20 Most Recent Dell 2200MP Multimedia Projector Questions & Answers


even if a fan spins it still can be noisy.clean all fans (i use a tooth brush).i also buy air in a can..(poundshop sells them).and spray them to clear any dust.when you have done that start the projector and see if is sorted...

Dell 2200MP... | Answered on Nov 02, 2017


buenas noches. tengo un problema con mi proyector.. hace unos minutos encendio y se veia la imagen pero luego lo desconectaron y cuando volvi a encender solo prende la luz de power pero no sale la imagen quen podra ser???

Dell 2200MP... | Answered on Oct 11, 2017


for any friends who is looking for optoma projector color wheel, DV10, HD20, HD70, HD70i, etc, please freely contact me, i'm a professional wholesaler and net retailer on projector spare parts, most of brand and all series, lens, color wheel, bulb and remote.
Jack

flying200809@gmail.com

Dell 2200MP... | Answered on Oct 14, 2016


if not even an led comes on, you need to replace the power supply.

Dell 2200MP... | Answered on Aug 06, 2014


its even not available at dell. i've spent an hour looking for that freakin part number and found none!!
_dell sales

Dell 2200MP... | Answered on Jul 02, 2012


You will found that there are some mirrors (4 of them, making a 'tunnel')just behind the color wheel. I assume these mirrors are positioned tohelp focus the light from the lamp into the first lens element making a sharpand bright beam to be then hit the DLP chip. These mirrors are betweenthe color wheel and the first lens element. These mirrors mayhave come loose inside the assembly, and may be sliding around. Check ifone mirror was broken on the corner. A broken mirror caused the light is notbeing properly focused on the DLP chip resulting no image as well as themirrors distorting the light beam causing the darkened wavy shadows in the image. It also couldbe the lamps ballast that is your issue or the lamp counter reset might havegone bad on you. Most dells the ballast would be the problem area. The ballastis what the lamp connects to. That is what powers the lamp. When those go badyou will this type of problems. Check the lamp again, check the lampdoor, and finally check the ballast. AV

Dell 2200MP... | Answered on Jun 13, 2011


Yes, it can be replaced; but Dell replacement parts are very hard to find. Also, it is tricky to open the equipment and not damage any other parts during the process. If you don't work on electronic equipment, I would take it in for service. Other suggestions on the web say to buy a used one for replacement parts if you want to do the work, because they cannot find service manuals or parts - except for bulbs. The color wheel for my Toshiba was $160, and the lamp was bad at the same time.

Dell 2200MP... | Answered on Feb 10, 2011


there is a problem with the power to the front fan from the main board. there are 3 wires going to the fans: one power, one return, and one signal. if the main board reads no signal from the fan's speed, it'll shut down. check the power going to the fans and the signal. you may need to replace the main board.

Dell 2200MP... | Answered on Feb 04, 2011


In system preferences, open Display and select Video Mirroring "On".

Dell 2200MP... | Answered on Jan 14, 2011


This is usually caused by dust getting on the mirrors. You will have to take the projector apart to clean the mirrors. Also I am going to include instructions for Self Diagnostics.

Self-diagnostic for video
  • Dell 2200MP projector provides self-diagnostic test of the projector video display (for Video, S-video, Component-I). Use this advanced feature for preliminary self-diagnostic on your projector when encountering the display problem for video.
  • After turning on the projector, press "+" and "-" buttons on the control panel simultaneously and release the buttons when screen goes blank.
  • Contact Dell if the projector doesn't enter diagnostic mode or if the colors are incorrectly displayed.
  • Press "+" and "-" buttons again to exit the diagnostic mode.
  • While in Self-diagnostic mode, the screen will run a seven-color-cycle test as following: "Red--> Green--> Blue--> White--> Watchet Blue--> Dark Green--> Yellow." Ensure that the colors of the test pattern are correct.

Dell 2200MP... | Answered on Nov 03, 2010


One person reported vertical black banding on the right of the screen, and someone told them it was a bad control board. I would contact Dell Support and see what they say. I've also heard of fan noise on these devices, but I wouldn't think that's what's going on in this case.
Here's Dell Support's site:
http://support.dell.com/
Good luck, and hope it's just an adjustment.

Dell 2200MP... | Answered on Sep 17, 2010


Try changing the screen resolution to a lower resolution like 640x480

Dell 2200MP... | Answered on Aug 25, 2010

Not finding what you are looking for?
Dell 2200MP Multimedia Projector Logo

78 questions posted

Ask a Question

Usually answered in minutes!

Top Dell Office Equipment & Supplies Experts

jasbo
jasbo

Level 3 Expert

2239 Answers

The Knight
The Knight

Level 3 Expert

76140 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Dell Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Dell Office Equipment & Supplies

  • Dell Office Equipment & Supplies

Most Popular Question

mi proyector empieza encender y se

  • Office Equipment & Supplies
Loading...