20 Most Recent Hitachi 36UX01S 36" TV Questions & Answers


Enter factory mode, and do a factory settings. If you wish to get some details; check the site linked here. Viewing it in "Mosaic" will make surf easy.
http://electronicshelponline.blogspot.com/

Hitachi 36UX01S... | Answered on Mar 21, 2014


To do a factory reset, you have to enter its service mode. If you wish to get some details; check the site linked here. Viewing it in "Mosaic" will make surf easy.
http://electronicshelponline.blogspot.com/
Service mode entry, adjust and exit procedure to many popular brand TVs are given.

Hitachi 36UX01S... | Answered on Mar 21, 2014


the audio is plugged in but your video isn't plug your video in and you should see a picture

Hitachi 36UX01S... | Answered on Aug 30, 2012


You have a vertical output IC that needs repaired. You may need to only resolder the vertical output IC. If then you do resolder, you will need to check and replace any capacitor in the immediate area of the vertical IC. A weak or bad capacitor will heat up the IC, and create rings on the pins under the IC. Also check the solder grounds on any resistor and diode that are immediately near this IC. This will bring your TV back to full view. Thanks for asking and show a few hands of support!

Hitachi 36UX01S... | Answered on Oct 04, 2010


try to replace the vertical ic and resolder the vertical section.

Hitachi 36UX01S... | Answered on Sep 16, 2009


the set will not operate with out proper vertical signal/deflection. you may have bridged pins together when resoldering. use a 25w or 35w soldering iron so as not to lift copper traces from pc board. always use solder wick to remove old solder and DO NOT keep on pad to long. mch

Hitachi 36UX01S... | Answered on Feb 20, 2009


RELACED THE VERTICAL OUTPUT IC ALONG WITH THE CAPACITOR AROUND IT.6 YEARS IS ENOUGH FOR THE CAPACITOR 2 DRIED UP THIS CAUSE FAILURE TO THE IC...

Hitachi 36UX01S... | Answered on Mar 08, 2008


The set has a vertical problem if the line you mention is from side to side ,if the line is from top to bottom the problem is in the horizontal circuit and both can be repairable,a vertical fairlure is a common problem,the vertical IC goes bad and it takes a safety resistor with him to prevent any more damage,the horizontal is rare but it happens too,if you are familiar with tv service you can change the IC but you will need a service manual to identify the part,you can get a manual overnight if you downloaded it at www.servicemanuals.net,if you are not too familiar you should seek the help of a servicer for safety reasons.Let Us know how it goes or if you need more information.

Hitachi 36UX01S... | Answered on Nov 01, 2006


sounds like you have a vertical sweep problem. Where the fault lies cpuld be the vertical output IC the verticle b+ feed, could be the capacitors in the vertical circuit?? Your gonna need to troubleshoot thr vrtical circuit if your not a tech thin my advise is to take the set to a pro for sn est. Good Luck

Hitachi 36UX01S... | Answered on May 22, 2006


Open internal fuse or power supply failure

Hitachi... | Answered on Oct 05, 2019


You should only ever take the back of any electrical device if you know what you are doing. A lot of people have been electrocuted whilst working on electrical devices or they have cause damage leaving the TV useless. If you know someone that has has experience of disassembling electrical devices or repairing them, ask them to do the cleaning.

Hitachi... | Answered on Sep 27, 2019


Use code search on your URC to find something that works. If a search through all codes stored in the URC fails, try a different one.

Hitachi... | Answered on Sep 27, 2019


The panel control board on the tv is faulty. Try disconnect the panel connection form the main board and the check.
If you wish to get some details; check the site linked here. Pull up older posts.
http://electro-medical.blogspot.com/

Hitachi... | Answered on Sep 21, 2019


Replace the main board. Parts on eBay or internet.

Hitachi... | Answered on Sep 02, 2019

Not finding what you are looking for?
Hitachi 36UX01S 36" TV Logo

15 questions posted

Ask a Question

Usually answered in minutes!

Top Hitachi Televison & Video Experts

Jaime Hernandez

Level 3 Expert

2337 Answers

The Knight
The Knight

Level 3 Expert

76140 Answers

Steve Allison
Steve Allison

Level 3 Expert

5569 Answers

Are you a Hitachi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Hitachi Televison & Video

  • Hitachi Televison & Video

Most Popular Question

need info wont turn

  • Televison & Video
Loading...