewing Machines

  • Euro-Pro Sewing Machines

Most Popular Question

mi maquina de coser no da puntadas

  • Sewing Machines
Loading...